Home > Corbin > Firearms accessories > Corbin LED-1 Lead Extruder Die Instructions Manual

Corbin LED-1 Lead Extruder Die Instructions Manual

Add to Favourites
    Download as PDF

    View the Corbin LED-1 Lead Extruder Die Instructions Manual for free. All the Corbin manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 LED-1 Lead Extruder Die for use in Corbin Hydro-press The Corbin LED-1 Lead Extruder Die is used in the Corbin CHP-1 Hydro- press or the Corbin CSP-2H Hydraulic Mega-Mite press, to produce lead wire from soft lead. The kit consists of a billet moulding set (two billet mould tubes approxi- mately 4 inches long with a 0.785-inch bore and a mounting base, which supports a tube while it is being filled with hot lead), and the extruder itself, which consists of a die body with 0.825 inch bore, a threaded...
    Page 2 Wearing heat-resistant gloves, you can remove the tube within seconds of pouring the lead, set it aside, and slip another tube over the base. Pour the second tube full of lead, and then give the first tube a sharp down and up shake to dislodge the lead billet. Switch tubes, and continue making billets in this manner. Always wear eye protection and follow standard precautions involving the use of hot lead to avoid burns and health risks. Make the billets in a well-ventilated area. Do not eat or smoke...
    Start reading Corbin LED-1 Lead Extruder Die Instructions Manual

    Related Manuals for Corbin LED-1 Lead Extruder Die Instructions Manual

    All Corbin manuals