Home > Corbin > Firearms accessories > Corbin RBTL-4-M Die Set Instruction Manual

Corbin RBTL-4-M Die Set Instruction Manual

Add to Favourites
    Download as PDF

    View the Corbin RBTL-4-M Die Set Instruction Manual for free. All the Corbin manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 How to Swage Bullets Using TheRBTO-4-M, -S, or -H Die Set Type -H dies fit into the ram of the Corbin Mega-Mite press (CSP-2), Corbin Hydro, Jr., (CSP-2H) press, and the Corbin Hydro-Press (CHP-1). The type - M dies fit either the horizontal Silver Press (CSP-3) or the vertical Series II Press (CSP-1). The type -S dies fit only the Series II Press (CSP-1). The last letter, -M, -S, or -H, describes the outside diameter, threads, punch lengths, and which presses the die set will fit. If a tool fits both...
    Page 2 Never try to swage a component that will not go into the die by hand. The swaging operation depends on each component being slightly smaller than the die bore, and increases the bullet diameter a little with every step. The core seating die and point forming die are matched to each other for a given jacket and core material to within 0.0005 to .0010 inches with the core seater being smaller. The first die is the CORE SWAGE (CSW-1). It is used to form a piece of lead to precise diameter, length and...
    Start reading Corbin RBTL-4-M Die Set Instruction Manual

    Related Manuals for Corbin RBTL-4-M Die Set Instruction Manual

    All Corbin manuals