D-Link Di624 A Manual

51
 Input your IP address and
subnet mask. (The IP
Addresses on your network
must be within the same
range. For example, if one
computer has an IP Address
of 192.168.0.2, the other
computers should have IP
Addresses that are
sequential, like 192.168.0.3
and 192.168.0.4. The subnet
mask must be the same for
all the computers on the
network.)
Networking Basics
Assigning a Static IP Address
in 
Windows XP/2000
 Input your DNS server
addresses. (Note:  If you
are entering a DNS
server, you must enter the
IP...

52
Networking Basics
Assigning a Static IP Address with 
Macintosh OSX

53 Networking Basics
Selecting a Dynamic IP Address with 
Macintosh OSX
Go to the Apple Menu and select
System Preferences
Click on Network
Select Built-in Ethernet in the
Show pull-down menu
Select Using DHCP in the
Configure pull-down menu
Click Apply Now
The IP Address, Subnet
mask, and the Router’s IP
Address will appear in a few
seconds

54 Networking Basics
Checking the Wireless Connection by Pinging in Windows XP and
2000
Checking the Wireless Connection by 
Pinging in Windows Me
and 98
Go to Start > Run >
type cmd.  A window
similar to this one
will appear.  Type
ping
xxx.xxx.xxx.xxx,
where xxx is the IP
Address of the
Wireless Router or
Access Point.  A
good wireless
connection will show
four replies from the
Wireless Router or
Acess Point, as
shown.
Go to Start > Run
> type command.
A window similar to
this will appear.
Type ping...

55
Troubleshooting
This Chapter provides solutions to problems that can occur during the installation and
operation of the DI-624 Wireless Broadband Router. We cover various aspects of the
network setup, including the network adapters. Please read the following if you are having
problems.
Note: If you have
changed the default IP
Address, make sure to
ping the correct IP
Address assigned to the
DI-624.
Note:  It is recommended that you use an Ethernet connection to
configure the DI-624 Wireless Broadband...

56 2. The wireless client cannot access the Internet in the
    Infrastructure mode.
Make sure the wireless client is associated and joined with the correct Access
Point. To check this connection:  Right-click on the Local Area Connection icon
in the taskbar> select View Available Wireless Networks. The Connect to
Wireless Network screen will appear.  Please make sure you have selected the
correct available network, as shown in the illustrations below.
Troubleshooting
Check that the IP Address assigned...

57 Troubleshooting
3.  Check that the drivers for the network adapters are
      installed properly.
You may be using different network adapters than those illustrated here, but this
procedure will remain the same, regardless of the type of network adapters you are
using.
Click Device
Manager

58
Troubleshooting

59 Troubleshooting
4.  What variables may cause my wireless products
     to lose reception?
D-Link products let you access your network from virtually anywhere you want.  However,
the positioning of the products within your environment will affect the wireless range.
Please refer to Installation Considerations in the Wireless Basics section of this manual
for further information about the most advantageous placement of your D-Link wireless
products.
5.  Why does my wireless connection keep dropping?
6....

60 Troubleshooting
6.  Why can’t I get a wireless connection? (continued)
Turn off your DI-624 and the client. Turn the DI-624 back on again, and then turn
on the client.