Daewoo Dwf 200m Instruction Manual

							11
GENERAL PROCEDURE FOR OPERATION
1. Add measured detergent to the washer, (Follow manufacturers directions for safe use)
2. OPTIONAL STEP
If desired, add measured liquid chlorine bleach to the bleach inlet, use only liquid chlorine
in the bleach inlet
* Follow manufacturers direction for safe use.
4. Close the washer lid (door)
5. Press the power button.
6. Select the cycle. The full automatic cycle has four settings; FUZZY, BLANKET, WOOL, LIGHT
HEAVY, ECONOMY.(See page 9) 3. OPTIONAL STEP
• Pour liquid fabric softener into the dispenser using the amount recommended on the package.
Avoid dripping or spilling any fabric softener on the load.
• Dilute fabric softener with warm water.
Fill dispenser with warm water until liquid reaches the base line in the case.
The dispenser is for liquid fabric softener use only. (See page 2)
• The liquid fabric softener will be put into the TUB automatically when final Rinse process.
7. Press the START/HOLD button.
NOTE
• Do not let bleach splash, drip, or run down into washer
basket. 
Undiluted bleach will damage any fabric it touches.
• Do not use this dispenser to add powdered chlorine or
color safe bleach to your wash load. The dispenser is for
liquid chlorine bleach use only.
DetergentInlet Hole
Base Line
Softener inlet
DWF-200/240M(101)  97.1.19 4:22 PM  ÆÁ11
 
						

							12
To winterize washerTo use washer again
ExteriorInterior
CARING FOR YOUR WASHER
Proper care of your washer can extend its life. This section explains how to care for
your washer properly and safely.
Cleaning your washer
Winter storage or moving care
Install and store your washer where it will not freeze. Because some water may stay in the
hoses, freezing can damage your washer.
If storing or moving your washer during freezing weather, winterize it.
Non-use or vacation care
Operate your washer only when you are at home.
If will be on vacation or not using your washer for an extended period of time, you should:
• Unplug the power supply cord or turn off eletrical power to the washer.
• Turn off the water supply to the washer.
This helps avoid accidental flooding (due to a water pressure surge) while you are away.
Wipe up detergent, bleach, and other spills
with a soft, damp cloth or sponge as they
occur. Occasionally wipe the outside of the
washer to keep it looking like new one. Clean interior with 250ml of chlorine bleach
mixed with 500ml of detergent.
Run washer through a complete cycle.
Repeat process if necessary.
• Turn off water faucet.
• Disconnect and drain water inlet hoses
• Run washer on a drain and spin setting 
(see page 10) for 1 minute.
• Unplug the power supply cord.• Flush water pipes and hoses.
• Reconnect water inlet hoses.
• Turn on water faucet.
• Reconnect power supply cord.
Do not put sharp or metal object in your 
washer, they can damage the finish. Check all pockets for
pins, clips, money, bolts, nuts, etc.
Do not lay these objects on your washer after emptying
pockets.
DWF-200/240M(101)  97.1.19 4:22 PM  ÆÁ12
 
						

							13
HOW TO CLEAN THE FILTER
Cleaning the Lint Filter
Cleaning the drain filter
• In case Pump-Model drain hose, this filters equipped at the back side of washer.
• This drain filter is to screen the foreign stuffs such as threads, coins, pins, buttons etc ...
• If the drain filter is not cleaned at proper time (every 10 times of use), Drain problem could
be caused.  1Pull the Fiter frame up- 
ward.2Turn the lint filter inside 
fout, wash to the lint of3Return the filter as it was, 
and insert the filter frame 
1Pull the power 
plug out before 
cleaning it.2Turn off the water
supply to the 
washer and 
sperate the inlet 
hose.3Pull the inlet filter 
out.4Remove the dirt 
from the inlet 
filter with a brush.
1Put down the remained
water in the hose. And
put a container under the2Turn the cap counter3Pull out the filter 
assembly.
4Clean the drain filter.5Put in the filter along the
guiding prominence of
the case. Please note the
left position of the filter
adjusting the groove to
the guide rib.6Turn the cap clockwise
Cleaning the water inlet filter
• Clean the filter when water leaks from, the water inlet.
with water
Filter Frame
Lint Filter
filter to collect water.
FILTERCONTAINER
clockwise.
CAP
CASE
FILTER
CAP
CAPFILTER
CASE
GUIDE
RIB
SUIT
into the slot
CAP
tightly.
CAP
DWF-200/240M(101)  97.1.19 4:22 PM  ÆÁ13
 
						

							14
Stained, heavily-soiled, or greasy items may need to be prewashed or soaked for best results.
Soaking helps remove protein-type stains like blood, milk, or grass. Prewashing helps loosen
soil before washing.
Stain removal rules
• Use warm water for soaking or prewashing stained laundry. Hot water can set stains.
• Most stains are easier to remove when they are fresh. Old or set stains may not coconut
• Before treating any stain, find out what kind of stain it is, how old the stain is, what kind of
fabric it is, and if the fabric is color fast. (Check the care label)
• Washing and drying can set some stains.
• Start with cold or warm water, hot water can set some stain.
• When bleach is recommended, use a bleach that is safe for the fabric.
• Put the stained area face down on a paper towel or white cloth. Apply the stain remover
to the back of the stain. This forces the stain off fabric instead of through it.
Stain removal guide
STAINTOREMOVE
REMOVING STAINS
Blood
Chewing gum
Cocoa, Chocolate
Coffee
Cream/Milk
Ice cream
Deodorant
Egg
Fabric/Softener
Fruit stains
Grass
Grease and oil
Iron or rust
Lipstick
Mildew
Mud
Paint-oil based
Paint-water based
Scorch marksRinse immediately in COLD water.
If stain remains, soak in cold water with an enzyme prewash.
Use ice in plastic bag to harden the gum.
Scrape off what you can and then sponge with white spirits.
Sponge with COLD water and soak in an enzyme prewash.
If stains persist, rub in a little detergent and rinse in cold water.
Blot up quickly and rinse out in COLD water.
Rub in a little detergent and wash in the maximum temperature allowed for the
fabric type.
Rinse in COLD water and wash normally.
If stain is still apparent, sponge with white spirits.
Rub affected area with white vinegar and then rinse under running COLD water.
Sponge with white spirits. 
Treat stiffened areas with enzyme prewash
Soak in a COLD enzyme prewash, rinse and wash normal.
Rub affected area with bar soap and wash normally.
Treat as soon as pressible by sponging with COLD water.
Rub a little detergent on the stain and wash normally
Sponge with white sprites.
Rub in an enzyme prewash and wash as normal
Lay the affected area face down on an absorbent cloth and work from the back.
Sponge with white spirits or dry cleaning fluid. Wash normally.
Apply lemon juice and salt and place in the sun. Wash normally.
Sponge with white methylated spirits and wash normally.
Wash in WARM water and detergent.
Moisten area with lemon juice, dry in the sun and wash normally.
If stain persists and the fabric allows, use a bleach.
Brush off any dry mud. Rinse in cold water.
If stain persists rub in a little detergent and wash normally.
Scrape off any fresh paint and sponge with a non flammable dry cleaning fluid
and wash normally.
Treat while still wet, rinse in WARM water and wash normally.
Dampen a cloth with hydrogen peroxide, lay it over the affected area and press
with a fairly hot iron.
DWF-200/240M(101)  97.1.19 4:22 PM  ÆÁ14
 
						

							15
PROBLEMCHECK POINT
•These cases are not malfunctions
• The sound wing heard during water supply is the operating sound made by the water
inlet valve.
• The sound sha heard in stopping the tub is the sound that comes from the
autobalancer of the tub.
• The sound wung heard during wash or spin is the operating sound made by the air
bubble generator.
TROUBLE SHOOTING
• The washer will not spin;
If the clothes is collected on one side
during spin and the tub becomes
unbalanced, the spin operation will be
interrupted, and then this unbalanced
condition will be corrected by following
operation: WATER SUPPLY RINSE
DRAIN However if the unbalanced
condition is unchanged despite repeating
the above operation, the lamp will
light up, and the buzzer will sound to
indicate a problem.
Most problems are easily solved if you understand the cause. 
Check the following list for problem befor calling for service.
Before calling for service, check these
• The washer will not
operate at all.
•
 Water is not supplied;
If water supply is not finished within 20
minutes, the lamp will light up, and
the buzzer will sound to indicate a problem.
• The washer will not drain;
If the drain is not finished within selected
time, lamp will light up, and the buzzer
will sound to indicate a problem.
• Is there a power failure?
• Is the power cord correctly connected to an electric outlet?
• Is the electric fuse broken?
• Did you turn on the power?
• Did you press Start/Hold button?
• Is there correct amount of water in the tub?
• Did you connect the inlet hose and open the water tap?
• Is the inlet hose or the water tap frozen?
• Is the water supply shut off?
• Does foreign matter block up the inlet hose filter?
• Is the drain hose frozen or blocked up by dirt?
• Is the drain hose kinked or deformed?
• Is the end of the drain hose immersed in water?
• Is there excessive dirt inside the pump housing?
• Is the clothe in the tub collected on one side?
• Is the washing machine installed on an uneven floor or is the
vibration serious?
• Is the lid open?
(The lamp will light up in this case.)
NOTE
Please check the point before calling for a service.
If the supply cord is damaged, it must only be replaced by a repair shop appointed by 
manufacturer, because special purpose tools are required.
DWF-200/240M(101)  97.1.19 4:22 PM  ÆÁ15
 
						

							16
MODEL NO.DWF-200MDWF-240M
Power Source
AC110~127V, 220V/60HzAC220~240V/50HzAC100~127V, 220V/60HzAC220~240V/50Hz
Power Consuption550W480W600W550W
Dimension (W5H5D, mm)630 51040 5670630 51060 5670
Unit Weight47kg / 48kg (Pump)49kg / 50kg (Pump)
Standard Water Consumption250
270
Standard Water Level•HIGH (97)     •MEDIUM (77)
•LOW (66
)      •E.LOW (42)•HIGH (103
)   • MEDIUM (87)
•LOW (70
)      • E.LOW (43)
Operating Water Pressure0.3kgf/cm2~8kgf/cm2(29.4kPa~784.5kPa)
Wash Mode
Multi Ð Washing Type (Radical + Air-Bubble + Pulsator)
SPECIFICATION
NOTE
• In case of moving Washing Machine, please follow the following
picture.
Front
Top
DWF-200/240M(101)  97.1.19 4:22 PM  ÆÁ16
 
						

							VISION CREATIVE, INC.Á±¸³²´ë¹®·Î5¡526
´ë¿ ´ º ù16Ã
´ã´ºÎÆ ¼¼Å¹± ¿¬±¸¼½ÂÁ´TEL
MODELDWF-200/240M(¿)
BUYER
1Â99.12.8-12.96Â
2Â99.12.23-12.247Â
ÏÁ¤3Â00.1.10-00.1.118Â
4Â9Â
5Â10Â
Á¦ÆÇ
ÀÎ
μ
¼â
±
MEMO
¿ ¿¬
¦
¶ôÃ
ó
³
V
VI
IS
SI
IO
ON
N´
´ã
ã´
´ç
ÁÇ
TEL:757-9340 FAX:774-1039
DWF-200/240M(101)  97.1.19 4:22 PM  ÆÁ17