Dell 2007wfp Users Guide

							Back to Contents Page  
Using Your Adjustable Monitor Stand   
 
   Attaching the Stand  
   Organizing Your Cables  
   Using the Tilt, Swivel and Vertical Extension  
   Removing the Stand   
   
Attaching the Stand  
 
1. Place the s tand  on a flat surface.  
2. Fit the groove on the back of the monitor onto the  2 tabs   of upper stand.   
3. Lower the monitor so that the monitor mounting area snaps on   or   locks to stand.   
Organizing Your Cables  
 
  
After attaching all necessary cables to your monitor and computer, (See  Connecting Your Monitor  for cable attachment,) use the Cable 
management hole to neatly organize all cables as shown above.  
Using the Tilt, Swivel and Vertical Extension  
 
Tilt/Swivel  
With the built - in pedestal, you can tilt and/or swivel the monitor for the most comfortable viewing angle.    
						

							 
 
Vertical Extension  
Stand extends vertically up to  130mm via the Lock down / release button.  
 
                   
Removing the Stand  
  After placing the monitor panel on a soft cloth or cushion, press and hold the Monitor Lock / Release Button, and then remove the stand.   NOTE:   Stand is detached and extended when the monitor is shipped from the factory.  
NOTE:  If locked in the down position, press the  Lock down / release  button on the bottom rear of stand. Lift the front panel up and extend the stand to 
the desired height.   
NOTICE:  Before relocating   or   moving the monitor to a different location, make sure that the stand is LOCKED DOWN. To lock it down, lower the height 
of the panel until it clicks and is locked into place.    
						

							 
 
Back to Contents Page  
    NOTE:   To prevent scratches on the LCD screen while removing the stand,   ensure that the monitor is placed on a clean surface.