Home > Dell > Notebook > dell inspiron 8000 removing and replacing parts User Manual

dell inspiron 8000 removing and replacing parts User Manual

Add to Favourites
    Download as PDF

    View the dell inspiron 8000 removing and replacing parts User Manual for free. All the Dell manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 Dell™ Inspiron™ 8000: Removing and Replacing Parts73 Dell™ Inspiron™ 8000: Removing and Replacing Parts Preparing to Work Inside the Computer NOTICE: Only a certified service technician should perform repairs on your computer. Damage or inoperability due to servicing not authorized by Dell is not covered by your warranty. NOTICE: Unless otherwise noted, each procedure in this manual assumes that a part can be replaced by performing the removal procedure in reverse order. NOTICE: To avoid...
    Page 2 74Dell™ Inspiron™ 8000: Removing and Replacing Parts www.dell.com | support.dell.com 11Remove any installed device in the media bay. 12To dissipate any static electricity while you work, periodically touch an unpainted metal surface on the surface of the computer, such as the I/O panel on the back of the computer chassis. 13Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by it edges or by its metal mounting bracket. Hold a component such as a...
    Page 3 Dell™ Inspiron™ 8000: Removing and Replacing Parts75 NOTICE: When reinstalling a screw, you must use a screw of the correct diameter and length. Make sure that the screw is properly aligned with its corresponding hole, and avoid over tightening. Screw Placemat Hard Drive Door Security: M3 x 5 mm (1 each)Keyboard to Bottom Case Assembly: M2.5 x 20 mm (4 each; plus one in memory module cover and one in Mini PCI card cover)Display to Base: M2.5 x 6 mm (3 each; 2 at back of computer; 1 at flex-cable...
    Page 4 76Dell™ Inspiron™ 8000: Removing and Replacing Parts www.dell.com | support.dell.com Pa l m R e s t t o Bottom Case Assembly: M2.5 x 20 mm (9 each) Pa l m R e s t B r a c k e t: M2.5 x 4 mm (2 each)System Board: M2.5 x 4 mm captive washer (3 each) M2.5 x 20 mm (1 each)LED Board: M2 x 4 mm (2 each) Fa n A ss e m b l y: M2 x 4 mm (3 each)RJ-11/RJ-45 Board Assembly: M2.5 x 4 mm (1 each)
    Start reading dell inspiron 8000 removing and replacing parts User Manual

    Related Manuals for dell inspiron 8000 removing and replacing parts User Manual

    All Dell manuals