Dyson Dc07 Owners Manual

							Owner’s ManualPlease read this guide carefully before using your DCO7
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 1 
						

							WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:
1 Do not leave appliance when plugged in. Unplug from electrical
outlet when not in use and before servicing.
2 Do not use outdoors or on wet surfaces or to vacuum water or other
liquids – electric shock and personal injury could occur.
3 Do not allow to be used as a toy. Close attention is necessary when
used by or near children.
4 Do not allow use by anyone unable to operate the vacuum properly.
5 Use only as described in this manual. Use only with Dyson-
recommended attachments, accessories, and replacement parts.
6 Check to ensure your electricity supply corresponds to that shown on
the rating plate, which can be found on the base of the machine
between the wheels. The machine must only be used as rated.
7 If the machine is not functioning properly, has been dropped,
damaged, left outdoors, or immersed in liquid, contact the Dyson
Helpline at 1-
866-
693-
9766.
8 Do not use with a damaged cord or plug; do not pull or carry by the
cord; do not use the cord as a handle; do not close a door on the
cord or pull the cord around sharp edges or corners. Do not run the
machine over the cord. Keep the cord away from heated surfaces
and open flames.
9 Do not unplug by pulling on the cord. To unplug, grasp the plug,
not the cord.
10 Do not handle the plug or machine with wet hands.
11 Do not use the machine without the clear bin
TMand the filters
in place.
12 Do not put any objects into openings in the machine. Do not use
with any opening blocked; keep free of dust, lint, hair, and anything
that may reduce air flow.
13 Keep hair, loose clothing, fingers, and all parts of body away from
openings in the machine and moving parts such as the brushbar.
14 Do not use the machine to pick up sharp hard objects, small toys,
pins, paper clips, etc. They may damage the machine.
15 The use of an extension cord is not recommended.
16 Store the machine indoors. Put the machine away after use with the
cord wrapped safely to prevent tripping accidents.
17 Turn off all controls before unplugging.
18 Take extra care when cleaning on stairs; always work with the
machine at the bottom of the stairs. Keep vacuum on the floor. 
Do not put on chairs, tables, etc.
19 Do not pick up anything that is burning or smoking, such as
cigarettes, matches, or hot ashes.
20 Do not use to pick up flammable or combustible liquids, such as
gasoline, or use in areas where they may be present.
21 When vacuuming, certain carpets may generate small static charges
in the clear bin
TMor wand. These are not associated with the
electricity supply. To minimize any effect from this, do not put your
hand or insert any object into the clear bin
TMunless you have first
emptied it and rinsed it out with cold water.
22 Do not carry out any maintenance or repair work other than that
shown in this manual or advised by the Dyson Helpline.
23 Consult your flooring manufacturer’s instructions before vacuuming
and caring for your flooring, rugs, and carpets. Some carpets will
fuzz if a rotating brushbar is used when vacuuming. If this happens
we recommend vacuuming in bare floors mode and consulting with
your flooring manufacturer.
Important safety instructions
IMPORTANT
SAFETY
INSTRUCTIONS
When using an electrical
appliance, basic precautions
should always be followed,
including the following:
READ ALL INSTRUCTIONS
BEFORE USING THIS 
VACUUM CLEANER
SAVE THESE
INSTRUCTIONS
THIS APPLIANCE IS INTENDED
FOR HOUSEHOLD USE ONLY
2
Polarization instructions
To reduce the risk of electric
shock, this appliance has a
polarized plug (one blade is
wider than the other). This plug
will fit in a polarized outlet only
one way. If the plug does not fit
fully in the outlet, reverse the
plug. If it still does not fit,
contact a qualified electrician to
install the proper outlet. Do not
change the plug in any way.
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 2 
						

							Important safety instructionsPa g e2
Assembling 4
Using your DCO7 6
Washing your filter 8
Using the tools  10
Emptying the Clear bin
TM12
Clearing blockages  14
Using and maintaining optional accessories 16
Troubleshooting tips 18
Limited warranty and Customer care 19
Contents
Owner ’s Manual
Please read this guide carefully
before use.
Dyson Helplinecontact us at1-
866-
693-
97663
Wand release button
Cyclone release button 
Airway inspection valve
Soleplate Shroud Wand cap
Upper cord hook
Bin emptying button
On/off switch
Washable lifetime
filter housing
Brushbar housing
Cyclone assembly
Wand
Brushbar on/off 
Carry handle
Clear binTM
Hose
Lower cord hook
U-bend release button
U-bend
Wand
Upper cord hook
www.dyson.com
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 3 
						

							Assembling your DCO7
This machine was inspected and
packaged carefully before being
shipped from the factory. 
If you need assistance during
assembly or operation, please
call the Dyson Helpline at 
1-
866-
693-
976 6 .
1Slide the hose into the guides
at the back of the machine,
and click into place.2While pressing the hose
release button, slide the
wand down insidethe hose.
Box contents
Stair tool
Crevice tool Brush tool Wand
Hose
2
Dyson Helplinecontact us at1-
866-
693-
97667 days a week4
Assembling
Additional accessories may be
included with some models.
1
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 4 
						

							Assembling
3Slide the wand into the top 
of the machine until it clicks
securely into place. You may
need to press firmly and
should hear a ‘click’ sound.
tipTo quickly release cord,
rotate upper cord hook
downward. Twist back up
before rewinding cord. 4Push the brush and stair tools
securely into the storage holes
on either side of machine.
Fit the crevice tool into the tool
clip on the back of the wand.
34
5Store the cord safely by
winding it counter-clockwise
around the cord winders and
securing with the cord clip.
5www.dyson.com
5
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 5 
						

							Using your DCO7
Switching on/off
1Make sure you have read
and understood all safety
instructions before using the
machine for the first time. 
The wand cap should be
closed when not using the
tools.
2Plug into electrical outlet and
press the on/off switch.3To start vacuuming, push the
front of the cleaner head down
with your foot and tilt the
handle backward.
Using your DCO7
WARNING
• This machine is intended for
domestic use only. Fine dust
such as plaster dust or flour
should only be vacuumed in
small amounts.
• Consult your flooring
manufacturer’s instructions
before vacuuming your
flooring, rugs and carpets.
Some carpets will fuzz if a
rotating brushbar is used when
vacuuming. If this happens we
recommend vacuuming in
bare floors mode and
consulting with your flooring
manufacturer.
CAUTION 
• Keep hair, loose clothing,
fingers, and all parts of the
body away from openings
and moving parts.
• This machine is fitted with
a belt protection system.
If any item becomes caught
in the brushbar (e.g., rug
fringe), you will hear a loud
“ratcheting” warning noise.
To rectify, turn the machine
off, disconnect from the
electrical outlet, and clear
any obstruction (see page 14),
checking that the brush control
is set to the correct position
for the floor surface before
re-starting the machine.
1
23
Dyson Helplinecontact us at1-
866-
693-
97667 days a week6
tipThe ratcheting noise may also
occur if your carpet or area
rug is not adequately attached
to the floor. If this happens
you should vacuum in bare
floors mode.
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 6 
						

							1
2
Using your DCO7
Transporting your Dyson
To move the machine from room
to room, ensure it is upright,
with the cord stored on the cord
winders and the wand securely
in place. Tilt back on the rear
wheels and push forward.Carrying your DCO7
Your DCO7 should be lifted by
using the carry handle. 
CAUTION
• Do not shake the machine
when carrying.
• For your safety do notpress
the cyclone release catch
when carrying your machine.Brush control system
Ensure the machine is in an
upright position before adjusting
the setting.
1Bare floors
Use this setting to stop brushbar
from turning when vacuuming
bare floors and delicate floors,
rugs, and carpets.
2Carpets
Use this setting so brushbar
turns when vacuuming non-
delicate surfaces.
tipThe brushbar will not turn until
you tilt the handle backward
to begin vacuuming.
7www.dyson.com
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 7 
						

							Only the blue foam pad and the
yellow case should be rinsed –
do not wash the filter housing.
3Submerge the foam pad and
case in cold water and rinse
thoroughly.
CAUTION 
• Rinse in cold water only.
• Do not use detergent.
• Do not put in a washing
machine or dishwasher.
Dyson Helplinecontact us at1-
866-
693-
97667 days a week8
Washing your filter
A Lifetime washable filter
IMPORTANT
Check your washable filter
regularly and wash at least
every 6 months according to
instructions to maintain
performance.
BLifetime HEPA filter
This is a permanent lifetime
filter. Do not remove or
attempt to rinse this filter.
Washing your filter
CAUTION 
• Turn power off and unplug
before washing filter. Failure
to do so could result in
electric shock or personal
injury.
Removing washable filter
1Press the filter release catch
to remove the filter housing
from the machine.
2Remove the filter from the
housing.
1
2
BA
3
tipThe filter may require more
frequent washing based on
individual vacuuming habits,
check regularly.
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 8 
						

							Washing your filter
6Leave in a warm place to dry
for 12 hours. Make sure the
filter is completely dry before
replacing in the machine.
CAUTION 
• Do not dry in an oven or
microwave.
• Do not dry in a clothes dryer.
• Do not dry near an open flame.7When the blue foam pad and
yellow case are completely
dry, place the foam pad in the
case and replace in the filter
housing.Click back into
machine, pressing points 1
and 2firmly to secure.
CAUTION 
• Do not use the machine
without the filter in place.
2
1
9
4
5
67
12 hrs
www.dyson.com
4Rinse the blue foam pad and
squeeze gently, repeating until
the water runs clear.
5Rinse the yellow case and tap
firmly, repeating until the water
runs clear.
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 9 
						

							Using the tools
Using the tools
Choosing the right tool
The tools allow you to clean
surfaces above the floor and 
to reach hard to clean areas.
Ensure the machine is in an
upright position before 
using tools. 
ABrush tool– with soft bristles
to dislodge dust and cobwebs.
Can be used to clean vents
and some furniture.
BStair tool– with velour strips
to pick up hairs and an
agitating edge to lift the
carpet. Can be used to clean
stairs and upholstery.
CCrevice tool– reaches deep
into nooks and crannies. 
Can be used to clean 
along baseboards and in
tight spaces. 
CAUTION 
Do not use your vacuum cleaner
outdoors or on wet surfaces.
Vacuum may be used inside a
garage only when used with the
Model 08909 Dyson Car
Cleaning Kit accessories. If used
in a garage, care should be
taken to wipe the soleplate and
wheels with a dry cloth after
vacuuming to clean off any
sand, dirt, or pebbles that could
damage delicate floors.How to clean your tools
The brush tool, stair tool, and
crevice tool may be washed in
warm water with a detergent.
Rinse and air dry thoroughly
before using. You may wipe the
outside of the floor tool or turbo
tool/mini turbine head with a
damp cloth, but do not
submerge in water. Do not
attempt to clean any tools when
they are attached to the machine.
A
B
C
1
2
Dyson Helplinecontact us at1-
866-
693-
97667 days a week10
Attaching tools
Use tools for easier cleaning in hard
to reach areas.
1Press the wand release to detach
the wand from the machine.
2Pull wand up to extend hose, slide
the hose away from the wand
until the metal tube and hose cuff
click into place.
All Dyson tools can be used
in the following ways:
Wand mode
Slide back the wand cap and fit one
of the tools directly on the 
wand handle.
18858_OPS_MANUAL_UPDATE_US.qxd  7/1/08  16:45  Page 10