Electrolux Enb 34000 W User Manual

							AB
mm
mm
min100
20
Electrical Connection
Caution! Any electrical work required to
install this appliance should be carried
out by a qualified electrician or
competent person.
Warning! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
12
3
4
5
Important! The wires in the mains lead are
coloured in accordance with the following
code:
1Green and Yellow: Earth
3Brown: Live
5Blue: Neutral
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termi-
nals in your plug, proceed as follows:
1. Connect the wire coloured green and yel-
low to the terminal marked either with the
letter “E“ or by the earth symbol 
 or
coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
“N“ or coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the “L“ or col-
oured red.
4. Check that no cut, or stray strands of wire
is present and the cord clamp 
4 is se-
cure over the outer sheath.
5. Make sure the electricity supply voltage is
the same as that indicated on the appli-
ance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
fitted 
2 . In the event of having to change
the fuse in the plug supplied, a 13 amp ASTA
approved (BS 1362) fuse must be used.
Warning! A cut off plug inserted into a
13 amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
Rear spacers
In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
Slacken the screws and insert the spacer
under the screw head, then tighten again the
screws.
electrolux  11
 
						

							12
3
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
Removing the shelf holders
Your appliance is equipped with shelf retain-
ers that make it possible to secure the
shelves during transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direction of
the arrow (A).
2. Raise the shelf from the rear and push it
forward until it is freed (B).
3. Remove the retainers (C).
Door reversibility
Warning! Before carrying out any
operations, remove the plug from the
power socket.
Important! To carry out the following
operations, we suggest that this be made
with another person that will keep a firm hold
on the doors of the appliance during the
operations.
To change the opening direction of the door,
do these steps:
1. Open the door with the appliance in the
upright position. Unscrew the screws (t1)
and remove the upper door plastic trim
(t2). Close the door.
t1
d7t1
t1
t2
t3
12  electrolux
 
						

							2. Remove the little plastic cover from the
door plastic trim and refit on the opposite
side (t3).
3. Remove the panel (t4). If it is necessary
use a screwdriver very carefully. Un-
screw the screw on the other side. Re-
move the upper door mount (t5). Place
them in an empty plastic bag.
t5 t4
4. Remove the upper door.
5. Unscrew the screw and remove the door
stopper (d1). Attach it reversed on the
other side.
d1
6. Unscrew the middle hinge (m2). Remove
the plastic spacer (m1).
7. Remove the lower door.
m3m4 m5 m1
m2
8. Remove using a tool the cover (b1). Un-
screw the lower hinge pivot (b2) and the
spacer (b3) and place them on the op-
posite side.
9. Re-insert the cover (b1) on the opposite
side.
b1
b2
b3
10. Remove the stoppers (d1) and move to
the other side of the doors.
11. Remove the left-hand cover pin of the
middle hinge (m3,m4) and move to the
other side.
12. Fit the pin of the middle hinge (m5) into
the left-hand hole of the lower door.
13. Re-insert the lower door on the pivot pin
(b2).
14. Re-screw the middle hinge (m1) on the
opposite side . Do not forget the plastic
spacer (m2) inserted under the middle
hinge.
electrolux  13
 
						

							15. Re-insert the upper door on the middle
hinge (m5).
Make sure that the edges of the doors
run parallel to the side edge of the appli-
ance.
16. Position and fix the upper hinge (you can
find them in the instruction for use bag)
on the opposite side (t6).
t6
t7
17. Insert the panel (t7) (that can be found in
the instruction for use bag).
18. Open the upper door, attach the top
cover (t2) using screws (t1). Insert the
magnet (d7). Close the door.
19. Reposition, level the appliance, wait for
at least four hours and then connect it to
the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fit-
ting of the gasket or accelerate this process
by heating up the part involved with a normal
hair drier.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After
Sales Service specialist will carry out the re-
versibility of the doors at your cost.
Environmental concerns
The symbol    on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will help
prevent potential negative consequences for
the environment and human health, which
could otherwise be caused by inappropriate
waste handling of this product. For more
detailed information about recycling of this
product, please contact your local council,
your household waste disposal service or the
shop where you purchased the product.
14  electrolux
 
						

							electrolux  15
 
						

							210620059-00-022009
925033192
925033437
www.electrolux.com
To buy accessories, consumables and spare parts at our online shop please visit:
www.electrolux.co.uk
www.electrolux.ie