Electrolux Esf 43010 User Manual

							technical data electrolux  31
The consumption values are intended
as a guide and depends on the
pressure and the temperature of the
water and also by the variations of the
power supply and the amount of
dishes.
Consumption values
Programme
duration 
(in minutes)Programme Energy
consumption 
(in kWh)Water
consumption 
(in litres)
75 - 85Intensive 70°1,5 - 1,718 - 20
105 - 115Normal 65°1,3 - 1,520 - 25
25 - 35Quick 60°0,7 - 0,88
130
Eco 50°
(Test programme for
test institutes)0,814
12Rinse and Hold< 0,14
117997 92/0en  5-09-2006  15:18  Pagina 31
 
						

							32electroluxhints for test institutes
Hints for test institutes
Testing in accordance with EN 60704
must be carried out with appliance
fully loaded and using the test
programme (see Consumption
values).Test in accordance with EN 50242
must be carried out when the salt
container and rinse aid dispenser
have been filled with salt and rinse aid
respectively and using the test
programme (see Consumption
values).
Full load: 9 standard place settings
Amount of detergent required:5 g + 20 g (Type B)
Rinse aid setting:position 4 (Type III)
Arrangement upper
basket without smaller
bowl and salad-bowlArrangement upper
basket with smaller bowl 
and salad-bowl
Cup racks: position AArrangement cutlery
basketArrangement lower
basket
117997 92/0en  5-09-2006  15:18  Pagina 32
 
						

							installation electrolux  33
Any electrical and/or plumbing
work required to install this
appliance should be carried out by
a qualified electrician and/or
plumber or competent person.
Remove all packaging before
positioning the machine.
If possible, position the machine next
to a water tap and a drain.
Fitting under a counter 
(kitchen worktop or sink)
By removing the machine’s worktop,
you can install it under a close fitting
sink unit or a pre-existing top,
providing the dimensions of the
recess correspond to those shown in
the picture.
Installation
Proceed as follows:
Remove the machine’s worktop by
unscrewing the two rear retaining
screws, pull the worktop from the
back of the machine and slide out
the front slots, lifting the worktop.
Insert the machine after adjusting the
levelling with the adjustable feet.
When inserting the machine, ensure
that the water inlet and drain hoses
are not kinked or squashed.
During all operations that involve
accessibility to internal components
the dishwasher has to be unplugged.
Be sure that once the appliance has
been installed, it is easily accessible
for the service engineer in the event
that a repair is required.
If the dishwasher is later used as a
free-standing appliance, the original
worktop must be re-mounted.
The plinth on free-standing appliances
is not adjustable.
Levelling
Good levelling is essential for correct
closure and sealing of the door.
When the appliance is correctly
levelled, the door will not catch on
either side of the cabinet.
If the door does not close correctly,
loosen or tighten the adjustable feet
until the machine is perfectly level.
117997 92/0en  5-09-2006  15:18  Pagina 33
 
						

							34electroluxinstallation
Water supply connections 
This dishwasher may be fed with
either hot (max. 60°) or cold water.
Nevertheless we advise you a cold
water supply.
A hot water supply is not always
efficient with very soiled crockery as it
shortens the washing programmes a
lot.
For making the connection itself, the
coupling nut fitted to the machine’s
supply hose is designed to screw onto
a 3/4 gas thread spout or to a
purpose made quick-coupling tap
such as the Press-block.
The water pressure must be within
the limits given in the Technical
specifications. Your local Water
Authority will advise you on the
average mains pressure in your area. 
The water inlet hose must not be
kinked, crushed, or entangled when it
is being connected. 
The dishwasher features fill and drain
hoses which can be turned either to
the left or the right to suit the
installation by means of the locknut.
The locknut must be correctly fitted
to avoid water leaks.
(Attention! NOT all models of
dishwashers have fill and drain hoses
provided with locknut. In this case,
this kind of facility is not possible).
If the machine is connected to new
pipes or pipes which have not been
used for a long time, you should run
the water for a few minutes before
connecting the inlet hose. 
DO NOT use connection hoses
which have previously been used
for an old appliance.
This appliance has been fitted with
safety features which will prevent the
water used in the appliance from
returning back into the drinking water
system. This appliance complies with
the applicable plumbing regulations.
117997 92/0en  5-09-2006  15:18  Pagina 34
 
						

							installationelectrolux  35
Water inlet hose with safety valve
After connecting the double-walled
water inlet hose, the safety valve is
next to the tap. Therefore the water
inlet hose is only under pressure
while the water is running. If the water
inlet hose starts to leak during this
operation, the safety valve cuts off the
running water.
Please take care when installing the
water inlet hose:
The electrical cable for the safety
valve is in the double-walled water
inlet hose. Do not immerse the
water inlet hose or the safety valve
in water.
If water inlet hose or the safety
valve is damaged, remove the
mains plug immediately.
A water inlet hose with safety valve
must only be replaced by a
specialist or by the Service Force
Centre.
Place the water inlet hose in such
a way that it is never higher than
the bottom edge of the safety
valve.
Warning!
Dangerous voltage
117997 92/0en  5-09-2006  15:18  Pagina 35
 
						

							36electroluxinstallation
Water outlet hose connection
The end of the drain hose can be
connected in the following ways: 
1. To the sink outlet spigot, securing
it to the underside of the work
surface. This will prevent waste
water from the sink running into
the machine. 
2. To a stand pipe provided with vent-
hole, minimum internal diameter 4
cm. 
The waste connection must be at a
height of between 30 cm (minimum)
and 100 cm (maximum) from the
bottom of the dishwasher. 
The drain hose can face either to the
right or left of the dishwasher 
Ensure the hose is not bent or
squashed as this could prevent or
slow down the discharge of water. 
The sink plug must not be in place
when the machine is draining as this
could cause the water to syphon back
into the machine. 
If you use a drain hose extension it
must be no longer than 2 metres and
its internal diameter must be no
smaller than the diameter of the hose
provided. 
Likewise the internal diameter of the
couplings used for connections to the
waste outlet must be no smaller than
the diameter of the hose provided. 
Our appliances are supplied with a
security device to protect against the
return of dirty water back into the
machine. 
If the spigot of your sink has a no
return valve incorporated this can
prevent the correct draining of your
dishwasher. We therefore advise you
to remove it.
117997 92/0en  5-09-2006  15:18  Pagina 36
 
						

							installation electrolux  37
Electrical connection
Safety standards require the
appliance to be earthed. The
manufacturer accepts no liability
for failure to observe the above
safety precautions.
Prior to using the appliance for the
first time, ensure that the rated
voltage and type of supply on the
rating plate match that of the
supply where the appliance is to be
installed. The fuse rating is also to
be found on the rating plate.
Always plug the mains plug into a
correctly installed shockproof
socket.
Multi-way plugs, connectors and
extension cables must not be used.
This could constitute a fire hazard
through overheating.
If necessary, have the domestic
wiring system socket replaced. In
case that the electrical cable has to
be replaced, contact your local
Service Force centre.
The plug must be accessible after
the appliance has been installed.
Never unplug the appliance by
pulling on the cable. Always pull
the plug.
117997 92/0en  5-09-2006  15:18  Pagina 37
 
						

							38electroluxenvironment concerns
Packaging material
The packaging materials are
environmentally friendly and can be
recycled. The plastic components are
identified by markings, e.g. >PEPS
						

							guarantee/customer serviceelectrolux  39
Guarantee/Customer Service
Belgium
DECLARATION OF GUARANTEE
TERMS.
Our appliances are produced with the
greatest of care. However, a defect
may still occur.
Our consumer services department
will repair this upon request, either
during or after the guarantee period.
The service life of the appliance will
not, however, be reduced as a result.
This declaration of guarantee terms is
based on European Union Directive
99/44/EC and the provisions of the
Civil Code. The statutory rights that
the consumer has under this
legislation are not affected by this
declaration of guarantee terms.
This declaration does not affect the
vendors statutory warranty to the end
user. The appliance is guaranteed
within the context of and in adherence
with the following terms:
1.In accordance with provisions laid
down in paragraphs 2 to 15, we
will remedy free of charge any
defect that occurs within 24
months from the date the
appliance is delivered to the first
end user. These guarantee terms
do not apply in the event of use
for professional or equivalent
purposes.
2.Performing the guarantee means
that the appliance is returned to
the condition it was in before the
defect occurred. Defective parts
are replaced or repaired. Parts
replaced free of charge become
our property.3.So as to avoid more severe
damage, the defect must be
brought to our attention
immediately.
4.Applying the guarantee is subject
to the consumer providing proof of
purchase showing the purchase
and/or delivery date.
5.The guarantee will not apply if
damage caused to delicate parts,
such as glass (vitreous ceramic),
synthetic materials and rubber, is
the result of inappropriate use.
6.The guarantee cannot be called
on for minor faults that do not
affect the value or the overall
reliability of the appliance.
7.The statutory warranty does not
apply when defects are caused
by:
– a chemical or electrochemical 
reaction caused by water,
– abnormal environmental 
conditions in general,
– unsuitable operating conditions,
– contact with harsh substances.
8.The guarantee does not apply to
defects due to transport which
have occurred outside of our
responsibility. Nor will the
guarantee cover those caused by
inadequate installation or
assembly, lack of maintenance or
failure to respect the assembly
instructions or directions for use.
117997 92/0en  5-09-2006  15:18  Pagina 39
 
						

							40electroluxguarantee/customer service
9.Defects that result from repairs or
measures carried out by people
who are not qualified or expert or
defects that result from the
addition of non-original
accessories or spare parts are not
covered by the guarantee.
10.Appliances that are easy to
transport may be delivered or sent
to the consumer services
department. Home repairs are
only anticipated for bulky
appliances or built-in appliances.
11 .If the appliances are built-in, built-
under, fixed or suspended in such
a way that removing and replacing
them in the place where they are
fitted takes more than half an
hour, the costs that result
therefrom will be charged for.
Connected damage caused by
these removal and replacement
operations will be the
responsibility of the user.
12.If, during the guarantee period,
repairing the same defect
repeatedly is not conclusive, or if
the repair costs are considered
disproportionate, in agreement
with the consumer, the defective
appliance may be replaced with
another appliance of the same
value. In this event, we reserve
the right to ask for a financial
contribution calculated according
to the length of time it has been
used.
13.A repair under guarantee does not
mean that the normal guarantee
period will be extended nor that a
new guarantee period begins.
14.We give a twelve month
guarantee for repairs, limited to
the same defect.15.Except in the event where liability
is legally imposed, this declaration
of guarantee terms excludes any
compensation for damage outside
the appliance for which the
consumer wishes to assert his
rights. In the event of legally
admitted liability, compensation
will not exceed the purchase price
paid for the appliance. 
These guarantee terms are only valid
for appliances purchased and used in
Belgium. For exported appliances, the
user must first make sure that they
satisfy the technical conditions (e.g.:
voltage, frequency, installation
instructions, type of gas, etc.) for the
country concerned and that they can
withstand the local climatic and
environmental conditions. For
appliances purchased abroad, the
user must first ensure that they meet
the qualifications required in Belgium.
Non-essential or requested
adjustments are not covered by the
guarantee and are not possible in all
cases. 
Our consumer services department is
always at your disposal, even after
the guarantee period has expired.
Address for our consumer services
department:
Belgium
Electrolux Home Products Belgium
ELECTROLUX SERVICE
Bergensesteenweg 719
1502 Lembeek
Consumer services 
Tel.: 02/363.04.44 
Fax.: 02/363.04.00
02/363.04.60
E-mail:
[email protected]
117997 92/0en  5-09-2006  15:18  Pagina 40