Electrolux Ew 1289 W Manual

							EW 1289 W
INSTRUCTION BOOKLET
KULLANIM KILAVUZU
WASHER-DRYER
KURUTMALI ÇAMAÇIR MAKINESI
TR
GB
132 991 030
132999190•EW1288W•cop  08/07/03  11:21  Pagina 1 
						

							2
Dear customer,
Please read these operating instructions carefully
and pay particular attention to the safety notes
indicated in the first pages. We recommend that you
keep this instruction booklet for future reference and
pass it on to any future owners.
Transport damages
When unpacking the appliance, check that it is not
damaged. If in doubt, do not use it and contact the
Service Centre.
The symbols you will see on some paragraphs of this booklet have the following meaning:
The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly
important for your safety or correct functioning of the appliance.
The information marked with this symbol provides additional instructions and practical tips on the use of
the appliance.
Tips and information about economical and ecological use of the machine are marked with this symbol.
Our contribution to the protection of the
environment: we use environmentally 
friendly paper.
132991030 EW1289W.qxd  08/07/2003  13:33  Pagina  2    (Nero/Process Black pellicola) 
						

							ENGLISH
Contents
3Operating sequence 19-21
Washing programmes 22
Drying programmes 23
International wash code symbols 24
Maintenance 25
Bodywork 25
Detergent dispenser drawer 25
Drain pump 25
Water inlet filter 26
Emergency emptying out 26
Frost precautions 26
Something not working? 27-28 Warnings 4-5
Disposal 5
Tips for environmental protection 5
Technical specifications 6
Installation 7
Unpacking 7
Positioning 7
Water inlet 7
Water drainage 8
Electrical connection 8
Your new washer-dryer 9
Description of the appliance 9
Door locked pilot light 9
Detergent dispenser drawer 9
Use 10
Control panel 10
Controls 10-14
Washing hints 15-16
Sorting the laundry 15
Temperatures 15
Before loading the laundry 15
Maximum loads 15
Laundry weights 15
Removing stains 15
Detergents and additives 16
Drying hints 17
Load 17
Garments not suitable for drying 17
Drying symbols on garment labels 17
Duration of the drying cycle 17
Fibre residue 17
Additional drying 17
132991030 EW1289W.qxd  08/07/2003  13:33  Pagina  3    (Nero/Process Black pellicola) 
						

							4
Installation
• All internal packing must be removed before using
the appliance. Serious damage may be caused to
the machine or adjacent furniture if the protective
transit devices are not removed or are not
completely removed. Refer to the relevant
paragraph in the instruction book.
• Any electrical work required to install this appliance
must be carried out by a qualified electrician.
• Any plumbing work required to install this
appliance must be carried out by a qualified
plumber.
• After having installed the machine, check that it is
not standing on its electrical supply cable.
• If the appliance is placed on a carpeted floor,
ensure that air can circulate freely between the
feet and the floor.
Use
• This appliance is designed for domestic use. It
must not be used for purposes other than those for
which it was designed.
• Only wash and dry fabrics which are designed to
be machine washed and dried. Follow the
instructions on each garment label.
• Do not overload the appliance. Follow the
instructions in the instruction book.
• Make sure that all pockets are empty. Objects such
as coins, safety pins, pins and screws can cause
extensive damage.
• Do not machine wash garments saturated with
petroleum, methylated spirits, trichlorethylene, etc.
If such fluids have been used to remove stains
prior to washing, wait until they have completely
evaporated from the fabric before placing
garments in the appliance.
• Place small items such as socks, belts, etc. in a
cloth bag or pillowcase to prevent them getting
trapped between the drum and the tub.
• If you use a liquid detergent with a dispenser which
has to be placed directly in the drum, remember to
remove this dispenser before drying.
Warnings
• Use only the recommended quantities of fabric
softener. An excessive amount could damage the
laundry.
• Leave the porthole door slightly ajar when the
appliance is not in use. This preserves the door
seal and prevents the formation of musty smells.
• Always check that water has emptied out before
opening the door. If not, drain the water following
the instructions in the instruction book.
• Always unplug the appliance and shut the water
tap after use.
General safety
• Repairs to the machine must be carried out only by
qualified personnel. Repairs carried out by
inexperienced persons could cause serious
danger. Contact your local Service Centre.
• Never pull the power supply cable to remove the
plug from the socket; always take hold of the plug
itself.
• During high temperature wash programmes and
during the drying cycle the door glass may get hot.
Do not touch it!
Child safety
• Children are often not aware of how dangerous
electrical appliances can be. When the machine is
working, children should be carefully supervised
and not be allowed to play with the appliance.
• The packaging components (e.g. plastic film,
polystyrene) can be dangerous to children - danger
of suffocation! Keep them out of children’s reach.
• Keep all detergents in a safe place out of children’s
reach.
• When the appliance is to be scrapped, cut off the
electrical supply cable and destroy the plug with
the remaining cable. Disable the door catch in
order to prevent children from becoming trapped
inside while playing.  The following warnings are provided in the interests of overall safety. You must read them carefully before
installing or using the appliance.
132991030 EW1289W.qxd  08/07/2003  13:33  Pagina  4    (Nero/Process Black pellicola) 
						

							ENGLISH
5
Disposal
Tips for environmental protection
Packaging materials
The materials marked with the symbol  are
recyclable.
>PEPSPP
						

							6
DIMENSIONS Height 85 cm
Width 60 cm
Depth 60 cm
WASHING DRYING
MAXIMUM LOAD Cotton 5.5 kg 2.7 kg
Synthetics 3 kg 2 kg
Delicates 3 kg -
Woollens 2 kg -
SPIN SPEED 1200 rpm max.
POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz
TOTAL POWER ABSORBED 2200 W
MINIMUM FUSE PROTECTION 10 A
WATER PRESSURE Minimum 50 kPa
Maximum 800 kPa
This appliance complies with the following EEC Directives:
73/23/EEC of 19/02/73 relating to low voltage
89/336/EEC of 03/05/89 relating to electromagnetic compatibility.
Technical specifications
132991030 EW1289W.qxd  08/07/2003  13:33  Pagina  6    (Nero/Process Black pellicola) 
						

							ENGLISH
Installation
7
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the two
rear bottom screws.Slide out the two plastic pins.
2. Lay the machine on its back, taking care not to
squash the hoses. This can be avoided by
placing one of the corner packing pieces between
the machine and the floor.
3. Remove the polystyrene block from the boottom
of the machine and release the two plastic bags.
4. Very carefully slide out the left polythene bag,
removing it towards the right and then
downwards.
5. Very carefully slide out the right polythene bag,
removing it towards the left and then upwards.











	
6. Set the machine upright and remove the
remaining rear screw. Slide out the relevant pin.
7. Plug the open holes with the plugs which you will
find in the plastic envelope containing the
instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor.
Water inlet
Connect the water inlet hose to a tap with a 3/4
thread.
Do not use already employed employed hoses.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks











132991030 EW1289W.qxd  08/07/2003  13:33  Pagina  7    (Nero/Process Black pellicola) 
						

							8 The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially
designed for this type of use.
Water drainage
The end of the drain hose can be positioned in three
ways:
Hooked over the edge of a sink using the plastic
hose guide supplied with the machine. In this
case, make sure the end cannot come unhooked
when the machine is emptying.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a heightof not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain pipe
must be larger than the outside diameter of the drain
hose.
The drain hose must not be kinked. Run it along the
floor; only the part near the drainage point must be
raised.




Electrical connection
This machine is designed to operate on a 220-230 V,
single-phase, 50 Hz supply.
Check that your domestic electrical installation can
take the maximum load required (2.2 kW), also
taking into account any other appliances in use.
Connect the machine to an earthed socket.
The manufacturer declines any responsibility
for damage or injury through failure to comply
with the above safety precaution.
Shuold the appliance power supply cable need
to be replaced, this should be carried out by
our Service Centre.
The power supply cable must be easily
accessible after installing the machine.
132991030 EW1289W.qxd  08/07/2003  13:33  Pagina  8    (Nero/Process Black pellicola) 
						

							ENGLISH
Your new washer-dryer
9 This new machine, which is fitted with the Direct Spray system, patented Electrolux, meets all modern needs
for effective treatment of laundry with low water, energy and detergent consumption.
Further savings are achieved by washing small loads of laundry, since water and electricity consumption is
proportional to the quantity and type of laundry being washed.
•The programme progress displayshows the programme steps selected  and the programme phase which
is running.
• The DELAY STARToption allows you to delay starting of the wash programme to the desired time of day.
• The RINSE HOLDfunction (stop with water in drum) can be selected for all fabrics: the laundry is left
immersed in the final rinse water to avoid the formation of creases.
•The special wool programmewith its new delicate wash system treats your woollens with extreme care.
•The drying programmeswill give your wash that soft, relaxed feel whatever the weather.
•3-compartment drawerfor detergent and fabric softner.
•The balance control deviceensures the machine is stable during the spin.
1 Detergent dispenser drawer
2 Programme chart
3 Control panel
4 Door locked pilot light
5 Drain pump
6 Adjustable feet
Door locked pilot light
It stays on during the whole programme indicating
that the door is locked.
When the light goes out, the door can be opened
(see page 14).
Detergent dispenser drawer
Prewash
Main wash
Fabric softener, starch
Description of the appliance







132991030 EW1289W.qxd  08/07/2003  13:33  Pagina  9    (Nero/Process Black pellicola) 
						

							10
Use

	

Control panel
1 ON/OFF button 
Press this button to switch the machine on. The
display (8) will show three blinking dashes or a
blinking zero.You will find more detailed explanations
on page 12 (see DISPLAY).
Press it again to switch the machine off. 
2 Mains-on light
This light comes on when the ON/OFF button is
pressed, and goes out when it is pressed again.
3 FABRIC button 
Press this button repeatedly to select the programme
on the basis of the type of laundry to be washed. The
light relevant to the selected programme will light up.
The machine will propose a temperature and
automatically select the maximum spin value
provided for the programme you have chosen. You
can change these values by operating buttons 4 and
5.
Hand wash 
When you select this programme, you obtain a
particularly delicate washing, suitable for articles of
clothing whose label indicates that they must be
hand-washed 
.
4 TEMPERATURE button
Press this button repeatedly to increase or decrease
the temperature, if you want your laundry to be
washed at a temperature different from the one
proposed by the washing machine. The relevant light
will light up.
Maximum temperatures are 95°C for cotton, 60°C for
synthetic fabrics,40°C for delicate fabrics, wool and
fabrics to be hand-washed(HAND WASH
programme).
Position SOGUK corresponds to a COLD WASH.
This option can be used for very delicate laundry,
such as curtains.
Important!
By depressing TEMPERATURE and SPIN SPEED
buttons simultaneously, the acoustic signal at the
end of the cycle is suppressed.
5 Spin speed button (DEVIR)
Press this button repeatedly to change the spin
speed, if you want your laundry to be spun at a
speed different from the one proposed by the
washing machine. The relevant light will light up.
Maximum speeds are:
• for cotton: 1,200 rpm;
• for synthetic fabrics, wool, and fabrics to be hand-
washed: 900 rpm;
• for delicate fabrics: 700 rpm.
RINSE HOLD position (SUDA BEKLETME): when
you choose this option, the machine will not drain the
water of the last rinse, so as not to wrinkle the
laundry.
At the end of the cycle, the light of the
START/PAUSE button(BAÇLAT/BEKLET) will flash,
to indicate that the water must be drained.
To complete the cycle, choose one of the following
options:
• Draining and spin:
- Press the START/PAUSE button. The machine
will drain the water, then spin the laundry at the
maximum speed provided for the performed
programme.
- Select spin speedby means of button 5, and
press the START/PAUSE button.
132991030 EW1289W.qxd  08/07/2003  13:33  Pagina  10    (Nero/Process Black pellicola)