European American Armory Pump Action Shotgun Mp133 Instruction Manual

MP133
PUMP ACTION
SHOTGUN
European American Armory Corp.
3855 North U.S. Highway One
Cocoa, Florida 32927
(321) 639-4842
www.eaacorp.com
E-mail: [email protected]
© Copyright EAA Corp. 3/00 

EAA MODEL: MP133
PUMP ACTION SHOTGUN
WARNING AND INSTRUCTION MANUAL
PLEASE READ THESE INSTRUCTIONS
MODEL NUMBERBARREL LENGTH     CALIBERS FINISH TYPE
M P 133 20,24,26,28 12GA / 3.5BLUE
  PUMP ACTION
GENERAL INFORMATION:
Weight (average) - 20 = 5.9 LBS.,  28 = 6.7 LBS.
Overall Length -  40 TO 48
Capacity - 4 + 1 @ 12ga / 3.5
FOR YOUR SAFETY AND THE SAFETY OF OTHERS, this owner’s manual
contains important warnings and safety procedures which must be under- stood
BEFORE using this firearm.  Read the entire...

1
TYPE OF AMMUNITION TO BE USED
It is suggested that high quality commercially manufactured ammunition be
used in this firearm.  Some factory ammunition works better than others and
you should stick with the brand you find works well in your shotgun.  Avoid
military surplus or hot loaded ammo.  
The use of reloaded, high pressure or
hand loaded ammunition will void the warranty.
N O T I C E
SHOTGUNS ARE CLASSIFIED AS FIREARMS OR DANGEROUS WEAPONS
and are sold by European American Armory Corporation with...

2
munition.  Make sure you know that this or any firearm is fully unloaded before
displaying or handling it.  When handling any firearm, keep your fingers away
from the trigger at all times until you intend to fire.
7.  WARNING: The actual firearm does not contain any lead; however, it does
fire ammunition containing lead or lead compounds known to the State of
California to cause cancer, birth defects, reproductive toxicity, and other seri-
ous physical injury.  Those who discharge a firearm, stand near...

3
Test your gun’s operation and safeties only at a shooting range while the fire-
arm is pointed in a safe direction.
Know your target and what is beyond.  Ask yourself what your bullet will hit if it
misses the target or passes through the intended target.  Remember, a fired
projectile can travel over a mile (including a ricochet) and is capable of going
through walls.
Guns and alcohol or drugs do not mix.  Don’t take any alcoholic beverages
and/or drugs before or during shooting activities.
Never pull...

4
Never shoot at hard flat surfaces or water....bullets ricochet.
If a gun fails to fire when the trigger is pulled, keep it pointed down range at the
target for 60 seconds.  Sometimes slow primer ignition will cause a “hang fire”
and the cartridge will go off after a short pause.  If it still fails to fire, keep
muzzle pointed in safe direction and avoid exposure to the breech, as you
attempt to unload your firearm.
Never let water, snow, mud or other material enter the barrel. Always be sure
the barrel...

5
FIRING WARNING
When shooting, full eye and ear protection is mandatory at all times.  Shooters
and spectators must wear shooting glasses and sound suppressor to prevent
eye injury and hearing loss.  Vision loss and hearing impairment can occur
with only one moment of non-protection.
W A R N I N G
Any bore obstruction, even if it is only partly blocked, may cause the gun to
blow up if it is fired, or may cause damage to the gun such as a bulged barrel.
To avoid injury or death to the shooter or...

6
EXTERNAL CONTROL PARTS:
Cross Trigger Block Safety: Located on trigger housing behind trigger, push
button style. When red ring is exposed shotgun will fire if trigger is pulled!! Do
not disengage safety unless you are ready to fire shotgun. (Safety Engaged -
The red ring is not showing and the trigger is blocked from full travel; Safety
Disengaged - The red rind is showing and the trigger has full travel...MAKE
SURE YOU UNDERSTAND HOW THE SAFETY WORKS BEFORE YOU LOAD
OR USE THE SHOTGUN)
Trigger:...

Magazine Tube Extension: Increases the Magazine tube capacity to hold 4
rds of 3.5 12ga
Internal Choke Tubes: Screw type internal, For accessory choke tubes call
“Colonial Arms Co” Selma, Al. 36702 at 334-872-9540.
DIRECTION FOR ASSEMBLY
The MP133 comes with the barrel separated from the receiver for transit rea-
sons. You will need to install the barrel to the receiver. A) To do this you will
remove the receiver and stock and forearm / slide assembly from the box and
remove the protective wrapping. B)...

Look into the muzzle. The ring at the surface of the barrel
bore overhangs the surface of the choke tube and should
be visible. The distortion of the ring may indicate the
damage of the choke tube or housing in the barrel.
PERIODICALLY, CHECK TO INSURE THE TUBE IS
FULLY SEATED IN THE BARREL.
After use remove the choke tube and clean the choke
tube threads and location in the barrel where the choke
tube thread into.  Only use choke tube lube for
lubrication. Only use IC choke tube with slug.
REMEMBER the...