Home > Flir > Thermovision > Flir ThermovisionTS Scout Quickstart Guide

Flir ThermovisionTS Scout Quickstart Guide

Add to Favourites
    Download as PDF

    View the Flir ThermovisionTS Scout Quickstart Guide for free. All the Flir manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 431-TS00-02-QS Rev 110 June 2012 Scout Quick Start Guide Power Button – The Scout camera has 3 power modes: On, Off, and Standby. • On - Takes approximately 90 seconds (during bootup there is a fast-flashing red LED on the eyepiece display). • Standby - After the camera is on, pressing the Power button will toggle the camera between On and Standby mode. (In Standby there is a slow-flashing red LED on the eyepiece display.) • Off - Push and hold the power button for 8 sec. to turn off. Capture...
    Page 2 431-TS00-02-QS Rev 110 June 2012 Installing the Batteries and SD Card The batteries must be installed and charged before using your camera. Install your SD card. 1. Remove the small SD card cover. No tools are required. 2. Install the SD card. 3. Loosen the four captive screws securing the battery cover. 4. Pry off the battery cover by grasping the front edge where the SD card cover was removed. 5. Install the batteries as shown. 6. Snap the SD card cover back into place and re-install the...
    Start reading Flir ThermovisionTS Scout Quickstart Guide

    Related Manuals for Flir ThermovisionTS Scout Quickstart Guide

    All Flir manuals