Freedom Arms Mid-Frame Revolver Model 1997 Instruction Manual

4   

5   

6 injuring others, you must practice and become familiar with
each of these hammer positions BEFORE loading your
revolver.
SAFETY POSITION - In this position, the hammer is fully
forward resting against the receiver, and the trigger is fully
released (See Figure 1).  When the hammer is in this position,
the trigger cannot be pulled all the way back.  Do not try to
force the trigger all the way back as this can damage the trigger
or the transfer bar.
CAUTION: EVEN IF THE HAMMER IS FULLY
FORWARD, IF THE...

7   

8
Figure 2 -- Full-Cock Position   

9   

10
Figure 3 -- Half-Cock Position   

11 To place the hammer in the Half-Cock position from the Safety
position:
1. Securely grip the hammer with your thumb.
2.Keeping your finger out of the trigger guard, slowly pull
the hammer back approximately half way between the
Safety position and the Full-Cock position. As the
hammer is drawn back you will hear an audible click as
the trigger drops into the half cock notch in the hammer.
(If you do not hear the click, you must immediately
unload the revolver and either send it to Freedom Arms
or take...

12     

13