Fujitsu P55xha30 Users Manual

E-9
English
USING THE REMOTE CONTROL
1 button 
Switches between power ON and standby
state.
3DISPLAY OFF button 
For showing on-screen-information.
4PICTURE MODE button 
Switches the picture mode.
7RGB input mode selector button
[RGB 1 – 2] 
Selects RGB 1 – 2.
9Video input mode selector button
[VIDEO 1 – 3] 
Selects VIDEO 1 – 3.
AMenu button [MENU] 
 – 
Use this button to display a desired menu
for adjusting the picture.
BEnter button [ENTER] 
 – 
Press this button to finalize the selection of
a desired...

E-10
USING THE REMOTE CONTROL (Continued)
PUTTING BATTERIES IN THE REMOTE CONTROL
1To remove the cover, slide it
outwards while pressing it down.2Place two AA batteries in the
remote control.  Make sure that the
batteries are properly oriented.3Close the cover until it snaps into
place.
Note
The remote control will not function properly if the batteries are dead.  Be sure to replace them as needed.
Do not use rechargeable batteries (Ni-Cd).
CAUTION:Be sure to use replacement batteries of the same type as...

E-11
English
EFFECTIVE RANGE FOR THE REMOTE CONTROL
Point the remote control at the display’s signal receiver when using it.
Make sure that there are no obstacles between the remote control and the display’s signal receiver.
Information
The remote control may not function properly if you use a high-frequency fluorescent lamp.  If you experience problems, move the lamp or use the
remote control from a different position.
Display – front
Right Left
5 m (Front)
Display – side
Upper
Lower
30° 30°20°
20°...

E-12
BASIC OPERATIONS
*You can also use the buttons
on the display’s control
panel to perform these steps.
 TURNING THE POWER ON AND OFF
1
2
3
Press /I to the left at the bottom
of the display to the ON 
 state.
The power lamp lights up.
Press  on the remote control.
The color of the power lamp changes from “Red”
to “Green”.
Press  –  or  –  or
.
Select the video mode to be input.
Press  when the power is ON.
The color of the power lamp changes from
“Green” to “Red” and the power turns “OFF”....

E-13
English
Press the Volume button
Press  to increase the volume.
Press 
 to reduce the volume.
*Note that the volume level remains stored even when you
turn OFF the power.
Muting the audio
Press  .
The audio is removed.
Press again to restore the audio to the original level.
The mute mode can also be released by pressing the volume
buttons.
ADJUSTING THE VOLUME
When the volume adjustment button is pressed
* Functions may not be available with some models and some device options.

&1MBTNBXJEF
...

E-14
SELECTING INPUT MODE
RGB INPUT MODE
1
RGB1 mode
Press the  –  buttons to
select the input mode.
Y ou can select from VIDEO1 mode to VIDEO4
mode.
The video modes corresponding to each input
terminal are as follows.
•V IDEO1: Video
• VIDEO2: S-video
• VIDEO3: Component video
• VIDEO4: Component video
*F or selection of the input terminal, see
“SETTING THE INPUT TERMINALS” on
P.  E-29.
1
*Y ou can also use the buttons
on the display’s control
panel to perform these steps.
VIDEO INPUT MODE
V ideo1 mode...

English
E-15
CONVENIENT FUNCTIONS
OTHER BASIC OPERATIONS
On-screen information (DISPLAY)
Press  .
The mode is indicated on the screen for 5 seconds.
Picture Mode (PICTURE MODE)
Press .
This button can be used to switch the picture mode.
In the picture mode, you can switch between the set status and the fine mode.
*For the picture mode settings, see “Setting Picture Mode (P. E-20)”.
Picture Memory (PICTURE MEMORY)
Press.
This button can be used to recall the settings of the picture memories 1 – 8. Each...

E-16
WATCHING PICTURES ON THE WIDE SCREEN
Note
•Displaying a picture in a Normal mode for extended periods of time may cause phosphor burn-in.
•A variety of picture modes are available with this display.  Remember that if you select a mode with an aspect ratio (ratio of frame width to frame
height) different from that of the TV program or video media, the pictures will appear differently than if you had selected a mode having the same
aspect ratio.
• Showing a movie or similar premium event at a...

E-17
English
Information
You may find dark areas on top and at the bottom of the screen if you select one of the Zoom modes for media while using the Vista Vision or Cinema
Vision size i.e., the sizes used frequently for picture software.
* Functions may not be available with some models and some device options.
SCREEN SIZE
ASPECT RATIO
The following aspect ratios are available.
16:9 aspect ratio
(HDTV broadcasting) 4:3 aspect ratio
(VHF/UHF broadcasting, BS broadcasting)
1.85:1 aspect ratio
(Vista...

E-18
ADJUSTMENT MENU
ADJUSTMENT MENU
MENU
PICTURE
POSITION/SIZE
AUDIO
FEATURES
FAC T ORY DEFAULT
Contrast
Brightness
Color
Tint
Sharpness
Picture Mode
PrecisionSetting
Noise Reduction *
Picture Memory
Default
Position
Size
Default
T reble
Bass
Balance
Loudness
Adjustment
Function
On Screen Menu
Input Terminal
Others
Luminance
Black Level
Colour Temp.
User Colour Temp.
Dot Clock
Clock Phase
Clamp Position
A uto Calibration
24 Frame Mode
OSD
Language
Name Select
Video Input
S-video Input
D-SUB Input
D VI...