Gateway E 4100 Service Manual

							Chapter 3101
7.Replace the CRT cable.
8.Connect the speaker and card reader board cables. 
						

							102Chapter 3
Replacing the Bluetooth Module
1.Connect the Bluetooth cable to the Bluetooth module
2.Replace the Bluetooth module.
3.Connect the Bluetooth cable to the mainboard. 
						

							Chapter 3103
4. Lay the Bluetooth cable into the channel to the right of the HDD bay.
5.Apply adhesive tape to hold the bluetooth cable in place. 
						

							104Chapter 3
Replacing the Button Board
1.Replace the button board.
2.Replace the two (2) screws.
3.Connect the touchpad FFC and lock it into place. 
						

							Chapter 3105
4.Replace the button board FFC and press down to set the adhesive.
Replacing the Card Reader Board
1.Connect the two (2) FFC cables to the Card Reader Board.
2.Replace the Card Reader board into the upper case. 
						

							106Chapter 3
3.Replace the ODD Eject module onto the guide pin and into place.
4.Replace one (1) screw to secure the ODD Eject board and two (2) screws to the Card Reader Board.
5.Attach the adhesive plastic covering the Card Reader and ODD Eject FFCs to the upper cover as shown 
below. 
						

							Chapter 3107
Replacing the LED Board
1.Replace the LED board.
2.Replace the one (1) screw.
3.Connect the LED board FFC. 
						

							108Chapter 3
4.Lock the LED board FFC.
Replacing the Upper Cover
1.Align the bottom edge of the upper cover with the bottom of the chassis.
2.Ensure all wires are tucked under the upper cover then gently lower the upper cover onto the upper cover.  
						

							Chapter 3109
3.Beginning with the bottom edge, press around the edges of the upper cover to snap it into place. 
						

							11 0Chapter 3
4.Replace the six (6) screws in the upper cover.
5.Turn the computer over and replace three (3) screws in the HD bay.
6.Replace nine (9) screws in the bottom cover.