Gateway m275 remove replace keyboard User Manual

1www.gateway.com
Replacing the Gateway M275 
Keyboard
This package includes a replacement keyboard for your Gateway M275 
notebook and these printed instructions.
Tools you need
You need a small Phillips screwdriver and a small flat-blade screwdriver to 
replace the keyboard.
Preventing static electricity discharge
The components inside your notebook are extremely sensitive to static 
electricity, also known as electrostatic discharge (ESD).
Before replacing the keyboard, follow these guidelines:
■Turn...

2www.gateway.com
■Unplug the power cord and the modem and network cables.
■Remove the battery. For more information, see “Changing batteries” in 
your user guide.
■Disconnect all peripheral devices and remove any PC Cards.
Before working with notebook components, follow these guidelines:
■Avoid static-causing surfaces such as carpeted floors, plastic, and packing 
foam.
■Remove components from their antistatic bags only when you are ready 
to use them. Do not lay components on the outside of antistatic...

3www.gateway.com
7Remove the two keyboard screws.
8Turn your notebook over so the top is facing up.
9Open the LCD panel to the normal viewing position.
Screw
Screw 

4www.gateway.com
10Insert the small flat-blade screwdriver under the bottom of the keyboard 
bezel between the F11 and F12 keys and gently pry it up.
11Remove the bezel from your convertible tablet PC by pulling the bezel 
toward you and at the same time lifting its front to clear the keyboard. 
You will hear small snapping sounds as the bezel comes away from your 
convertible tablet PC. Be careful not to break off the tabs found on the 
bottom of the bezel.
ImportantInserting a piece of cloth between...

5www.gateway.com
12With a small Phillips screwdriver, remove the four keyboard screws and 
put them in a safe place.
Screws 

6www.gateway.com
13Lift the back edge of the keyboard, then slowly rotate it toward you so it 
lies keys-down on top of your convertible tablet PC. Be careful not to 
damage the LCD panel.
14Carefully insert the small flat-blade screwdriver between the keyboard 
cable and the black plastic hinge where the cable connects to the system 
board. Gently lift the hinge off the cable. The cable is now free and you 
can remove the keyboard. 

7www.gateway.com
Installing the keyboard
To install the keyboard:
1Place the new keyboard keys-down on your notebook with the space bar 
away from you.
2Verify the black plastic hinge on the system board keyboard connector is 
in the raised position.
3Insert the end of the keyboard cable between the black plastic hinge and 
the white connector.
4Press the black plastic hinge onto the keyboard cable.
5Rotate the keyboard toward the LCD panel until the keyboard is 
almost face-up.
ImportantThe plug is...

8www.gateway.com
6Insert the tabs on the front of the keyboard under the palm rest.
7Gently press the keyboard down until it is flat all the way across. The 
keyboard should easily fall into place. Be careful not to damage the 
LCD panel.
8Replace the four keyboard screws.
Ta b s
Screws 

9www.gateway.com
9Slide the tabs on the bottom side of the bezel under your convertible tablet 
PC frame.
10Press down on the bezel in several places to make sure it is correctly 
mounted. The bezel is correctly mounted when you can run your finger 
along the bezel and find no loose spots. The bezel should be flat all the 
way across.
11Turn your convertible tablet PC over so the bottom is facing up.
12Replace the two keyboard screws.
13Replace the battery, connect the power adapter and modem and network...

10www.gateway.com