Hamilton Beach Bl84 Manual

							 
 
 
 
 
 
     4)  Remove the plastic separator by pulling straight out (you may need to twist slightly to 
          loosen).  
 
 
 
 
 
 
 
 
 
 
 
 
 
5) Clean the separator with dish soap and water or in the top rack of the d\
ishwasher. 
 
6) Dry the separator thoroughly on both sides. 
 
7) Using a clean cloth or paper towel, thoroughly dry the cold water reserv\
oir. 
 
8) Place the separator back in the dispenser.  Make sure the long, tapered \
end of the separator 
is positioned firmly on the metal plug on the bottom of the reservoir. 
 
9) Replace the support collar and turn clockwise until it is firmly in place. 
 
     10)  Install a full water bottle on the dispenser (see Preparing and Loading Your Dispen\
ser for        
Use). 
 
Sanitizing and Cleaning the Water Tanks: 
 
Important: Periodically the water dispenser tanks must be sanitized to prevent unpleasant tastes in 
the water and cleaned to remove mineral deposits that can impair flow. 
 
 
To Sanitize: 
 
Important: Before cleaning, set both power switches (on the back of the dispense\
r) to the OFF 
position and unplug the water dispenser.  Note: For first time installation, skip next three steps. 
 
1) Empty the water bottle, then remove it from the dispenser. 
 
2) Drain the water tanks (see Draining Instruction) 
 
 10 
						

							3) Reinstall the silicon stopper and drain cap (see Draining Instruction)\
 
 
4) DO NOT ADD BLEACH FIRST OR DIRECTLY TO THE DISPENSER.  
Concentrated bleach may damage plastic. 
 
5) Add ½ teaspoon (2.5 ml) of ordinary 6.0% maximum household bleach to a 2 quart (2 liter) 
pitcher filled with tap water. 
 
6) Pour the solution in the opening at the top of the dispenser. 
 
7) Repeat last two steps until the dispenser is full. 
 
8) Press the hot and cold dispenser buttons until the water just begins to \
flow from the faucets. 
 
9) Allow to sit for 15-20 minutes. 
 
10) Rinse out the bleach solution. 
 
11) Drain the water tanks into a large bucket (see Draining Instruction). \
 
12) Make sure that the silicon stopper is NOT installed. 
 
13) IMPORTANT:  Remove the separator and wipe out the cold water reservoir 
(see Cleaning the Separator). 
 
14) Clean, then reinstall the separator and collar  (see Cleaning the Separ\
ator). 
 
15) Pour approximately 1 gallon (4 quarts or 4 liters) of fresh tap water into the top and allow 
to drain into the bucket. 
 
16) Flush with an additional 1 gallon (4 quarts or 4 liters) of fresh tap water and allow to drain 
into the bucket. 
 
17) Reinstall the silicon stopper and drain cap (see Draining Instruction). 
 
18) Install a fresh water bottle (see Preparing and Loading Your Dispenser for Use). 
 
19) Dispense 1 quart (1 liter) of water from each faucet and taste to make sure the bleach 
solution is completely removed. 
 
20) If you continue to taste the chlorine from the bleach solution, repeat steps 11 – 20 until the 
taste is gone. 
 
21) Plug in the dispenser.  Then turn on the hot and cold power switches (o\
n the back of the 
dispenser). 
 
 
 
 
 
 11 
						

							To Remove Mineral Deposits: 
 
Mix 2 quarts (2 liters) of water with two quarts of vinegar OR mix 1 gallon of water (4 liters) with 
16 ounces (454 g) of citric acid crystals.  Bleach does not remove mineral deposits.  Do this in 
place of step 6 above when removing mineral deposits. 
 
 
 
Preparing for Vacation: 
 
For long vacations or absences, set both power switches (on back of the\
 dispenser) to the OFF 
position. 
 
Unplug the water dispenser. 
 
Remove the water bottle. 
 
Drain the water tanks (see Draining Instructions) 
 
Dry the separator thoroughly on both the top and bottom (see Cleaning the Separator). 
 
After returning from vacation, make sure to sanitize the water tanks before using the dispenser (see 
Sanitizing and Cleaning the Water Tank). 
 
 
 
 
 
TROUBLE SHOOTING_____________________________________________ 
 
PROBLEM   POSSIBLE CAUSES   SOLUTION 
 
No hot or cold water  1. over consumption of hot or  1. wait 30 minutes 
        cold water in short period      before using again 
        of time 
 
    2.  no power supply   2.  connect plug to socket, 
              turn on heating or 
              cooling switch. 
 
Water is not cool   Dispenser is unplugged   Push plug completely into 
outlet 
 
Cooling switch not on   Check to be sure cooling 
         switch is turned to ON 
 
    The fuse is blown/circuit   Replace house fuse or reset 
    breaker is tripped    circuit breaker. 
 
         If too many items are 
         plugged into a single 
         circuit, move some items 
         to a different circuit 
 12 
						

							 
    Temperature limiter tripped  Set the hot and cold power 
         switches to OFF position. 
         Wait five minutes, then set 
         switches to ON position. 
         Wait 30 minutes for water 
         to heat or cool. 
   
Water is not hot   Dispenser is unplugged   Push plug completely into 
outlet 
 
Heating switch not on   Check to be sure heating 
         switch is turned to ON 
     
    The fuse is blown/circuit   Replace house fuse or reset 
    breaker is tripped    circuit breaker. 
 
         If too many items are 
         plugged into a single 
         circuit, move some items 
         to a different circuit 
 
    Temperature limiter tripped  Set the hot and cold power 
         switches to OFF position. 
         Wait five minutes, then set 
         switches to ON position. 
         Wait 30 minutes for water 
         to heat or cool. 
 
 
 
 
 
PROBLEM   POSSIBLE CAUSES   SOLUTION 
 
No water running   1.  empty bottle    1.   replace with new bottle 
 out from faucets   2.  inlet of bottle supporter   2.   clean out wasted paper 
         blocked by bottle seal         and bottle seal, install 
               bottle again 
 
Water dispenser does  1.  empty water bottle   1.   replace with new bottle 
 not work   2.  mineral deposits clogging tank  2.  see Care and Cleaning. 
 
Water dispenser leaks  crack or pin hole in bottle   replace with new bottle 
  from the outside 
 
Compressor runs too  1.  room temperature is hotter  This may be necessary to 
  frequently        than normal    maintain a constant    
         temperature during hot 
         and humid days 
 
    2.  dispenser does not have  Check to be sure unit is 
         proper clearance   properly located to ensure 
         adequate airflow 
      
Noisy operation   improper installation   place the machine on level 
         surface 
 
 13 
						

							    Bottle making a gurgling noise  this is normal 
     
Hot water boiling sound   this is normal 
 
    Dispenser or water bottle    this is normal 
    shakes when the cooling 
    system cycles off 
 
Particles floating in  Water has high mineral   find a water source with 
 Water    content     lower hardness 
 
Water in bottle is hot  Water is boiling in the hot   press the hot dispenser 
    tank and bubbling up into   button until water flows to 
    the bottle    remove air from the hot tank 
 
Foul odor in air around  Hot water tank is empty or   press the hot dispenser 
 dispenser   not completely full   button until water flows to 
         remove air from the hot tank 
 
Water has poor taste  Separator needs cleaning   See Cleaning the Separator 
 or odor 
    Unit needs to be sanitized   See Cleaning and Sanitizing 
         the Water Tanks. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 14 
						

							 
 
 
Consumer Support__________________________________________________ 
Questions? How to contact us: Telephone 800-488-5080 (Monday – Friday 8:00AM-5:00 PM ET) 
 
E-mail: [email protected] 
 
[email protected]  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 15 
						

							 
 
 
 
 
 
 
 
 
 
 
LIMITED 1-YEAR WARRANTY  What does this warranty cover? - Any defect in materials or workmanship in the manufactured      product What does this warranty not cover? - Water Bottles - Service trips to your home to teach you how to use the   product. - Improper installation. - Failure of the product if it is abused, misused, altered or   used for other than the intended purpose. - Products that are used outside a residential or office   envinronment. - Replacement of house fuses or resetting of circuit     breakers. - Use of this product where water is microbiologically     unsafe or of unknown quality. - Damage to the product if used to dispense anything other    than water. - Damage to the product caused by accident, fire, floods or     acts of God. - Any service to the product - Incidental or consequential damage caused by possible   defects with this appliance, its installation or repair. For how long after the original purchase? -  One (1) year.   
How do I make a warranty claim? -  Return to the retailer from which it was purchased, along with a copy of the store receipt within the given period of time allowed for returns by the retailer (i.e. 90 days). After this period of time, contact TTI Appliances at 1 800 579 7990.  A refund will be provided once the defective unit and a copy of the receipt has been shipped to and received by TTI Appliances. This warranty excludes any cost of shipping to or from TTI Appliances.  How does state law relate to this warranty? - This warranty is extended to the original purchaser and     any succeeding owner for products purchased for home     or office use within the USA.  Some states do not allow     the exclusion or limitation of incidental or    consequential damages. This warranty gives you     specific legal rights, and you may also have other     rights which vary from state to state. To know what      your legal rights are, consult your local or state     consumer affairs office or your state’s Attorney     General.  Exclusion of implied warranties: Except where prohibited or restricted by law, there are no warranties, whether express, oral or statutory which extend beyond the description on the face hereof, including specifically the implied warranties of merchantability or fitness for a particular purpose.
 
Warrantor:  TTI Appliances, Los Angeles, CA  90025 
------------------------------------------------------------------------\
------------------------------------------------------------------------------------ 
 
 16 
						

							 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
HAMILTON BEACH ™ WATER
DISPENSER QUICK START 
GUIDE 
 
GUIA RAPIDA PARA 
DISPENSADOR DE AGUA 
HAMILTON BEACH ™ . . . 
 
WELCOME TO ANOTHER 
GREAT HAMILTON BEACH ™
PRODUCT 
 
BIENVENIDO A OTRO 
FABULOSO PRODUCTO DE 
HAMILTON BEACH™ 
NOTA IMPORTANTE   PARA PREVENIR DAÑOS DEJE LA UNIDAD DE PIE POR UN MÍNIMO DE CUATRO HORAS ANTES DE 
CONECTAR EL CABLE ELÉCTRICO. 
 
 PARA PREVENIR DAÑOS NO ENCHUFE O ENCIENDA SU DISPENSADOR DE AGUA A NO SER QUE HAYA AGUA EN EL SISTEMA    PODRÍAN RESULTAR MALOS OLORES SI EL CALENTADOR DE AGUA ES ENCENDIDO CUANDO NO HAY AGUA EN EL TANQUE   ANTES DE USARLO POR PRIMERA VEZ, REMUEVA LA BOLSA DE CARBON ABSORBENTE ADHERIDO A LA PARTE POSTERIOR DE ESTE DISPENSADOR, Y PONGALE EN LA BASURA. 
 
 
 
 
INSTRUCCIONES RÁPIDAS     ASEGÚRESE DE QUE EL DISPENSADOR ESTA DESCONECTADO Y APAGADO    LIMPIE Y DESINFECTE ESTE DISPENSADOR ANTES DE USAR. NOTA: PARA PREVENIR DAÑOS SIGA LAS INSTRUCCIONES EN SU MANUAL DE PROPIETARIO. 
 
 COLÓQUESE UNA BOTELLA LLENA. PARA PREVENIR DANOS SIGA LAS INSTRUCCIONES EN U S MANUAL DE PROPIETARIO     DEJE CORRER PEQUEÑA PORCIÓN 
DE AGUA DE CADA GRIFO. 
   ENCHUFE Y ENCIENDA SU DISPENSADOR    PREGUNTAS? LLAME AL    1-800-488-5080
IMPORTANT NOTICES   1. TO PREVENT DAMAGE TO WATER DISPENSER, LET UNIT STAND UPRIGHT FOR A MINIMUM OF FOUR HOURS BEFORE PLUGGING IN POWER CORD.   2. TO PREVENT DAMAGE TO WATER DISPENSER, DO NOT PLUG IN OR TURN ON YOUR WATER DISPENSER UNLESS THERE IS WATER IN THE SYSTEM.   3. ODORS MAY RESULT IF THE WATER HEATER COMES ON WHEN THERE IS NO WATER IN THE TANK.   4. PRIOR TO FIRST USE, PLEASE REMOVE CARBON ABSORBENT BAG ATTACHED TO THE OUTSIDE OF CONDENSOR ON THE BACK OF YOUR NEW DISPENSER, AND DISPOSE OF PROPERLY. 
 
 
 
QUICK START 
INSTRUCTIONS    1. ENSURE THE DISPENSER IS UNPLUGGED AND SWITCHED OFF.    2. CLEAN AND SANITIZE THIS DISPENSER BEFORE USE. NOTICE: TO PREVENT DAMAGE TO DISPENSER, FOLLOW THE DIRECTIONS IN YOUR OWNER’S MANUAL.    3. LOAD A NEW BOTTLE. NOTICE: TO PREVENT DAMAGE TO DISPENSER, FOLLOW THE DIRECTIONS IN YOUR OWNER’S MANUAL.    4. DISPENSE A SMALL AMOUNT OF WATER FROM EACH FAUCET.    5. PLUG IN AND TURN ON YOUR DISPENSER    QUESTIONS? Call 1-800-488-5080 
 
Posicion APAGADO (OFF)
OFF 
position 
 
 
Posicion ENCENDIDO (ON)
ON 
position