Hitachi 55pd5200 Users Manual

39
ENGLISH
Selected charactersSetup hint
Audio Input
AV1Stereo         L/MonoThis should correspond to the audio signal from the equipment that is
connected to AV1 audio input terminal. If it is monaural audio, set this to
L/Mono.
AV2
(Same to AV1)AV3
AV4
Scart OutputNot Available (grayed out)
RGB1DVI-PC         DVI-STBThis should correspond to the signal mode of the signal from the
equipment that is connected to RGB1 DVI terminal.
RGB2 (1st step)RGB         ComponentThis should correspond to the signal...

40
Make the checks suggested below depending on the symptoms observed.  If the symptoms remain uncorrected, contact your dealer.
Customer servicing can be hazardous.
WARNING
SymptomPoint to checkSee page
•  The screen becomes dark and the images cannot be seen
during VCR special playback (fast forward, rewind).
•  This sometimes occurs when a component output VCR such as
the 480i is connected.
This is not a malfunction; therefore, please take note that this may
occur. When it does occur, change to...

41
ENGLISH
Signal Input
1
2
3
4
S-input connector pin specifications
PinInput signal
1Y
2Y-GND
3C
4C-GND
FrameGND
20 18 16 14 12 10 8 6 4 2
21
19 1715 13 11 9
75
31
Scart connector pin specifications
PinSignalPinSignal
1AUDIO OUT (RIGHT)12Not Used
2AUDIO IN (RIGHT)13RGB-R GND
3AUDIO OUT (LEFT/MONO)14GND
4AUDIO GND15RGB-R / S.VHS CHROMINANCE IN
5RGB-B GND16BLANKING SIGNAL
6AUDIO IN (LEFT/MONO)17COMPOSITE VIDEO GND
7RGB-B IN18BLANKING SIGNAL GND
8AUDIO/RGB SWITCH / 16:919COMPOSITE VIDEO OUT
9RGB-G...

42
Recommended Signal List
With Digital RGB signal input (RGB1 input)
(: acceptable)
No.
Signal modeHorizontal
frequency
(kHz)Dot clock
frequency
(MHz)Setup Menu Condition
RemarksSignal NameResolutionVertical frequency
(Hz)DVI-PCDVI-STB
1VGA640 X 40070.0831.4725.18
2640 X 48059.9431.4725.18
3W-VGA864 X 48059.9431.4734.24WVGA type : On
4
VESA
640 X 48072.8137.8631.50
5640 X 48075.0037.5031.50
6640 X 48085.0143.2736.00
7800 X 60056.2535.1636.00
8800 X 60060.3237.8840.00
9800 X 60072.1948.0850.00
10800 X...

43
ENGLISH
Optional Tuner Unit Function
The optional tuner unit can operate when installed with the optional video unit.
Additional functions when the optional tuner unit is installed are as follows: (                      )
COMPONENT NAMES
Remote control (provided for the optional tuner unit)
POWER ON / OFF button
PICTURE MODE button
SURROUND button
Loading Batteries
1. Open the battery cover.
•  Slide back and remove the battery
cover in the direction of the arrow.
2. Load batteries.
•  Load two Size...

44
COMPONENT NAMES (continued)
Remote control (provided for the optional tuner unit) (continued)
Dynamic Natural
Movie Music
Favourite Speech
D / N
A / B i+
MENU
OK
FREEZE
ZOOM
AV 1
RGB1 RGB2 AV 2 AV 3 AV 42-4-12 I / II
P+
P-
+ -
DVD
123
456
78
09
PICTURE MODE
You may recall the picture mode by
pressing this button. Each time pressed,
picture mode is changed in following
sequence.
INPUT SELECT
Press this button to change input
mode.
RECALL
You can see the input mode status on
the screen by pressing this...

D / N
A / B i+
MENU
OK
FREEZE
ZOOM
AV 1
RGB1 RGB2 AV2 AV3 AV42-4-12
I / II
P+
P-
+-
DVD
123
456
78
0
9
45
ENGLISHSUBTITLE button
TV button
TEXT button
COLOUR buttons
(RED, GREEN, YELLOW, BLUE)
TEXT / TV+
TEXT button
TV / TEXT button
MODE button
[Buttons for TELETEXT Mode]
PAGE UP / DOWN button
REVEAL button
HOLD button
INDEX button
SUB PAGE buttons
CANCEL buttonU. N. L. button
Buttons on Remote ControlFunction
TEXTPress this to use the TELETEXT services.
TVPress this to return to the TV mode when in the...

46
Monitor rear panelSpeaker (R)
(exp)(exp) Speaker (L)
20 18 16 14 12 10 8 6 4 2
21
19 1715 13 11 9
75
31
antenna
Make sure that the power switch of the monitor is turned off.
INSTALLATION INSTRUCTIONS
Connecting Antenna
Precautions when connecting the antenna
• Please use a coaxial cable which is free from interference to connect the antenna. Avoid using a parallel flat
feeder wire as interference may occur, causing reception to be unstable and stripe noise to appear on the
screen.
• Avoid using indoor...

47
ENGLISH
OPERATING INSTRUCTIONS
POWER ON/OFF 
button
•
Input can be switched by pressing the AV1, AV2, AV3,
AV4, RGB1 or RGB2 buttons of the remote control. And
the way to return to a TV channel is as follows:
•  Pressing INPUT SELECT button at RGB2 input screen.
•  Pressing some PROGRAM SELECT buttons and select a TV
channel.
•  Pressing PROGRAM UP/DOWN buttons at the screen without
OSD(On-screen display).
•
Input can be switched in the sequence of TV 
➔ AV1
➔
AV2
➔AV3
➔AV4
➔RGB1
➔RGB2 by pressing...

48
OPERATING INSTRUCTIONS (continued)
RECALL button
MULTI PICTURE
button
SELECT buttons
Activating the Split mode from the TV screen
Pressing the MULTI PICTURE button one time will display 2 pictures.
•  The speaker icon can be shifted left and right by pressing the A/B button; the audio will be output from the
side on which the speaker icon is located.
•  The same signal input cannot be selected for both screens at the same time.
•  The TV channel can be changed by pressing the  and  PROGRAM UP/DOWN...