Honeywell thermostat 4500 User Manual

 
9 
Using Two 4500 Thermostats with 
Your Security System 
If your security system includes two 4500 thermostats and you have a 
multi-zone heating or air conditioning system, you can set the heat 
and air conditioning at different temperatures in different parts of the 
house. 
In order to program the thermostats, you must obtain access to the 
security system and then the Thermostat Menu Mode.   
Refer to the section “To Enter the Thermostat Menu Mode” on 
page 5 or perform the first three steps of...

 
10 
When Leaving Protected Premises 
for Extended Periods 
We recommend that the 4500 thermostat, the original thermostat, 
and the entire heating/cooling system be tested weekly, and always 
before leaving the premises for extended periods of time such as 
during vacation time.   
 
 W e recommend that your alarm system is monitored by a central station for 
system low battery and AC loss.  Be sure to give your central station contact 
information of someone who can access the premises in the event...

 
11 
Testing the Heating/Cooling System 
To be sure the heating/cooling system is maintaining the room 
temperature at the set-back point you have programmed by phone, 
test the system as follows:   
1.  Be sure that the 4500 thermostat is in the ACTIVE mode using its front 
panel slide switch.  Refer to page 3 if in doubt. 
2.  Be sure that the ACTIVE LED turns on, and is not flashing.  
• A flashing LED indicates a problem with the wiring to the 
4500 thermostat).   
• A “Check Thermostat”...

 
12 
Testing the Pre-Existing Thermostat 
Switch the front panel ACTIVE/BYPASS switch to BYPASS, and 
check that the pre-existing thermostat (not the 4500 thermostat) is 
working and able to control the heating/cooling system.  If the pre-
existing thermostat does not function, have it replaced, or call your 
heating or air conditioning service company.   
If you need service for your security system or heating/air conditioning 
system: 
If your security system or heating/air conditioning systems are in...

 
   
FEDERAL COMMUNICATIONS COMMISSION 
(FCC) PART 15 STATEMENT 
This equipment has been tested to FCC requirements and has been found accept-able for 
use.  The FCC requires the following statement for your information: 
This equipment generates and uses radio frequency energy and if not installed and used 
properly, that is, in strict accordance with the manufacturers instructions, may cause 
interference to radio and television reception.  It has been type tested and found to comply 
with the limits...

 
  ONE YEAR LIMITED WARRANTY 
Honeywell International Inc., acting through its Security & Custom Electronics business (Seller), 165 Eileen Way, 
Syosset, New York 11791, warrants its security equipment (the product) to be free from defects in materials and 
workmanship for one year from date of original purchase, under normal use and service. Sellers obligation is 
limited to repairing or replacing, at its option, free of charge for parts, labor, or transportation, any product proven 
to be defective in...