HP Compaq W220q User Guide

							
 
Preset Display Modes 
Preset Pixel Format 
Horizontal 
Frequency (kHz) Ve r t i c a l  
Frequency (Hz) 
1 640 x 480 31.47 59.94 
2 640 x 480 37.50 75.00 
3 720 x 400 31.47 70.08 
4 800 x 600 37.88 60.32 
5 800 x 600 46.88 75.00 
6 832 x 624 49.72 74.55 
7 1024 x 768 48.36 60.00 
8 1024 x 768 60.02 75.03 
9 1152 x 720 44.86 60.00 
10 1152 x 870 68.68 75.06 
11 1152 x 900 61.80 65.96 
12 1280 x 768 47.396 60.00 
13 1280 x 960 60.00 60.00 
14 1280 x 1024 63.98 60.02 
15 1280 x 1024 79.98 75.02 
16 1440 x 900 55.94 59.89 
17 1600 x 1000 61.648 60.00 
18 1680 x 1050 65.29 60.00  
21 
 
						

							
 
Power Cord Set Requirements 
The monitor power supply is provided with automatic line switching (ALS). This feature allows the monitor to 
operate on input voltages in the range of 100–240V ∿, 50/60 Hz, 1.5A. 
The power cord set (flexible cord or  wall plug) received with the monitor meets the requirements for use in the 
country/region where the equipment was purchased. 
If you need to obtain a power cord  for a different country/region, you shou ld purchase a power cord that is 
approved for use in that country/region. 
The power cord must be rated for the product and for the voltage and current marked on the product’s electrical 
ratings label. The voltage and current rating of the cord  should be greater than the voltage and current rating 
marked on the product. In addition, the cross-sectional area of the wire must be a minimum of 0.75 mm² or 
18AWG, and the length of the cord must be between 4.94  ft (1.5 m) and 12 ft (3.6 m). If you have questions 
about the type of power cord to use, co ntact your HP-authorized service provider. 
A power cord should be routed so that it is not likely  to be walked on or pinched by items placed upon it or 
against it. Particular attention should be  paid to the plug, electrical outlet, and the point where the cord exits from 
the product. 
Pin Assignments 
 
Pin Number 
15-Pin Side of 
the Signal Cable
 
1 Video-Red 
2 Video-Green 
3 Video-Blue 
4 Ground 
5 Detect Cable 
6 GND-R 
7 GND-G 
8 GND-B 
9 +5V 
10 Ground 
11 Ground 
12 DDC-Serial data 
13 H-sync 
14 V- s y n c 
15 DDC-Serial clock  
22 
 
						

							
Plug and Play DDC2B Feature 
This monitor is equipped with VESA DDC2B capabilities according to  the VESA DDC STANDARD. It allows the 
monitor to inform the host system of its identity  and, depending on the level of DDC used, communicate 
additional information about its display capabilities. 
The DDC2B is a bi-directional data channel based on th e I²C protocol. The host can request EDID information 
over the DDC2B channel. 
 
LCD Monitor Quality and Pixel Policy 
 
The HP LCD Monitor uses high-precisi on technology, manufactured according to high standards, to help 
guarantee trouble-free performance. Ne vertheless, the display may have cosmetic imperfections that appear as 
small bright or dark spots. This is common to all LCD displa ys used in products supplied by all vendors and is not 
specific to the HP LCD Monitor. These imperfections are  caused by one or more defective pixels or subpixels. 
A pixel consists of one red, one green, and one blue subpixel. 
A defective whole pixel is always turned on (a bright spot on a dark background), or it is always off (a dark 
spot on a bright background). The first is the more visible of the two. 
A defective subpixel (dot defect) is le ss visible than a defective whole pixel and is small and only visible on a 
specific background. 
To locate defective pixels, the moni tor should be viewed under normal  operating conditions and in normal 
operating mode at a supported resolution and response  rate, from a distance of approximately 50 cm (16 in). 
We expect that, over time, the industry will continue to im prove its ability to produce displays with fewer cosmetic 
imperfections, and we will adjust guidelines as improvements are made. 
For more information about your W220q Mo nitor, refer to the HP Web site at: http://www.hp.com/support
 
Agency Regulatory Notices 
 
Federal Communications Commission Notice 
This equipment has been tested and found to comply with the limits for a Class B di gital device, pursuant to 
Part 15 of the FCC Rules. These limits are designed to pr ovide reasonable protection against harmful interference 
in a residential installation. This equipment generates,  uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions,  may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not o ccur in a particular installation. If this equipment does 
cause harmful interference to radio or  television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the in terference by one or more of the following measures: 
Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and the receiver. 
Connect the equipment into an outlet on a circuit diffe rent from that to which the receiver is connected. 
Consult the dealer or an experienced radio or television technician for help. 
 
23 
 
						

							
Modifications 
The FCC requires the user to be notified that any changes or modifications made to this device that are not 
expressly approved by Hewlett-Packard Company may void  the user’s authority to operate the equipment. 
Cables 
Connections to this device must be made with shielded cables with me tallic RFI/EMI connector hoods to maintain 
compliance with FCC rules and regulations. 
Declaration of Conformity for  Products Marked with FCC Logo, 
United States Only 
This device complies with Part 15  of the FCC Rules. Operation is subj ect to the following two conditions: 
(1) this device may not cause harmful interference, and (2 ) this device must accept any interference received, 
including interference that may cause undesired operation. 
For questions regarding yo ur product, contact: 
Hewlett-Packard Company 
P. O. Box 692000, Mail Stop 530113 
Houston, Texas 77269-2000 
Or 
call: 1-(800)-474-6836 
For questions regarding this  FCC declaration, contact: 
Hewlett-Packard Company 
P. O. Box 692000, Mail Stop 510101 
Houston, Texas 77269-2000 
Or 
call: 1-(281)-514-3333 
To identify this product, refer to the part,  series, or model number found on the product. 
Canadian Notice 
This Class B digital apparatus meets all requirements  of the Canadian Interference-Causing Equipment 
Regulations. 
Avis Canadien 
Cet appareil numérique de la classe B  respecte toutes les exigences du Règlement sur le matériel brouilleur du 
Canada. 
24 
 
						

							
European Union Regulatory Notice 
This product complies with the following EU directives: 
Low Voltage Directive 2006/95/EC 
EMC Directive 2004/108/EC 
Compliance with these directives implies conformity to applicable harmonized European standards (European 
Norms) which are listed on the EU Declaration of Conf ormity issued by Hewlett-Packard for this product or 
product family. 
This compliance is indicated by the following  conformity marking placed on the product: 
 
This marking is valid for non-Telecom products and EU 
harmonized Telecom products (e.g., Bluetooth). 
xxxx*  
This marking is valid for EU non-harmonized Telecom 
products. *Notified body number (used only if applicable 
— refer to the product label). 
 
Hewlett-Packard GmbH, HQ-TRE, Herrenberg er Straße 140, 71034 Böblingen, Germany 
25 
 
						

							
Disposal of Waste Equipment by Users in Private Households in the 
European Union 
 
 
This symbol on the product or on its packaging indicates that this product must not be disposed of with your other 
household waste. Instead, it is your responsibility to  dispose of your waste equipment by handing it over to a 
designated collection point for the recycling of waste elec trical and electronic equipment. The separate collection 
and recycling of your waste equipment at the time of disp osal will help to conserve natural resources and ensure 
that it is recycled in a manner that  protects human health and the environm ent. For more information about where 
you can drop off your waste equipment for recycling, plea se contact your local city office, your household waste 
disposal service or the shop wh ere you purchased the product. 
Japanese Notice 
 
 
 
26 
 
						

							
Japanese Power Cord Notice 
 
 
 
Japanese Material Content Declaration 
A Japanese regulatory requirement, defined by Specification JIS C 0950, 2005, mandates that manufacturers 
provide Material Content Declarations for certain categories of electronic products offered for sale after 
July 1, 2006. To view the JIS C 0950 material declaration for this product, visit www.hp.com/go/jisc0950. 
 
 
 
Korean Notice 
 
 
 
Materials Disposal 
This HP product contains Mercury in the fluorescent lamp  in the display LCD that might require special handling 
at end-of-life. 
Disposal of this material  can be regulated because of environmental  considerations. For disposal or recycling 
information, please contact your local authoritie s or the Electronic Industries Alliance (EIA) (
www.eiae.org). 
27 
 
						

							
HP Recycling Program 
HP offers product end-of-life return programs for HP and other manufacturers’ hardware in several geographic 
areas. 
The terms and availability of these programs vary  by geography because of differences in regulatory 
requirements and local customer demand. For information on  the HP recycling program, refer to the HP Web site 
at: 
http://www.hp.com/recycle
EPA ENERGY STAR® Compliance 
 
Products marked with the ENERGY STAR® logo on the packaging box qualify with the U.S. Environmental 
Protection Agency’s ENERGY STAR® guidelines for energy efficiency. 
Products with the ENERGY STAR® label are designed to use less energy, he lp you save money on utility bills, and 
help protect the environment. 
ENERGY STAR® is a registered trademark ow ned by the U.S. government. 
28 
 
						

							
 
 
 
29 
 
						

							
  
 
Part number: 468328-001