HP IPAQ H1900 Series Pocket PC Users Guide

							Troubleshooting
User’s Guide 9–7
Expansion Cards
For more information on expansion cards, refer to Chapter 6, 
“Using Expansion Cards.”
Problem Solution
I cannot get my 
iPAQ Pocket PC 
to recognize the 
expansion card.Be sure you have firmly pushed the expansion card down into 
the iPAQ Pocket PC. Make sure third party SDIO drivers are 
installed.
I cannot insert 
my card. Be sure you are not inserting the card at an angle.
 Be sure you insert the connection area first.
I cannot remove 
my SDIO card.Push the SDIO card in to release the locking mechanism. The 
card will pop out slightly and can and be easily removed.
My iPAQ Pocket 
PC cannot 
recognize 
my card. Reset the device by using the stylus to lightly press the 
Reset button on the side of the unit.
 Be sure you loaded any drivers that came with the 
purchased expansion card. 
						

							9–8 User’s Guide
Troubleshooting 
						

							User’s Guide A–1
A
Regulatory Notices
Federal Communications Commission 
Notice
This equipment has been tested and found to comply with the 
limits for a Class B digital device, pursuant to Part 15 of the FCC 
Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This 
equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference 
will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user 
is encouraged to try to correct the interference by one or more of 
the following measures:
■Reorient or relocate the receiving antenna
■Increase the separation between the equipment and receiver
■Connect the equipment into an outlet on a circuit different 
from that to which the receiver is connected
■Consult the dealer or an experienced radio or television 
technician for help 
						

							A–2 User’s Guide
Regulatory Notices
Modifications
The FCC requires the user to be notified that any changes or 
modifications made to this device that are not expressly approved 
by Hewlett-Packard Company may void the authority to operate 
the equipment.
Cables
Connections to this device must be made with shielded cables 
with metallic RFI/EMI connector hoods in order to maintain 
compliance with FCC Rules and Regulations.
Declaration of Conformity for products 
marked with the FCC logo—United 
States only
This device complies with Part 15 of the FCC Rules. Operation is 
subject to the following two conditions: (1) this device may not 
cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause 
undesired operation.
For questions regarding your product, contact:
Hewlett-Packard Company
P. O. Box 692000, Mail Stop 530113
Houston, Texas 77269-2000
Or, call 1-800-652-6672
For questions regarding this FCC declaration, contact:
Hewlett-Packard Company
P. O. Box 692000, Mail Stop 510101
Houston, Texas 77269-2000
Or, call (281) 514-3333
To identify this product, refer to the Part, Series, or Model 
number found on the product. 
						

							Regulatory Notices
User’s Guide A–3
Canadian Notice
This Class B digital apparatus meets all requirements of the 
Canadian Interference-Causing Equipment Regulations.
Avis Canadien
Cet appareil numérique de la classe B respecte toutes les 
exigences du Règlement sur le matériel brouilleur du Canada.
Japanese Notice 
						

							A–4 User’s Guide
Regulatory Notices
European Union Notice
 0682
Products bearing the CE marking comply with the R&TTE 
Directive (1999/5/EC), EMC Directive (89/336/EEC), and the 
Low Voltage Directive (73/23/EEC) issued by the Commission of 
the European Community.
Compliance with these directives implies conformity to the 
following European Norms (in parentheses are the equivalent 
international standards and regulations):
■EN 55022 (CISPR 22)—Electromagnetic Interference
■EN 55024 (IEC61000-4-2, 3, 4, 5, 6, 8, 11)— 
Electromagnetic Immunity
■EN61000-3-2 (IEC61000-3-2)—Power Line Harmonics
■EN61000-3-3 (IEC61000-3-3)—Power Line Flicker
■EN 60950 (IEC 60950)—Product Safety
■ETS 300 328—Technical requirements for radio equipment
■ETS 300 826 or EN 301 489-17—General EMC 
requirements for radio equipment
This product may be used in all EU and EFTA countries. 
  
						

							Regulatory Notices
User’s Guide A–5
Battery Warning
ÅWARNING: This computer contains a lithium ion rechargeable 
battery pack. To reduce the risk of fire or burns, do not disassemble, 
crush, puncture, short external contacts, or dispose of in fire or water. 
Ä
CAUTION: Danger of explosion if battery is incorrectly replaced. 
Replace only with the same or equivalent type recommended by the 
manufacturer. Dispose of used batteries according to the 
manufacturer’s instructions.
Because of the type of battery used in your h1930 and h1940 Series, 
follow local regulations regarding the safe disposal of the battery. 
Your vendor can advise you on local regulations, and/or the 
existence of any battery disposal programs in operation.
Equipment Warning
Å
WARNING: To reduce the risk of personal injury, electrical shock, fire 
or damage to the equipment:
■Plug the AC adapter into a grounded (earthed) electrical outlet 
that is easily accessible at all times.
■Disconnect power from the equipment by unplugging the 
AC adapter from the electrical outlet or unplugging the 
Synchronization cable from the host computer.
■Do not place anything on the AC adapter cord or any of the 
other cables. Arrange them so that no one may accidentally step 
on or trip over them.
■Do not pull on a cord or cable. When unplugging from the 
electrical outlet, grasp the cord by the plug or, in the case of the 
AC adapter, grasp the AC adapter and pull out from the electrical 
outlet.
■Do not use converter kits sold for appliances to power the 
iPAQ h1930 and h1940 Series. 
						

							A–6 User’s Guide
Regulatory Notices
Airline Travel Notice
Use of electronic equipment aboard commercial aircraft is at the 
discretion of the airline.
Wireless Notices
In some situations or environments, the use of wireless devices 
may be restricted. Such restrictions may apply aboard airplanes, 
in hospitals, near explosives, in hazardous locations, etc.
If you are uncertain of the policy that applies to the use of this 
device, please ask for authorization to use it prior to turning it on.
U.S. Regulatory Wireless Notice
This products emits radio frequency energy, but the radiated 
output power of this device is far below the FCC radio frequency 
exposure limits. Nevertheless, the device should be used in such a 
manner that the potential for human contact with the antenna 
during normal operation is minimized.
Canadian Regulatory Wireless Notice
Operation is subject to the following two conditions: (1) this 
device may not cause interference, and (2) this device must 
accept any interference, including interference that may cause 
undesired operation of the device.
The term “IC:” before the certification/registration number 
only signifies that the Industry Canada technical specifications 
were met. 
						

							Regulatory Notices
User’s Guide A–7
Japanese Regulatory Wireless Notice 
Brazilian Regulatory Wireless Notice
Este equipamento opera em caráter secundário, isto é, não tem 
direito a proteção contra interferência prejudicial, mesmo de 
estações do mesmo tipo, e não pode causar interferência a 
sistemas operando em caráter primário. 
						

							A–8 User’s Guide
Regulatory Notices