JVC Ux- H33 Manual

For Customer Use:Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
Model No.                                                         
Serial No.                                                          
UX-H35— Consists of CA-UXH35 and SP-UXH35
UX-H33— Consists of CA-UXH33 and SP-UXH33
UX-H30— Consists of CA-UXH30 and SP-UXH30
MICRO COMPONENT SYSTEM
INSTRUCTIONS
GVT0101-008A
[B]
MICRO COMPONENT...

G-1Warnings, Cautions and Others
IMPORTANT for the U.K.
DO NOT
 cut off the mains plug from this equipment. If the
plug fitted is not suitable for the power points in your home
or the cable is too short to reach a power point, then
obtain an appropriate safety approved extension lead or
consult your dealer.
BE SURE  to replace the fuse only with an identical
approved type, as originally fitted.
If nonetheless the mains plug is cut off ensure to remove
the fuse and dispose of the plug immediately, to...

G-2
SAFETY INSTRUCTIONS
“SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT”
This equipment has been designed and manufactured to meet international safety standards, but like any electrical equip-
ment, care must be taken if you are to obtain the best results and safety is to be assured.
Do read the operating instructions before you attempt to use the equipment.
Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of
equipment) are...

1
Introduction
About This Manual
This manual is organized as follows:
• The manual mainly explains operations using thebuttons on the remote control.
You can use the buttons both on the remote
control and on the main unit for the same
operations if they have the same or similar names
(or marks), unless mentioned otherwise.
• Basic and common information that is the same for many functions is grouped in one place, and is not
repeated for each procedure. For instance, we do not
repeat the information about...

2
Contents
Location of the Buttons ............................................... 3
Main Unit ........................................................................\
.. 3
Remote Control ................................................................. 5
Getting Started ............................................................. 6
Supplied Accessories ......................................................... 6
Connecting Antennas ........................................................ 6
Connecting...

3
MICRO COMPONENT SYSTEMSTANDBYw
qe
r
t
Top view
Front view
TIMER/SNOOZE
MULTI CONTROL
ONE TOUCH
REC AHB PRO
VOLUME
AUXTAPE CDTUNER
BAND
COMPACTDIGITAL AUDIO
PHONES
4
¢7
OPEN9 7
\b
1
2
5
\f
8
4 3
Become familiar with the buttons on your unit.
Main Unit
Location of the Buttons
EN01-15_UX-H30[B]f.pm6 02.12.26, 1:35 PM
3 

4
Main unit
1PHONES jack (11)
2 Disc cover
3 TIMER/SNOOZE button (10, 22  – 24)
4 ONE TOUCH REC (recording) button (20, 21)
5
 (standby/on) button (11, 23)
\f Source buttons
•AUX,  @ #  TAPE, BAND TUNER, and
# /8  CD
Pressing one of these buttons also turns on the
unit.
7 MULTI CONTROL buttons
•4  (reverse skip),  7 (stop), and ¢  (forward
skip)
8 AHB (Active Hyper Bass) PRO button (11)
9 0 OPEN (disc cover open) button (16)
\b VOLUME + / – buttons (11)
q Display window
w STANDBY lamp (11)
e Cassette...

5
Remote Control
See the pages in parentheses for details.
1Number buttons
2 BASS button (11)
3 Multi control buttons
•
 UP,  4 (reverse skip),  7 (stop),  ¢
(forward skip), and 
 DOWN
4 SET button (13)
5 Source buttons
•3/8  CD,  2 3  TAPE, TUNER, and AUX
Pressing one of these buttons also turns on the
unit.
\f REV.MODE (reverse mode) button (19  – 21)
7 PRGM (program) button (17)
8 RDS operation buttons (14, 15)
•PTY SEARCH, PTY SELECT + / –, DISPLAY,
and TA/NEWS/INFO
9 STANDBY/ON 
 button (11, 23)
\b...

6
Getting Started
Supplied Accessories
Make sure that you have all the following items.
The number in parentheses indicates the quantity of
each piece supplied.
•AM loop antenna (1)
• FM antenna (1)
• AC power cord (1)
• Remote control (1)
• Batteries (2)
If anything is missing, consult your dealer
immediately.
Connecting Antennas
FM antenna
1Attach the FM antenna to the FM
COAXIAL 75  Ω terminal.
2Extend the FM antenna.
3Fasten it up in the position which gives
you the best reception, then fix it on...

7
1Connect the AM loop antenna to the
AM LOOP terminals as illustrated.
2Turn the AM loop antenna until you
have the best reception.
To connect an outdoor AM (MW) antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it
horizontally. The AM loop antenna must remain
connected.
For better reception of both FM and AM (MW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of...