Kenmore 13213 K Manual

21
Connect wires black to black and white to white, using UL 
Listed/CSA Approved twist-on wire connectors (not included).
Tighten strain relief screws to secure cable.
Place wires inside terminal box. Insert tabs on left side of cover. 
Make sure wires are tucked inside box. Close cover ensuring 
wires are not pinched. Use ¹⁄₄" hex head socket, nut driver or 
To r x
® T20® screwdriver and previously removed screw to secure 
cover.
Secure Dishwasher in Cabinet Opening
Check that dishwasher is still...

22
Secure dishwasher to countertop
Locate brackets on top of dishwasher and secure dishwasher to 
countertop with two, #10 x ¹⁄₂" Phillips-head screws (included). 
The dishwasher must be secured to keep it from shifting when 
door is opened.
Side mount dishwasher to cabinet
NOTE: If side mounting dishwasher to cabinet, you must drill 
pilot holes in cabinet to avoid splitting the wood. 
Locate brackets on side of dishwasher and secure dishwasher to 
cabinet with two, #10 x ¹⁄₂" Phillips-head...

23
Complete Installation
Option A, Install Access Panel - Plastic Panel
Place the plastic access panel against the dishwasher leg.
Check that the lower edge of the access panel touches the floor. 
Adjust if necessary.
Using a flat-blade screwdriver, turn the fasteners ¹⁄₄ turn 
clockwise to lock into place. The fasteners slot will be straight up 
and down when properly locked.
Option B, Install Access Panel - Metal Panel
Check that grounding clip is attached to the lower panel. 
Position the lower panel...

24
Check that the lower edge of the lower panel contacts the floor. 
Adjust if necessary.
Tighten access panel screws.
Plug into a grounded 3 prong outlet. Check that power supply 
cord does not touch dishwasher motor or lower part of 
dishwasher tub.
Reconnect Power
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, 
fire, or electrical shock.
WARNING 

25
Check Operation
■Read the Dishwasher User Instructions that came with your 
dishwasher.
■Check that all parts have been installed and no steps were 
skipped. Check that you have all tools used.
■Start dishwasher and allow it to complete the shortest wash 
cycle. After the first 2 minutes, unlatch door, wait 5 seconds, 
then open door. Check that there is water in the bottom of 
the dishwasher tub. Check that dishwasher is working 
properly.
If the dishwasher is not working properly, disconnect power...