Home > Kenwood > Communications receiver > Kenwood Th-K2at/e, K2e/t, K4at, K4e Transceiver Instruction Manual

Kenwood Th-K2at/e, K2e/t, K4at, K4e Transceiver Instruction Manual

Add to Favourites
    Download as PDF

    View the Kenwood Th-K2at/e, K2e/t, K4at, K4e Transceiver Instruction Manual for free. All the Kenwood manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 INSTRUCTION MANUAL 144MHz FM TRANSCEIVER TH-K2AT TH-K2E TH-K2ET 430MHz FM TRANSCEIVER TH-K4AT TH-K4E © B62-1696-00 (K, K2, E, E3, M, M2) 09 08 07 06 05 04 03 02 01 00
    Page 2 NOTICE TO THE USER One or more of the following statements may be applicable for this equipment. FCC WARNING This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC This equipment has...
    Page 3 MODELS COVERED BY THIS MANUAL The models listed below are covered by this manual. TH-K2AT, TH-K2E, TH-K2ET TH-K4AT, TH-K4E MARKET CODES Kn: The Americas En: Europe Mn: General (Where n represents a variation number.) The market code is printed on the bar-code label of the carton box. Refer to the product specifications {pages 122 ~ 133} for information on the available operating frequencies within each model. For accessories supplied with each model, refer to pages vii ~ ix.
    Page 4 PRECAUTIONS Please observe the following precautions to prevent fire, personal injury, or transceiver damage: ¥ Do not transmit with high output power for extended periods. The transceiver may overheat. ¥ Do not modify this transceiver unless instructed by this manual or by KENWOOD documentation. ¥ When using a regulated power supply, connect the specified DC cable (option) to the DC IN jack on the transceiver. The supply voltage must be between 12 V and 16 V to prevent damaging the transceiver. ¥ When...
    Start reading Kenwood Th-K2at/e, K2e/t, K4at, K4e Transceiver Instruction Manual

    Related Manuals for Kenwood Th-K2at/e, K2e/t, K4at, K4e Transceiver Instruction Manual

    All Kenwood manuals