Home > Land Rover > Automobile > Land Rover Body Repairs Water Leaks Water Leak Landrover Jlrext Com Manual

Land Rover Body Repairs Water Leaks Water Leak Landrover Jlrext Com Manual

Add to Favourites
    Download as PDF

    View the Land Rover Body Repairs Water Leaks Water Leak Landrover Jlrext Com Manual for free. All the Land Rover manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 Body Repairs - Water Leaks - Water Leak Diagnosis and Testing Inspection and Verification 1.1. Verify the customer concern. 2. 2. Visually inspect for obvious signs of mechanical or electrical damage. 3. 3. If an obvious cause for an observed or reported con cern is found, correct the cause (if possible) before proceeding to the next step. 4. 4. If the cause is not visually evident, verify the sy mptom and refer to the Symptom Chart. Water Leak Diagnostic Procedure Introduction This procedure...
    Page 2 There are different substances that can be used to seal water leaks, putty type sealant and wet/paste sealant. Examples of these are bostic (dum-dum) 303 glasticon and bet afill 10210 which is a white paste and terostat 33 which is clear.  NOTE: Do not use silicon based sealers as these w ill cause problems if any subsequent paint operations are required. Careful consideration needs be given as to the subs tance used to seal a water leak, for example an external seam on a white vehicle would...
    Page 3 Windscreen hinge Main harness grommet Air-con pipe grommet For windscreen hinge GO to Pinpoint Test T. For main harness grommet GO to Pinpoint Test U. For air-con pipe grommet GO to Pinpoint Test V. In rear luggage compartment/seating area (entry point - lower body side/rear)Rivets in body side Tail lights/rear end capping For rivets in body side GO to Pinpoint Test W. For tail lights/rear end capping GO to Pinpoint Test X. In rear luggage compartment/seating area (entry point - upper body...
    Page 4 apertures for abnormalities/distortion. Apply sealant to the outer edge of the grommet and reinstall Remove excess sealant from the body area 2 Materials required: sealant (clear or black), gloves, spirit wipe, cloth 3 Allow the sealant to cure, and retest suspect area for water entry 4 Is water still entering the vehicle? Yes Carry out a water leak test and visual inspection o f any suspect or wet areas, once the water entry point ha s been determined refer to the Water Ingress Paths And...
    Start reading Land Rover Body Repairs Water Leaks Water Leak Landrover Jlrext Com Manual

    Related Manuals for Land Rover Body Repairs Water Leaks Water Leak Landrover Jlrext Com Manual

    All Land Rover manuals