Lawn Mower 8211 0224 08 Stiga Multiclip 48 51se Pro48 Pro51s Operators Manual

DEUTSCHD
SI
MULTICLIP
8211-0224-0848
51S
51SE
PRO 48
PRO 51S 

3
SVENSKAS
2.
3.
4.5.
1.
A
A 

4
SVENSKA S
6.7. Briggs & Stratton LS 45
ED
8. Briggs & Stratton XTE 50
ADD
FULL
FULL
ADD
0,15 l.
ADD
FULL
9. Briggs & Stratton INTEK
10. Briggs & Stratton LS 4511. Briggs & Stratton XTE 50
3x
12. Honda
STOP
G
13. Multiclip 48/Pro 48, Briggs & Stratton 

5
SVENSKAS
G
M
STOP
G
N
18. Pro 51S
17. Multiclip 51S, Honda16. Multiclip 48, Honda
STOP
G
I
14. Multiclip 51S, Briggs & Stratton
STOP
I
G
B
15. Multiclip 51SE
21. Briggs & Stratton LS 4520. Multiclip 51S/51SE/PRO 51S
19.
STOP
N
G
I 

6
SVENSKA S
23. Honda
25. Multiclip 51S/51SE
HS
I
22. Briggs & Stratton XTE 50 / INTEK
0,75 mmBriggs & Stratton : 0,76 mm
Honda: 0,7-0,8 mm
24.
27. Multiclip 51S, 51SE, PRO 51S
P
K
26. PRO 51S
40 Nm
29.28. PRO 48, PRO 51S
T
L K 

7
ENGLISHGB
SYMBOLS
The following symbols are displayed on the ma-
chine in order to remind you about the safety pre-
cautions and attention necessary when using the
machine.
The symbols mean:
Warning! Read the Instruction Book and
Safety Manual before using the machine.
Warning! Keep spectators away. Beware
of objects being flung out.
Warning! Do not put hands or feet under
the chassis of the machine when it is run-
ning.
Warning! Before starting any repair work,
remove the spark plug cable from the...

8
ENGLISHGB
Note! Bear in mind that petrol is a perishable, do
not purchase more petrol than can be used within
30 days.
START OF ENGINE
(Briggs & Stratton)
1. Place the lawn mower on flat, firm ground. Do
notstartinhighgrass.
2. Make sure the spark plug lead is connected to
the spark plug.
3. When starting a cold engine: Press down the
primer fully 3-9 times (fig. 10, 11).
When starting a warm engine the primer does
not need to be used. If the engine stops due to a
lack of petrol, refill and press down...

9
ENGLISHGB
2. Release Start/Stop-loop G to stop the engine
(fig. 13, 14, 15, 16, 17, 18). This loop must not
be disengaged (e.g. through fixing it in the de-
pressed position against the steering), as the en-
gine cannot be stopped.
3. If the lawn mower is left unattended to, remove
the lead from the spark plug.
Multiclip 51SE:Also remove the starter key.
If the start/stop loop no longer works,
stop the engine by removing the lead
from the spark plug. Immediately take
the lawn mower to an authorised...

10
ENGLISHGB
Fill with new oil: use oil of SAE 30 or SAE 10W-
30 quality. The crankcase holds approx. 0.6 litre.
Fill until the oil reaches the “FULL/MAX” mark
on the dip stick. Do not fill with too much oil.
AIR FILTER
A dirty and blocked air filter reduces the engine
output and increases engine wear.
Briggs & Stratton LS 45 (fig. 21):Carefully re-
move the air cleaner so that no dirt falls down into
the carburettor. Take out the foam plastic filter el-
ement and wash it in liquid detergent and water....

11
ENGLISHGB
2. When the clutch loop is
pressed in approx. 2 cm
(position 1), there should
be some resistance when
moving the lawn mower.
With the clutch loop fully
pressed in (position 2, it
should not be possible to
move the mower. Unscrew
the nippleTuntil this posi-
tion is achieved.
ADJUSTING THE CLUTCH CABLE
(PRO 51S)
Control the clutch function (fig. 26):
1. Push the mower forwards and backwards with
disengaged transmission.
2. Set the clutch control to the position and
push the mover until the...