LG 22ld350 Owners Manual

PREPARATION
21
ATTACHING THE TV TO A DESK (Except 19/22LD350, 19/22LD350C)
The TV must be attached to a desk so it cannot be pulled in a forward/backward direction, potentially causing
injury or damaging the product.
G GTo prevent TV from falling over, the TV should be securely attached to the floor/wall per installation
instructions. Tipping, shaking, or rocking the machine may cause injury.
WARNING
1-Screw
(provided as parts of the product)
Desk
Stand
KENSINGTON SECURITY SYSTEM
This feature is not...

PREPARATION
22
SECURING THE TV TO THE WALL TO PREVENT FALLING
WHEN THE TV IS USED ON A STAND
PREPARATION
We recommend that you set up the TV close to a wall so it cannot fall over if pushed backwards. 
Additionally, we recommend that the TV be attached to a wall so it cannot be pulled in a forward direction,
potentially causing injury or damaging the product. 
Caution: Please make sure that children don’t climb on or hang from the TV. 
Insert the eye-bolts (or TV brackets and bolts) to tighten the...

PREPARATION
23
ANTENNA OR CABLE CONNECTION
1. Antenna (Analog or Digital)
Wall Antenna Socket or Outdoor Antenna without a Cable Box
Connections.
For optimum picture quality, adjust antenna direction if needed.
2. Cable
Wa l l
Antenna
Socket
Outdoor
Antenna
(VHF, UHF)
Cable TV
Wall JackMulti-family Dwellings/Apartments
(Connect to wall antenna socket)
RF Coaxial Wire (75 ohm)
RF Coaxial Wire (75 ohm) Single-family Dwellings /Houses
(Connect to wall jack for outdoor antenna)
Be careful not to bend the...

EXTERNAL EQUIPMENT SETUP
24
EXTERNAL EQUIPMENT SETUP
HD RECEIVER SETUP
This TV can receive digital over-the-air/digital cable signals without an external digital set-top box. However, if
you do receive digital signals from a digital set-top box or other digital external device.
Component Connection
1. How to connect
Connect the video outputs (
Y,   PB, PR)
of the digital set-
top  box  to  the C CO
OM
MP
PO
ON
NE
EN
NT
T 
 I
IN
N 
 V
VI
ID
DE
EO
O 
 
jacks  on
the TV. Match the jack colors (Y = green, P...

EXTERNAL EQUIPMENT SETUP
25
HDMI Connection
Connect the digital set-top box to the H HD
DM
MI
I/
/D
DV
VI
I
I IN
N
or H HD
DM
MI
I/
/D
DV
VI
I 
 I
IN
N 
 1
1/
/2
2
* jack on the TV.
No separate audio connection is necessary.
HDMI supports both audio and video.
1. How to connect
2. How to use
Turn on the digital set-top box. 
(
Refer to the owner’s manual for the digital set-top box.)
Select theH HD
DM
MI
I
orH HD
DM
MI
I1
1/
/2
2
* input source on the TV
using the I IN
NP
PU
UT
T
button on the remote...

EXTERNAL EQUIPMENT SETUP
26
EXTERNAL EQUIPMENT SETUP
DVI to HDMI Connection
RS-232C IN(CONTROL&SERVICE)
VIDEOYPBPRLRAUDIO
RGB IN (PC)
VIDEOAUDIORL/MONO
COMPONENT IN
OPTICAL
DIGITALAUDIO OUT AV IN 1
1
/DVI IN
AUDIO IN(RGB/DVI)
LRDVI OUTPUTAUDIO
1
2
G GA DVI to HDMI cable or adapter is required for this con-
nection. DVI doesn't support audio, so a separate audio
connection is necessary.
NOTE!
Connect  the  DVI  output  of  the  digital  set-top  box  to
the H HD
DM
MI
I/
/D
DV
VI
I 
 I
IN
N
or H HD...

EXTERNAL EQUIPMENT SETUP
27
DVD SETUP
Component Connection
Component Input ports
To get better picture quality, connect a DVD player to the
component input ports as shown below.
Component ports on the TV
YPBPR
Video output ports 
on DVD player
Y
Y
Y
YPB
B-Y
Cb
PbP
R
R-Y
Cr
Pr
RS-232C IN(CONTROL&SERVICE)
ANTENNA
/CABLE IN
N (PC)
VIDEOAUDIORL/MONO
OPTICAL
DIGITALAUDIO OUT AUDIO IN(RGB/DVI)AV IN 1
VIDEOYPBPRLRAUDIOCOMPONENT IN
YLRPBPR
12
Connect  the  video  outputs (
Y,   PB,  PR)
of  the  DVD  to
the C...

EXTERNAL EQUIPMENT SETUP
28
EXTERNAL EQUIPMENT SETUP
Composite (RCA) Connection
RS-232C IN(CONTROL&SERVICE)
ANTENNA
/CABLE INVIDEOYPBPRLRAUDIO
N (PC)
COMPONENT IN
OPTICAL
DIGITALAUDIO OUT AUDIO IN(RGB/DVI)VIDEOAUDIORL/MONOAV IN 1
LRVIDEOAUDIO
HDMI Connection
RS-232C I(CONTROL&SER
VIDEOYPBPRLAUD
RGB IN (PC)
VIDEOAUL/MONO
COMPONENT IN
OPTICAL
DIGITALAUDIO OUT AUDIO IN(RGB/DVI)
1
/DVI IN
HDMI OUTPUT
1
Connect  the A AU
UD
DI
IO
O
/V VI
ID
DE
EO
O
jacks between  TV  and
DVD. Match the jack colors (Video =...

EXTERNAL EQUIPMENT SETUP
29
VCR SETUP
Antenna Connection
Connect the RF antenna out socket of the
VCR to the A AN
NT
TE
EN
NN
NA
A/
/C
CA
AB
BL
LE
E 
 I
IN
N
sock-
et on the TV.
Connect  the  antenna  cable  to  the  RF
antenna in socket of the VCR.
1. How to connect
Set VCR output switch to 3 or 4 and then tune
TV to the same channel number.
Insert a video tape into the VCR and press PLAY
on the VCR. (
Refer to the VCR owner’s manual.)
2. How to use
2
1
RIO
UDIORAV IN 1
ANTENNA
/CABLE INLRS-VIDEO...

EXTERNAL EQUIPMENT SETUP
30
EXTERNAL EQUIPMENT SETUP
OTHER A/V SOURCE SETUP
VIDEO
AUDIO
L/MONO
R
USB IN
AV IN 2
IN 2
H/P
LRVIDEO
Camcorder
Video Game Set
Connect  the A AU
UD
DI
IO
O
/V VI
ID
DE
EO
O
jacks
between  TV  and  external  equipment.
Match the jack colors
.
(
Video = yellow, Audio Left = white, and
Audio Right = red)
1. How to connect
2. How to use
Select the A AV
V2
2
* input source on the TV using
the I IN
NP
PU
UT
T
button on the remote control.
If  connected  to A AV
V
or A AV
V 
 I
IN
N...