Loewe Individual 26 Lcd Operating Instructions

233–32507.024
TV
  Individual 40 Selection
  Individual 32 Selection
 Individual 32
  Individual 26 Selection
 Individual 26
Operating Instructions
 

 - 2
Operating modes – PIP  24
PIP picture as freeze picture  24
Selecting the station of the PIP picture  24
Select the station of the TV picture (main picture)  24
PIP scan in the PIP picture  24
Interchanging PIP picture/TV picture  24
Functions in the PIP menu  25
Setting the PIP type  25
Position of the PIP picture  25
Operating modes – EPG  26
Using the EPG  26
EPG menu  27
Selecting providers and stations  27
Data capture  27
Operating modes – Teletext  28
Page selection with the coloured keys...

3 -  
Remote control - TV functions
Switch on/off - on stand by
Select station up 
(1
Blue button: (3 programme info on/off Yellow button: 
(3 previous station
Freeze picture on 
(1
Status display on/off (3; 
MENU: hide menu Open index; 
MENU: info texts on/off PIP on/off (picture in picture)
P+/P–
Select station up/downSwitch over to operate DVD-Player
Sound menu on/off Switch over to the RADIO mode 
(2
Select station directly;
MENU: enter numbers or letters
Station list on; 
MENU: confirm/call Sound...

 - 4
Control unit
I     N     D     I     V     I     D     U     A     L
DR+
Call the menu,
in the menu: up 

Station up,
in the menu: right  Switch TV set on/off
to standby
Station down,
in the menu: left 
Radio on/off 
(1 (back to TV mode),
switching on the radio from standby
in the menu: down The mains switch is located 
in the middle of the rear side 
of the set. Display:
standby =      
operation =      
operation without screen display =      
(radio mode, EPG data capture or timer recording)...

5 -  
89374.003 SE RV IC E 
VGA/XG A  HDTV/P C I  N  AUDIO OUT 
AUDI O D  IGIT AL 
IN LR OUT  AUDI O I  N 
L 
SD/HD-COMPONENT IN 
C/ P rr Y  C/ P bb R C 
AV 2  
RGB / Y  UV ()  AV 1  ANT -TV ANT -S AT 
13/18 V  /350 mA 
5 V  /80 mA HDMI DVI () 220-240V~ 
50/60 Hz 
Audio output left/right (analogue) Audio input left/right (analogue) Center Audio input (analogue)
Antenna/cable PIP tuner 
(1
or satellite antenna
(Sat tuner 1) (1
Euro-AV-
socket 1Euro-AV-
socket 2Socket for
power cable
Service socket
VGA/XGA...

 - 6
(1 Set-specific equipment and retrofitting options for PIP and satellite tuners, see pages 44 and 45.
Connections to rear panel
Audio output left/right (analogue) Audio input left/right (analogue) Center Audio input (analogue)
Antenna/cable PIP tuner (1
or satellite antenna
(Sat tuner 1) (1
Euro-AV-
socket 1Euro-AV-
socket 2Socket for
power cable
Service socket
VGA/XGA input
HDMI (DVI) input
Digital audio inputDigital audio output Component 
video inputs
(Cb/Pb–Cr/Pr–Y)
Antenna output PIP tuner 
(1...

7 -  
Welcome
Transporting
Only transport the unit in an upright position. Hold the set by the top and bot-
tom edges of the housing. The LCD screen is made of glass and/or plastic and 
may break if not handled carefully. Should the LCD screen become damaged 
or should the liquid crystal begin to leak, then it is imperative you wear rubber 
gloves when removing the set. Should the liquid come in contact with your skin, 
thoroughly rinse with water immediately.
Installation options
As a manually rotatable...

 - 8
Welcome
Note on the LCD screen
The TV set with an LCD screen you have purchased meets the highest quality 
requirements and has been tested for pixel errors. Despite the utmost caution 
in production of the displays, it cannot be totally ruled out that some of the 
pixels might be defective for technological reasons. Please understand that such 
effects cannot be considered a unit defect as defined by the warranty as long as 
they are within the limits specified by the standard.
Cleaning
Use only a...

9 -  
For your safety
For your safety and to avoid unnecessary damage to your TV set, please 
read and observe the following safety instructions:
•  This TV set is designed exclusively for reception and reproduction of video 
and audio signals. 
•  This equipment is designed for domestic and 
office environments and must not be used 
in rooms with high humidity (e.g. bathroom, 
sauna) or high concentrations 
of dust (e.g. workshops). If the 
equipment is used in the open 
air, ensure that it is protected...

 - 10
Connection
Power mains
Remove the cover for the connections.
Connect the TV set to a 220-240V/50- 60 hertz power outlet. Plug the small 
plug of the mains cable into the mains socket on the rear of the TV set; plug the 
large mains plug into a mains socket.
Antennas
Plug the antenna plug of your antenna/cable system or the room antenna for 
DVB-T into the ANT-TV socket (Tuner 1).
If the reception conditions are good, then a room antenna may be used for  
DVB-T. Passive and active room antennas are...