Miele Da 420 V Manual

Cover
Tower
Canopy
Grease filters
Charcoal filter
Special accessory for recirculation
mode.
Recirculation grilles
Only for recirculation mode.
Control panel
	Hob lighting

Touch control for the
hob lighting
This control switches the lighting on
and off, and is also a dimmer switch.
On/Off touch control for the fan
Touch controls to select the fan
power level

Touch control for the run-on
option
The fan can be set to continue running,
and to switch off automatically after
either 5 or 15...

The cooker hood works with
. . . air extraction:
(excluding ...U models)
The air is drawn in and cleaned by the
grease filters and directed outside.
The cooker hood is fitted with a
non-return flap, which is closed when
the cooker hood is switched off. No
exchange of room air and outside air
can take place. When the cooker hood
is switched on, the non-return flap
opens for the cooking vapours to be
blown directly outside.
. . . air recirculation:
(...U models only)
The air is drawn in and cleaned first...

Conctivity
This cooker hood is communication
enabled.
Communication module XKM 2000 DA
, available as an optional extra,
enables the operation of the cooker
hood to be automatically controlled by
the operating status of a Miele electric
hob with onset controls.
For communication to take place, the
hob must be fitted with communication
module XKM 2000 KM.
The hob transmits information about its
operating status to the cooker hood via
the household power supply
(Powerline).–When the hob is switched on...

To switch the fan on
Press the On/Off control.
The fan will come on at power level "II".
The indicator lamp will come on.
If the cooker hood has been
connected to a window contact
switch via the Miele DSM 400 control
module, then the fan cannot be
switched on if the window is shut.
The indicator lamp will flash.
To select a power level
Use the–/+controls to select the
power level required.
+control = higher setting
–control = lower setting
Depending on the intensity of the
cooking vapours,...

The indicator lamps for fan power levels
I and IV will flash if the automatic
switch-off for the Intensive setting is not
activated.
Press the+control to activate auto
-
matic switch-off.
The indicator lamps for fan power
levels I and IV will now light up
constantly.
Press the–control to deactivate the
automatic switch-off function.
Press the run-on option control to
confirm your selection.
If you do not confirm your selection
within 4 minutes, the cooker hood will
automatically revert to the...

To switch the hob lighting on
The hob lighting can be switched on
and off independently of the fan.
Briefly press the lighting control to
switch on the hob lighting.
The indicator lamp will come on.
The hob lighting will switch on at
maximum brightness.
To dim the hob lighting
The brightness of the lighting can be
adjusted.
With the lighting switched on, press
and hold the right hand lighting
control. The brightness will gradually
dim until you release the control.
Press the control in again to...

Filter operating hours counter
The number of hours the appliance has
been in operation is stored in memory.
The operating hours counter tells you
when the grease filters or charcoal filter
need to be cleaned or replaced.
Resetting the operating hours
counter for the grease filters
After 30 hours of operation (or another
time if the operating hours counter has
been altered), the grease filter indicator
lamp will light up. The grease filters
must then be cleaned.
Afterwards, the grease filter operating...

Altering the operating hours counter
for the grease filters
The operating hours counter for the
grease filters is set at the factory for 30
hours. This can be lengthened or
shortened to suit the type of cooking
you do. You can choose 20, 30, 40 or
50 hours.
–Select a short time if you roast or fry
a lot.
– If you use very little fat for cooking,
select a longer time.
– If you only cook occasionally we
recommend that you still select a
short time, because grease which
has built up gradually over a long...

Activating and altering the operating
hours counter for the charcoal filter
(...U models only)
The charcoal filter is needed for
recirculation mode.
On delivery, the operating hours counter
for the charcoal filter isdeactivated.
For recirculation mode, the operating
hours counter needs to be set to suit
the type of cooking you do:
Press the On/Off control to switch the
fan off.
Press the run-on option and the
charcoal filter controls at the same
time.
The indicator lamp for the charcoal filter
control...

Reading the operating hours counter
for the charcoal filter
To check the percentage of time set
already used:
Press the On/Off control to switch the
fan on.
Press and hold the charcoal filter
control.
One or more of the indicator lamps for
the–/+controls will flash.
The number of flashing lamps shows
the percentage of the operating time
which has already been used up.
1 lamp = 25 %
2 lamps = 50 %
3 lamps = 75 %
4 lamps = 100 %
The number of operating hours used
remains in the memory, even when the...