Miele F 5122 Ui Operating And Installation Instructions

							In normal use, ice and frost will form on
the evaporator plates. If allowed to
accumulate, this will impair the
efficiency of the freezer and increase
the consumption of electricity.
Do not scrape ice and frost off the
evaporator plates as this can
damage them and render the
appliance unusable.
The freezer should be defrosted from
time to time. It must be defrosted if a
layer of ice approx. 0.5 cm thick has
accumulated. It is best to defrost when
only very little food or no food at all is
left in the freezer.
Before defrosting
Switch on the Super freeze function
at least 4 hours before defrosting to
ensure frozen food retains its cold
reserve for longer when taken out of
the freezer.

Remove the frozen food from the
freezer and place it in another
freezer, or in a cool box, or wrap it in
several layers of newspaper or cloths
and store in a cool place until the
freezer is ready for use again.

Take all the freezer drawers out
except for the bottom one, which is
used for collecting the defrosted
water.To defrost
Carry out the defrosting procedure
as quickly as possible if food has
not been placed in another freezer.
The longer the food is left out at
room temperature, the faster it
defrosts.
Switch off the appliance using the
On/Off button, and remove the plug.
The On/Off indicator light will go out.
Leave the freezer door open.
To speed up defrosting, two bowls of
hot water (not boiling), with plates
underneath them, can be placed in the
appliance. Closing the door in this
instance will help retain the warmth and
speed up the defrosting process.
Do not use steam cleaning
apparatus to defrost the appliance.
Steam could reach the electrical
components and cause a short
circuit.
We do not recommend the use of
hot air blowers such as hairdryers
for defrosting your freezer.
Never place electric heaters or
candles in the appliance to defrost
it. These can damage the plastic
parts.
Defrosting the appliance
21
 
						

							Do not use defrosting sprays or
de-icers, as they could contain
substances which may damage the
plastic parts and which may cause a
build-up of gases and pose a
danger to health.
After defrosting
Take the bottom drawer out of the
appliance and empty it.
Use a sponge or towel to soak up
any water from defrosting still in the
appliance.
Clean the appliance, and then dry it
thoroughly.
Plug the appliance in again, and
switch on using the On/Off button.
The indicator light will come on.
Switch on the Super freeze function
so that the freezer can cool down
quickly.
The indicator light will come on.

Once the temperature in the freezer
has reached the required
temperature, place the food back in
the freezer drawers and put them
back in the freezer.

Close the door to the appliance.

Switch the Super freeze function off
after 15 minutes.
The indicator light will then go out.
Defrosting the appliance
22
 
						

							A range of Miele branded cleaning
and conditioning products is
available to order from Miele or
www.miele-shop.com.
Make sure that water cannot get into
the electronics.
Never use steam cleaning
apparatus to clean the appliance.
Steam could reach the electrical
components and cause a short
circuit.
The data plate located inside the
appliance must not be removed.
It contains information which is
required in the event of a service call.
To avoid damaging the surface of
your appliance, do not use:
– cleaning agents containing soda,
ammonia, acids or chlorides,
–
cleaning agents containing
descaling agents,
–
abrasive cleaning agents, e.g.
powder cleaners and cream
cleaners,
–
solvent-based cleaning agents,
–
stainless steel cleaning agents,
–
dishwasher cleaner,
–
oven sprays,
–
glass cleaning agents,
–
hard, abrasive sponges and
brushes, e.g. pot scourers,
–
melamine eraser blocks,–sharp metal scrapers.
Before cleaning
Switch the appliance off.
Disconnect it from the mains.
Take any frozen food out of the
appliance and store it in a cool place.
Remove the freezer drawers before
cleaning them.
Defrost the freezer.
Cleaning the interior and
accessories
Use lukewarm water with a little
washing-up liquid. Wash all parts and
accessories by hand only. Do not wash
in a dishwasher.
After cleaning, wipe the interior and
accessories with a damp cloth, and
dry with a soft cloth. Leave the door
open to air the appliance for a short
while.
Ventilation gaps

The ventilation gaps should be
cleaned on a regular basis with a
brush or vacuum cleaner. A build-up
of dust will increase the energy
consumption of the appliance.
The ventilation grille in the plinth can be
removed for cleaning:

Press the clips in the openings of the
grille upwards and simultaneously
pull the grille forwards and out.
Cleaning and care
23
 
						

							Door seal
Do not use any oils or grease on the
door seal as these will cause the
seal to deteriorate and become
porous over time.
The door seal should be cleaned
regularly with clean water and then
wiped dry with a soft cloth.
After cleaning
Close the appliance door.
Reconnect to the mains and switch
the appliance on using the On/Off
button.
The indicator light will come on.
Switch on the Super freeze function
so that the freezer can cool down
quickly.
The indicator light will come on.
Once the temperature in the freezer
has reached the required
temperature, place the food back in
the freezer drawers and put them
back in the freezer.

Switch the Super freeze function off.
The indicator light will then go out.
Cleaning and care
24
 
						

							Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Ensure that current is not supplied to
the appliance until after
maintenance or repair work has
been carried out.
What to do if...
. . . the appliance does not get cool.
Make sure that the temperature dial
is not set at "0".
Check that the plug is correctly
inserted in the socket and switched
on.

Check that the fuse is not defective
and that the mains fuse has not
tripped. If it has, contact the Miele
Service Department.
. . . the door will not open because it
has been opened and closed too
many times in succession.
This is not a fault. The suction caused
by opening and closing the door is
preventing the door from opening. Wait
a few minutes and then try again. It
should now open without force.. . . the temperature is too low.
Turn the temperature dial to a lower
setting.
The Super freeze function has not
been switched off. The indicator light
is still on.
. . . the compressor is switching in
too frequently and for too long.
Check whether the ventilation gaps
have been covered over or become
dusty.
The door has been opened too
frequently, or a large amount of fresh
food has been put in at once for
freezing.
Check that the door has been closed
properly.
Check whether a thick layer of ice
has built up. If it has, then the freezer
will need defrosting.
. . . the alarm sounds and the alarm
indicator light is on.
The temperature has risen above the
setting on the temperature dial because

the door has been opened too
frequently, or large amounts of fresh
food have been put in at once for
freezing.

there has been a lengthy interruption
to the power supply.

the ventilation gaps are blocked.
Once the problem has been resolved
the alarm indicator light will go out and
the alarm will stop.
Problem solving guide
25
 
						

							. . . the On/Off button indicator light
is not on.
Check if the Super freeze indicator
light comes on when you press the
Super freeze button.
If it does, then the indicator light for
the On/Off button is defective.
Call the Service Department.
If the Super freeze indicator light
does not come on either, then check
whether
- the plug is correctly inserted in the
socket.
- the mains fuse has tripped. If it has
there is a fault. Call the Service
Department.
. . . the Super freeze indicator light
does not light up, even though the
appliance is working.
The indicator light is defective. Call
the Service Department.
. . . food has frozen together.
Use a blunt instrument, e.g. a spoon
handle or plastic scraper, to prise it
apart carefully.
. . . there is a thick layer of ice in the
freezer section.

Check whether the door closes
properly.

Defrost and then clean the freezer.
Too thick a layer of ice reduces
efficiency and increases energy
consumption.
If you still cannot remedy the fault
having followed these suggestions,
please contact the Miele Service
Department.
To prevent unnecessary loss of
temperature it is advisable not to
open the door while waiting for the
appliance to be serviced.
Problem solving guide
26
 
						

							Normal noises What causes them
Brrrrr...Humming noise made by the motor (compressor). This noise can
get louder for brief periods when the motor is switching on.
Blubb, blubb....A gurgling noise can be heard when coolant is circulating
through the pipes.
Click....Clicking sounds are made when the thermostat switches the
motor on and off.
Sssrrrrr....On multi-zone and frost-free appliances you can sometimes just
hear the movement of air circulating inside the appliance.
Creak ...Creaking sounds can be heard when material inside the
appliance expands.
Remember that the noise of the compressor and the coolant circulating in the
system is unavoidable.
Noises that you can
easily rectifyWhat causes them, and what can you do about
them
Rattling, vibrating The appliance is uneven:Realign the appliance using a spirit
level, by raising or lowering the screw feet underneath the
appliance.
The appliance is touching another appliance or piece of
furniture:Move it away.
Drawers, baskets or shelves are unstable or sticking:Check
all removable items and refit them correctly.
Are any bottles or containers unstable or knocking against
each other?Separate them.
The transport cable clips are hanging loose at the back of
the appliance:Remove the clips.
Noises
27
 
						

							In the event of a fault which you cannot
correct yourself, or if the appliance is
under guarantee, please contact:
–your Miele Dealer
or
–Miele (see back cover for contact
details).
Please note that telephone calls may
be monitored and recorded for
training purposes (UK only).
When contacting your Dealer or the
Miele Customer Contact Centre, please
quote the model and serial number of
your machine. This information is given
on the data plate.
Guarantee
Please see the guarantee card
supplied.
In the U.K. your appliance is
guaranteed for 2 years from the date of
delivery. However, you must activate
your cover by calling 08706 080028 or
registering online at www.miele.co.uk.
Please note that telephone calls may
be monitored and recorded for
training purposes (UK only).
After Sales/Guarantee
28
 
						

							The appliance is supplied with a mains
cable and moulded plug ready for
connection to an a.c. single phase
220 – 240 V 50 Hz supply. Connection
should be made via a fused plug and
suitable switched socket which is easily
accessible after installation.
For extra safety it is advisable to install
a suitable residual current device
(RCD).
Connection should be made via a fused
plug and suitable switched socket
which is easily accessible. Do not
connect the appliance to the mains
electricity supply by an extension lead.
Extension leads do not guarantee the
required safety of the appliance (e.g.
danger of overheating).
Do not connect the machine to an
inverter such as those used with an
automomous energy source e.g.Solar
power. When switched on peak loads
in the system can cause the safety
switch off mechanism to be triggered.
This can damage the electronic unit.
The machine must be used with
so-calledEnergy saving devices
either. These reduce the amount of
energy supplied to the machine
causing it to overheat.
If the electrical connectionhas to be
changed, this must only be done by a
suitably qualified and competent
person.
Electrical connection
29
 
						

							This appliance must be built in,
otherwise it could tip up.
Location
This appliance should be installed in a
dry, well-ventilated room. It should not
be installed where it is exposed to
direct sunlight or directly adjacent to a
heat-producing appliance such as an
oven or a radiator. The room
temperature should not go above or
below the climate range for which the
appliance is designed. The higher the
ambient temperature of the room, the
more energy the appliance requires to
operate.
Important: tropical / humid
environments
During periods of high humidity,
some condensation may appear on
outside surfaces of cooling
appliances. This condensation will
disappear when humidity levels
drop. For prevention, it is advisable
to install the appliance with sufficient
ventilation in a dry and/or an
air-conditioned room.
Please ensure that doors are closing
and sealing properly.
Please ensure that the appliance is
installed in accordance with these
installation instructions and that the
handle is fitted correctly. Should you
require further assistance please
contact your Miele customer service
centre.Climate range
The appliance is designed for use
within certain climate ranges (ambient
temperatures), and should not be used
outside this range. The climate range of
the appliance is stated on the data
plate inside the appliance.
Climate range Ambient room
temperature
SN
N
ST
T+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
Operating in a room which is too cold
will result in the cooling system
switching off for too long, causing the
internal temperature in the appliance to
rise with the risk of frozen food
deteriorating and going off.
Ventilation
The air inlet and outlet on the appliance
must not be covered or blocked in any
way.
They should be dusted on a regular
basis.
Before installation

Remove any cable clips from the
back of the appliance.

Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
Installation tips
30