Miele Pw 6101 Operating Instructions

							Plumbing
The machine should be connected to two
water supply valves, which conform with
local and national regulations. Installation
must be carried out by an authorized
service technician.
To ensure the machine is correctly
connected please follow the installation plan
and the separate installation instructions
supplied with the machine.
Connecting the water intake / water
drain hoses
See the enclosed installation plan.
A water pressure flow rate of at least 14.5 psi,
maximum 145 psi is required.
The inlet pressure hoses supplied with the
machine must be used for connection to the
water supply.
The hoses should only be replaced with
genuine Miele spare parts which fulfill the
pressure requirements.
The hot water intake must not exceed a
temperature of 158°F (70°C).
Cold water connection only
See the enclosed installation diagram.
,Must comply with all local codes.
Installation Instructions
41
 
						

							Electrical connection
All electrical work must be performed by a
qualified service technician in accordance
with applicable codes and standards.
The connecting terminal is located behind a
cover.
The machine must only be connected to the
voltage and frequency shown on the data
plate.
The machine is equipped with a multi-tap
transformer.
Steam heated washersare factory set to
3 phase, 208 V, 60 Hz
They can be converted to
3 phase, 240 V, 60 Hz by a Miele Service
Technician.
Electrically heated washersare factory set
to 3 phase, 230 V, 50/60 Hz
They can be converted to
3 phase, 208 V, 60 Hz by a Miele Service
Technician.
To activate the heating the water level in the
drum must be 2 (50 mm) high.
A motor overload protection is located in the
motor winding.
See the enclosed wiring and installation
diagrams.
Steam connection
The steam connection must only be
connected by a certified installer. For more
information see the enclosed installation
plan and the installation manual.
Connecting the dispensing pumps
The connecting terminal for 4 time controlled
dispensing pumps is located behind the
cover next to the electrical connection.
The dispensing pumps can be operated
without the multifunction module.
Installation Instructions
42
 
						

							1. Sort the laundry
Only use this machine for items that are machine washable, see item fabric care label.
^Empty all pockets.
2. Turn the machine on and load the laundry
^Press theIOn button to turn the machine on.
^Open the drum door and load the laundry.
^Close the drum door.
3. Add detergent
^Add detergent:
Main wash in detergent containerj,
Prewash in detergent containeri,
Fabric softener/ starch in front detergent containerp,
Additional liquid aids in rear detergent containerp(if programmed).
4. Select a program by turning the jog shuttle
Programs may vary depending on the offerings of your machine.
Standard programs
1Hot Wash 194°F9Wrinkle Free Intensive 86°F
2Cottons 140°F10Delicates
3Cottons Intensive 140°F11Woolens 86°F
4Cottons 86°F12Handwash Woolens 86°F
5Cottons Intensive 86°F13Extra Starch
6Wrinkle Free 140°F14Extra Rinse + Spin
7Wrinkle Free Intensive 140°F15Extra Spin
8Wrinkle Free 86°F16Extra Drain
5. Pressh"Start".
The selected program begins.
6. At the end of a program
The program end is displayed.
^
Open the door by pulling the handle.
Remove the laundry.
^
Leave the drum door open.
^
Turn the machine off with the0Off button.
Quick Guide
43
1 Hot Wash
Program end
Door can be opened.
mFC A
 
						

							All rights reserved / 210606 578 520 / 03