Miele T 8823 C Manual

When washing such heavily soiled items, ensure that you use
sufficient detergent and select a high temperature. If in doubt,
wash the items several times.
Oil-affected items can ignite spontaneously, especially when
exposed to heat sources such as in a tumble dryer.
The items become warm, causing an oxidation reaction in the oil.
Oxidation creates heat.
If the heat cannot escape, the items can become hot enough to
catch fire. Piling, stacking or storing oil-affected items can prevent
heat from escaping...

In many programmes, the heating phase is followed by a cooling
down phase to ensure that the items are not too hot to handle when
you remove them (this also avoids the danger of the laundry
self-igniting). The programme is not finished until the cooling down
phase is complete.
Ensure that you always wait until the end of the programme before
removing the laundry.
Warning: Do not switch the tumble dryer off before the end of the
drying programme. If this was done, remove and spread out all
items quickly...

The dryer must not be used without the fluff filters in place or if
the fluff filters are damaged in any way.
The fluff filters must be cleaned regularly.
The dryer must not be used without the condenser unit in place.
The fluff filters must be thoroughly dried after cleaning. Damp or
wet filters could cause operational faults.
Do not install the tumble dryer in a room where there is a risk of
frost occurring. At temperatures around freezing point the tumble
dryer may not be able to operate...

Always close the door after use. This way you will avoid the
danger of:
–Children climbing onto or into the dryer or hiding things in it.
–Pets or other small animals climbing into it.
The tumble dryer must not be hosed down.
Accessories
Only use genuine Miele spare parts and accessories with this
appliance.
If non-Miele parts are used, warranty, performance and product
liability claims may be invalidated.
Miele cannot be held liable for damage caused by
non-compliance with these Warning and Safety...

Control panel
Low temperaturebutton
Delicate fabrics are dried at a lower
temperature.
Drying level button
Indicator lights show the selected
drying level.
Display
See the next page.
Delay startbutton
This button is used for:
- Delaying the start of a programme.
- SelectingWarm air/Cool air.
Buzzerbutton
An audible tone sounds at the end of
the programme.
Perfect Dryindicator light
For all drying levels. See the next
page.Check lights
See Problem solving guide and After
Sales service....

The following information appears in
the display:
–Programme duration.
–Programme sequence
Drying
Cooling down
Finish
–Check and fault messages
The following functions are selected
via the display
–Programme duration
Warm air, Cool air
– Delay start
You can delay the start of a
programme.
Once the Delay start time has
finished, the programme begins
automatically.
– Programmable functions
The programmable functions are
used to alter the machines
electronics to suit changing
requirements. See Programmable...

Care symbols
Drying
Normal/higher temperature.
Reduced temperature:
SelectLow temperaturefor
sensitive fabrics.
Do not tumble dry
Ironing
Very hot.
Hot.
Warm.
Do not iron.
Tips on drying
– See the Programme chart for
maximum recommended loads
for
each programme.
Overloading can cause unnecessary
wear and tear to the laundry, give a
disappointing drying result and
cause more creasing.
–
Do not tumble dry loopknit garments!
Spin garments for at least 30
seconds after washing.
–
Open jackets
so that...

Brief instructions
The headings numbered (
,,...)
show the operating sequence and can
be used as a brief guide to using your
machine.

Sort the laundry
Separate the washed laundry and sort it
according to...
. . . the drying level required,
. . . the type of fibre or weave,
. . . size,
. . . the moisture content after spinning.
In this way an even drying result will be
achieved.
Make sure that objects, e.g.
detergent dispensing balls, have
been removed from the laundry.
They could melt and cause...

Select a programme
Select the programme you want.
The relevant indicator light will come
on. Indicator lights for drying levels or
Extra options and times may also be
displayed.
Programmes with drying levels
–Cottons, Minimum iron, Delicates,
Proofing, Express, Automatic plus,
Denim, Shirts

Press the button repeatedly until the
relevant indicator light comes on
(with almost all programmes).
Four drying levels can be selected from
Cottons and Express. The selection of
the other programmes is either...

Starting the programme
The indicator light for theStart/Stop
button will flash when a programme is
being selected. The flashing indicates
that a programme can be started.
Press theStart/Stopbutton.
TheStart/Stopbutton will now light up.
Perfect Dryonly flashes/illuminates
during programmes with drying levels.
It remains dark during time controlled
programmes (see Operating the
tumble dryer).
Note: The duration shown in the display
is only an estimate and can change.
Before the end of a programme
The...