Mitsubishi CP D2E User Manual

Loading the ribbon cartridge
Preparation
EN-21
When setting a ribbon cartridge aside, keep it upright to protect it from dust.
Do not touch the ribbon or leave a ribbon cartridge in a dusty environment.
Fingerprints or dust on a ribbon may cause printing quality to deteriorate.
If the ribbon has torn, replace the ribbon cartridge with a new one.
Note on ribbon cartridge storage
Store ribbon cartridges in a place that is free from high temperature, humidity, dust, and direct sunlight.
Downloaded From...

Loading paper
Preparation
EN-22
 Loading paper 
Loading paper into the paper-cassette
1
Open the paper-cassette cover. 
Slide and pivot the paper-cassette cover following the direction of the arrow. 
2Fan the paper stack properly and load the paper into the paper-cassette with the 
protection sheet facing up.
3Close the cover until it clicks into place. 
Note
Do not load more than 50 sheets in the paper-cassette.
Tip
Use only one pack (25 sheets) of paper at a time. Keep another pack in its original...

Loading paper
Preparation
EN-23
Setting the paper-cassette into the printer
1
Open the paper-cassette door. 
When closing the paper-cassette door, push the paper-cassette door tab in as you close the door until it 
clicks into place and locks.
2Remove the protection sheet.
3Insert the paper-cassette all the way. 
Push the paper-cassette until it clicks into place.
To remove the paper-cassette, pull it out holding both sides.
Tip
Printed paper is ejected onto the top of the paper-cassette.  
Note
Do not...

Printing pictures from a digital camera
Printing
EN-24
Printing
Printing pictures from a digital camera
About PictBridge-compatible digital cameras
You can print pictures directly by connecting your PictBridge-compatible digital camera to the printer.
You can specify the pictures to be printed and the number of prints by following the instructions displayed on 
the LCD screen of the camera while it is connected to the printer.
The printing procedure varies from one digital camera to another. Refer to the...

Printing pictures from a digital camera
Printing
EN-25
Connecting a digital camera to the printer
The procedure below assumes that you are connecting a PictBridge-compatible digital camera.
Use the USB cable supplied with the digital camera to connect.
1Turn on the printer.
For details, refer to “Plugging in to an outlet and turning the printer on/off” (gpage 18).
2Plug one end of the USB cable into the USB connector on the digital camera, and 
then plug the other end into the PictBridge connector on the...

Printing pictures from a digital camera
Printing
EN-26
Using a digital camera to print
1
Print the desired picture by following the instructions displayed on the digital camera 
screen.
The Access indicator on the printer blinks when printing is in progress. The indicator turns off when 
printing ends. For details on how to use the digital camera, refer to the manual supplied with the digital 
camera.
2When printing is complete, turn off the printer and digital camera, and then 
disconnect the USB...

Printing pictures from a PC
Printing
EN-27
Printing pictures from a PC
Installing the printer driver (during initial setup)
Supported Windows operating systems: Windows 2000/XP
Supported Macintosh operating systems: Mac OS X v10.4
1Start up your PC, and then insert the software CD-ROM supplied with the printer into 
the CD-ROM drive.
If you are using Macintosh, double click the [Installer] icon displayed on the desktop to begin 
installation.
2Install the printer driver by following the instructions...

Printing pictures from a PC
Printing
EN-28
Connecting a PC to the printer
Use a commercially available USB cable (A-B type, less than 3m (9.8 ft.)).
1Plug one end of the USB cable into the USB port on the PC, and then plug the other 
end into the USB connector on the rear of the printer.
2Turn on the printer.
Printing pictures
1
In your application, display and select the pictures to be printed.
2On the print screen, select [CP-D2E] from the available printer list.
3On the print setting screen, check the...

Printing pictures from a PC
Printing
EN-29
Setting the print properties
If you are using Windows:
Select [Printing Preferences] from the File menu. On the [MITSUBISHI CP-D2E Printing Preferences] 
screen, use the [Paper] and [Color Adjustment] tabs to change the number of copies, and to make adjustments 
to the color settings.
Paper setup screen: The following items can be set.
Color Adjustment screen: The following items can be set.
ItemContents
Paper Size 4 × 6 inch (100 × 148 mm)
Copy Count Select...

Printing pictures from a PC
Printing
EN-30
If you are using Macintosh:
Select [Page Setup] and [Print] from the File menu to change the paper size, number of copies, and to make 
adjustments to the color settings.
Page Setup screen: The following items can be set.
Note
The screens are those in Mac OS X v10.4. They may differ depending on the operation system.
ItemContents
Settings Select [Page Attributes].
Format for Select [CP-D2E].
Paper Size Select one of the following paper styles.
Edged 4 × 6 inch...