MSI Hetis 865gv-e Manual

System Assembly
3-3 Checking the Items
Before assembling  your system, please check the items listed below for basic
system operation.  You may install a card reader to enhance your system
perofrmance.
CPU Cooler Footstand
IDE or SATA HDDOptical DriveCard Reader (optional)CPU 

Chapter 3
3-4Unscrew the chassis cover.
Remove  the chassis cover.
Use a screw driver to unscrew the drives
cage. 1. Removing Cover, Front Bezel, Drives Cage and HDD tray 3.2 Installation Procedures
Press the locking tabs simultaneously to
release the front bezel from the chassis. 

System Assembly
3-5 Remove the front bezel.
Press the lock brackets inwards and then
pull the drives cage forwards to remove it
from the chassis.
Remember to unplug the power cord
while removing the drives cage.
The drives cage has been removed. 

Chapter 3
3-6 The HDD tray has been removed. Pull the HDD tray forwards to remove
from the chassis. Push the tray lever to release the tray.
Pull the lever in the direction indicated to
take out the tray. 

System Assembly
3-7 Insert the DIMM vertically into the slot.
Note: The DIMM has only one notch on
the center of module.  It will only fit in the
right direction.
The plastic clip at each side of the
DIMM slot will automatically close. 2. Installing Memory ModulesLocate the DIMM slots. 

Chapter 3
3-8 Locate the CPU socket.  Pull the lever
away from the socket and raise it up to
90-degree angle.
Close the lever to complete the
installaton. 3. Installing CPU
Put the CPU onto the socket.
Note: Make sure the pins are completely
embedded into the socket.  The CPU can
only fit in the correct direction. 

System Assembly
3-9If the metal clip is closed, push the black
tab to open the clip.  Remember to do so
on four clips. Before installing the CPU cooler, check
to see if the four metal clips of the CPU
cooler are closed. 4. Releasing Cooler Clips 

Chapter 3
3-10Place the CPU cooler onto the CPU
socket. 5. Installing CPU Cooler
Close the lever to secure the CPU cooler.Please note that the metal clips must not
be placed inside the CPU cooler rack.
Instead, they should be placed outside
the rack. 

System Assembly
3-11 Connect the power cord of the CPU
cooler. 

Chapter 3
3-12 6. Installing HDD
Use 4 screws to secure the IDE HDD
module. Insert the IDE HDD module into the tray.
Note: The system supports both IDE and
SATA interfaced HDD.
Connect the HDD cable and  power cord.