NEC Ds2000 Hardware Manual Instructions Manual
Here you can view all the pages of manual NEC Ds2000 Hardware Manual Instructions Manual. The NEC manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 71
4. Optional Equipment 4-21 WALL-MOUNT KIT Wall-Mounting a Key Telephone (Figures 4-11 through 4-13) To mount the telephone on the wall(Figure 4-11): 1. Using the screws provided, attach the wall-mount bracket to the wall in the desired location. 2. Plug in the telephone’s modular line cord. 3. Run the telephone’s line cord through one of the slots in the bottom of the wall-mount bracket. 4. Plug the line cord into the telephone’s 625 modular jack. 5. Place the telephone on top of the wall-mount bracket...
Page 72
4-22 WALL-MOUNT KIT To mount the telephone on a wall plate(Figure 4-12): 1. Snap the wall-mount bracket onto the wall plate. 2. Plug the telephone’s line cord into the jack in the wall plate and into the telephone. 3. Place the telephone on top of the wall-mount bracket and snap into place. Figure 4-12 MOUNTING ON A WALL PLATE 80000 - 43A Tab on phone must snap into cutout on wall mount bracket
Page 73
4. Optional Equipment 4-23 WALL-MOUNT KIT To remove the telephone from the wall mount kit (Figure 4-13): 1. From the front of the phone, grab the tabs that secure the telephone to the wall-mount kit. 2. While pressing in the tabs, lift up the phone until it snaps clear of the wall-mount kit. Figure 4-13 REMOVING THE WALL MOUNT BRACKET 80000 - 45 Press down tabs on phone and pull bracket in direction of arrows
Page 75
4. Optional Equipment 4-25 Using the Desk Stand (Figure 4-14) Each telephone has an integrated desk stand. You can extend the desk stand in one of two positions: low and high.To use the desk stand low position: 1. Flip up each telephone leg until it snaps into place.To use the desk stand high position: 1. Flip up each telephone leg into the low position. 2. Push out the leg extender. 3. Slide the extender up, then down until it locks in place as shown at right. Figure 4-14 USING THE DESK STAND 80000 -...
Page 76
4-26 REJ RECORDING JACK Installing the REJ Recording Jack (Figure 4-15) Use the REJ Recording Jack (P/N 80175) to connect a Super Display or 34-Button Display Telephone to an external tape recorder or amplifier. The REJ output is a mono sub-miniature jack which connects directly to an AUX level input. The REJ broadcasts both sides of your conversation (i.e., your voice and your caller’s voice) whenever you lift your handset. The REJ does not broadcast Paging announcements or activate for Handsfree...
Page 77
4. Optional Equipment 4-27 REJ RECORDING JACKFigure 4-15 INSTALLING THE REJ 80000 - 48To mono AUX input on amplifierRed wire
Page 79
5. Maintenance Options and SMDR 5-1 Section 5, MAINTENANCE OPTIONS AND SMDR In this section . . . PageSMDR . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-8 Installing SMDR . . . . . . . . . . . . . . . . . . . . . . 5-8 Programming SMDR . . . . . . . . . . . . . . . . . . . 5-8 Modem Installation . . . . . . . . . . . . . . . . . .5-10 Installing a Modem . . . . . . . . . . . . . . . . . . . . 5-10 Making your own Data Cables . . . . . . . . .5-12 In this section . . . PageBacking Up Site...
Page 80
5-2 PC Card Data Base Compatibility Keep the following PC Card data base compatibility guidelines in mind when backing up and restoring site data:U Slot Version 02.01.00 or Higher Use PC Card with Software P/N 80051-V02.**.** to load or upgrade your system software. Do not use PC Card with Software P/N 80050-V**.**.**. Use Blank PC Card P/N 85880 to store up to 16 system data bases. You cannot store data bases on PC Card with Software P/N 80051-V02.**.**. If restoring a data base from software...