NEC Px 50xr6 Operation Manual

En-9
R 1
2
(MONO)LY Cb/Pb Cr/Pr
R
LY Cb/Pb Cr/Pr
(MONO)
R
L
(MONO)
IN
OUTHDMIHDMIVIDEO AUDIO1DVD/HD1DVD/HD2DVD/HD3DVD/HD4PC/RGB AUDIO2AUDIO 3REMOTEEXTERNAL CONTROL
VIDEO AUDIO1DVD/HD1DVD/HD2DVD/HD3DVD/HD4PC/RGB AUDIO2AUDIO 3REMOTEEXTERNAL CONTROLCb / Pb Cr/ Pr L/R Y Cb/Pb Cr/Pr L/R Y
L/RIN OUT
D
CE F G H IJKBAL
Rear View/ Terminal Board
60XR5
HDMI, the HDMI logo and High-Definition Multimedia Interface are 
trademarks or registered trademarks of HDMI Licensing LLC.
AAC IN
Connect the included power cord...

En-10
q POWER ON/STANDBY
Switches the power on/standby.
(This does not operate when the ON/STANDBY
indicator of the plasma is off.)
w OFF TIMER
Activates the off timer for the unit.
eDISPLAY
Displays the source settings on the screen.
rWIDE
Automatically detects the signal and sets the aspect
ratio.
WIDE button is not active for all signals.
tMENU/ENTER
Press this button to access the OSM controls.
Press this button during the display of the main menu
to go to the sub menu.
yCURSOR ( / 
 / 

 / )
Use...

En-11
Basic Operations
POWER
To turn the unit ON and OFF:
1. Plug the power cord into an active AC power outlet.
2. Press the Power button (on the unit).
The monitor’s ON/STANDBY indicator turns red and the
standby mode is set.
3. Press the POWER ON button (on the remote control) to
turn on the unit.
The monitor’s ON/STANDBY indicator will light up
(green) when the unit is on.
4. Press the POWER STANDBY button (on the remote
control) or the Power button (on the unit) to turn off the
unit.
The monitor’s...

En-12
Wide Screen Operation (manual)
With this function, you can select one of seven screen sizes.
When viewing videos or digital video discs
1. Press the WIDE button on the remote control.
2.Within 3 seconds ...
Press the WIDE button again.
The screen size switches as follows:
→ NORMAL → ANAMORPHIC → STADIUM → ZOOM → 2.35:1 → 14:9 → UNDERSCAN
When a 720P or 1080I signal is input:
ANAMORPHIC ↔  2.35:1
When displaying enhanced split screen:
NORMAL ↔  ANAMORPHIC
NORMAL size screen (4:3)
The normal size...

En-13
Information
 Supported resolution
See page En-3 of Model Information for details on the
display output of the various VESA signal standards
supported by the monitor.
 When 852 (848) dot  480 line wide VGA*
signals with a vertical frequency of 60 Hz and
horizontal frequency of 31.7 (31.0) kHz are in-
put
Select an appropriate setting for RGB SELECT mode
referring to the“Table of Signals Supported” on page
En-3 of Model Information.
*“VGA”, “SVGA” and “SXGA” are registered
trademarks of IBM, Inc....

En-14
Information
Split screen operations may not function depending on
the combination of input signals. In the table below,
“” means Yes, “” means No.
 Split screen operations may not function
depending on the frequency of the RGB
signals.
SPLIT SCREEN Operations
Showing a couple of pictures on the
screen at the same time
* There may be some RGB-input  signals that may not be
displayed as not all signals are supported.
1. Press the button to select a screen mode from among single
mode, side-by-side,...

En-15
Operations in the Picture-in-picture mode
To move the position of the sub screen, press the cursor 

or  button.
To change the size of the sub screen, press the 
 button.
VIDEO1PC/RGB
AB
VIDEO1PC/RGB
AB
VIDEO1PC/RGB
AB
VIDEO1PC/RGB
AB
 button
 button
 button
 button
To make the desired picture active, press the ACTIVE
SELECT button.
ACTIVE
SELECT
button
VIDEO1PC/RGB
AB
VIDEO1PC/RGB
AB
A
B
VIDEO1PC/RGBVIDEO1A
B
PC/RGB
Bottom Left Bottom Right

button
button
 button
 button
Top Right

button...

En-16
Menu Operations
The following describes how to use the menus and the
selected items.
1. Press the MENU/ENTER button on the remote control to
display the MAIN MENU.
MAIN MENU
PICTURE
AUDIO
IMAGE ADJ.SET UP
FUNCTION
SIGNAL INFO.
SEL.EXITMENU/ENTEROKEXIT
2. Press the cursor buttons 
   on the remote control to
highlight the menu you wish to enter.
3. Press the MENU/ENTER button on the remote control to
select a sub menu or item.
SEL. ADJ. RETURN
PICTURE
PICTURE MEMORY
CONTRAST
BRIGHTNESS
SHARPNESS...

En-17
Main menu Sub menu Sub menu 2 Sub menu 3 Sub menu 4 RESETREFERENCE
PICTURE PICTURE MEMORY OFF/MEMORY1-6 YES En-19
CONTRAST←→  0←52→72 YES En-19
BRIGHTNESS←→  0←32→64 YES En-19
SHARPNESS←→  0←16→32 YES En-19
COLOR←→  0←32→64 YES En-19
TINT R←→G     0←32→64 YES En-19
NR OFF/NR-1/NR-2/NR-3 YES En-19
COLOR TEMP. LOW/MIDDLE LOW/MIDDLE/HIGH YES En-20
WHITE BALANCE GAIN RED←→  0←40→70 YES En-20
GAIN GREEN←→  0←40→70 YES En-20
GAIN BLUE←→  0←40→70 YES En-20
BIAS RED←→  0←40→70 YES En-20...

En-18
*1 Only when AUTO PICTURE is OFF.
*2 PC/RGB only
*3“LOW TONE” is only for 50 inch type.
Main menu Sub menu Sub menu 2 Sub menu 3 Sub menu 4 RESETREFERENCE
FUNCTION ADVANCED OSM ON←→OFFYES En-26
POWER MGT. ON←→OFFYES En-26
INPUT SKIP ON←→OFFYES En-27
SUB. PICTURE SUB. P DETECT OFF←→AUTO YES En-27
DISPLAY FADE←→NORMAL YES En-27
SUB. P RATE 20%←…
→100% YES En-27
ZOOM NAV OFF←→S BY S←→BTM LEFT←→BTM RIGHT←→TOP RIGHT←→TOP LEFT YES En-27
PICTURE FREEZE OFF←→S BY S1←→S BY S2←→BTM LEFT←→BTM RIGHT←→TOP...