Nokia N974 Manual

2 If the battery is inserted, lift the battery to remove it.3 Pull out the SIM card holder, and insert the SIM card. Make
sure that the contact area on the card is facing down and
that the missing corner on the card is facing the missing
corner on the holder. Push the SIM card holder back in.4 Align the contacts of the battery with the corresponding
connectors on the battery compartment, and insert the
battery.
5 To replace the back cover, direct the top locking catches
toward their slots, and press down...

Insert the memory card
A memory card may be already inserted in the device. If not,
do the following:
1 Remove the back cover of the device.2 Insert a compatible memory card in the slot. Ensure that
the contact area on the card is facing down and towards
the slot.3 Push the card in, until it locks into place.
4 Replace the back cover. Keep the device facing down
when replacing the cover. Ensure that the cover is
properly closed.
Remove the memory card
Important: Do not remove the memory card during an...

Switch the device on or off
To switch on the device:
1 Press and hold the power key.
2 If the device asks for a PIN code or lock code, enter it, and
select OK. The preset lock code is 12345. If you forget the
code and your device is locked, your device will require
service and additional charges may apply. For more
information, contact a Nokia Care point or your device
dealer.
To switch off the device, press the power key briefly, and
select Switch off!.Charge the battery
Your battery has been partially...

device for the first time. If the device indicates a low charge,
do the following:
1 Connect the charger to a wall outlet.2 Connect the charger to the device. The charging indicator
light next to the micro-USB connector is lit when the
battery is being charged.
3 When the device indicates a full charge, disconnect the
charger from the device, then from the wall outlet.
You do not need to charge the battery for a specific length of
time, and you can use the device while it is charging. If the
battery is...

Warning:
When you use the headset, your ability to hear outside
sounds may be affected. Do not use the headset where it can
endanger your safety.
Do not connect products that create an output signal as this
may cause damage to the device. Do not connect any voltage
source to the Nokia AV Connector.When connecting any external device or any headset, other
than those approved by Nokia for use with this device, to the
Nokia AV Connector, pay special attention to volume levels.
Attach a wrist strapThread the...

Tap and double-tapTo open an application or other element on the touch screen,
you normally tap it with your finger. However, to open the
following items, you must tap them twice.
•List items in an application, such as the Drafts folder in
the Messaging application.
•Files in a file list, for example, an image in the Captured
folder in the Photos application.
Tip: When you open a list view, the first item is already
highlighted. To open the highlighted item, tap it once.
If you tap a file or similar item...

FlickTo flick, place your finger on the screen, slide it quickly across
the screen, then quickly lift your finger. The content of the
screen will continue scrolling with the speed and direction it
had at the moment of release. To select an item from a
scrolling list and to stop the movement, tap the item. In your
device, flicking is available in Music player.ScrollTo scroll up or down in lists that have a scroll bar, drag the
slider of the scroll bar.
In some list views, you can place your finger on a...

Keyboard input
KeyboardYour device has a full keyboard. To open the keyboard, push
the touch screen up. In all applications, the screen rotates
automatically from portrait to landscape when you open the
keyboard.
1Sym key. To insert special characters not shown on the
keyboard, press the sym key once, and select the desired
character from the table.
2 Function key. To insert special characters printed at the
top of keys, press the function key, and then press the
corresponding alphabet key, or press and...

Insert letters not shown on the keyboardIt is possible to insert variations of letters, for example, letters
with accents. To insert á, press and hold the sym key, and
simultaneously press the A key repeatedly, until the desired
character is displayed. The order and availability of letters
depends on the selected writing language.Touch input
HandwritingThe input methods and languages supported by the
handwriting recognition vary by region and may not be
available for all languages.
To activate...

Writing speed  — Adjust the speed at which handwriting is
recognised.
Guiding line  — Show or hide the guiding line in the writing
area. The guiding line helps you write in a straight line, and
it also helps the device recognise your writing. This option
may not be available in all languages.
Pen trail width  — Change the thickness of the text.
Writing colour  — Change the colour of the text.
Virtual keypadWith the virtual keypad (Alphanumeric keypad), you can
enter characters like you would with a...