OKI C110 User Manual

31  -  C110 User’s Guide
Types
Before purchasing a large quantity of special media, do a trial printing  
with the same media and check the print quality.
Keep media on a flat, level surface in its original wrapper until it is time to  
load it.
Plain Paper (Recycled Paper)
Use plain paper that is
Suitable for plain paper laser printers, such as standard or recycled office 
paper.
Important!
Do not use the media types listed below. These could cause poor 
print quality, media misfeeds, or damage to the...

32  -  C110 User’s Guide
Dusty
Wet (or damp)
Layered 
Adhesive
Folded, creased, curled, embossed, warped, or wrinkled
Perforated, three-hole punched, or torn 
Too slick, too coarse, or too textured 
Different in texture (roughness) on the front and back
Too thin or too thick
Stuck together with static electricity
Composed of foil or gilt; too luminous
Heat sensitive or cannot withstand the fusing temperature (180°C 
[356°F])
Irregularly shaped (not rectangular or not cut at right angles)
Attached with...

33  -  C110 User’s Guide
Labels
CAUTION
Labels may stick to the fuser, causing them to peel off and media 
misfeeds to occur.
A sheet of labels consists of a face sheet (the printing surface), adhesive, and 
a carrier sheet:
The face sheet must follow the plain paper specification.
The face sheet surface must cover the entire carrier sheet, and no 
adhesive should come through on the surface.
You can print continuously with label sheets. However, this could affect the 
media feed, depending on the media...

34  -  C110 User’s Guide
DO NOT use label sheets that 
Have labels that easily peel off or have parts of the label already removed
Have backing sheets that have peeled away or have exposed adhesive
Are precut or perforated
Letterhead Stationery
You can print continuously with letterhead. However, this could affect the 
media feed, depending on the media quality and printing environment. If 
problems occur, stop the continuous printing and print one sheet at a time.
Try printing your data on a sheet of...

35  -  C110 User’s Guide
Postcards
You can print continuously with postcard. However, this could affect the 
media feed, depending on the media quality and printing environment. If 
problems occur, stop the continuous printing and print one sheet at a time.
Try printing your data on a sheet of plain paper first to check placement.
Use postcards that are
Approved for laser printers
DO NOT use postcards that are
Coated
Designed for inkjet printers
Precut or perforated
Preprinted or multicolored
NoteIf the...

36  -  C110 User’s Guide
Printable Area
The printable area on all media sizes is up to 4.0 mm (0.157) from the edges 
of the media.
Each media size has a specific printable area (the maximum area on which 
the machine can print clearly and without distortion). 
This area is subject to both hardware limits (the physical media size and the 
margins required by the machine) and software constraints (the amount of 
memory available for the full-page frame buffer). The printable area for all 
media sizes is...

37  -  C110 User’s Guide
Loading Media 
1OPen the ream of paper and take off the top and bottom sheets. 
2Holding a stack of approximately 200 sheets at a time, fan the stack to 
prevent static buildup before inserting it in a tray.
Important!
Although this printer was designed for printing on a wide range of 
media types, it is not intended to print exclusively on a single 
media type except plain paper. 
 
 
Continuous printing on media other than plain paper (such as 
labels or thick stock) may...

38  -  C110 User’s Guide
Tray 1 (Multipurpose Tray)
For details on the types and sizes of media that can be printed from Tray 1, 
refer to 
“Print Media” on page 30.
Loading Plain Paper
1Open Tray 1.
NoteIf there is media in Tray 1, 
remove it.
2Slide the media guides to 
provide more space between 
them.
Downloaded From ManualsPrinter.com Manuals 

39  -  C110 User’s Guide
3Load the paper face up in the 
tray.
NoteDo not load paper above 
the 
 mark. Up to 200 
sheets (80 g/m2 [21 lb]) of 
plain paper can be 
loaded into the tray at 
one time.
4Slide the media guides against 
the edges of the paper.
 
 
 
 
 
 
 
 
 
 
Downloaded From ManualsPrinter.com Manuals 

40  -  C110 User’s Guide
Other Media
When loading media other than plain paper, set the media mode (Labels, 
Letterhead, Postcard, Thick Stock 1, or Thick Stock 2) in the driver for 
optimum print quality.
Loading Label Sheets/Letterheads/Postcards/Thick Stock
1Open Tray 1.
NoteIf media has been loaded 
into Tray 1, remove all media 
from the tray.
2Slide the media guides to 
provide more space between 
them.
Downloaded From ManualsPrinter.com Manuals