Panasonic 1080l Multi Purpose Digital Camera Ak Hc910p Operating Instructions

AK-HC910P
Before attempting to connect, operate or adjust this product, please
read these instructions completely.
1080I Multi-purpose 
Digital Camera 

2FCC Note: 
This device complies with Part 15 of the
FCC Rules. To assure continued
compliance follow the attached instal-
lation instructions and do not make any
unauthorized modifications.
This equipment has been tested and
found to comply with the limits for a
class A digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
when the equipment is operated in a
commercial environment. This
equipment generates, uses, and...

3
For Your Safety...................................2
Preface ...............................................4
Features..............................................4
Precautions .........................................5
Major Operating Controls and 
Their Functions .............................6, 7
How to Install ......................................8
_How to set the lens .......................8
_How to install on the camera
housing, pan/tilt head, 
tripod, etc....

4
Preface
Thank you very much for purchasing the multi-purpose digital
camera.
New 2/3q2.2 million-pixel CCD is
employed.
[1920(H) k1080(V)]
•2.2 million-pixel CCD is 2/3qsize, being
compact and light-weight.
The camera section is equipped with a
high picture quality digital signal
processing LSI.
•10 Bit, 74 MHz high picture quality digital
processing after the process circuit.
•New type CCD flaw correcting function.
•High reliability, multi-function, and
improvement of maneuverability are
realized....

5 •Do not attempt to disassemble the
camera or other units. In order to prevent
electric shock, do not remove screws or
covers. There are no user-serviceable
parts inside.
•Do not abuse the camera. Avoid striking,
shaking, etc. The camera contains
sensitive components which could be
damaged by improper handling or
storage.
•Do not let the lens remain uncapped
when the camera is not use. If the lens is
not installed, do not leave the lens mount
hole uncovered.
•Do not touch the surface of the lens or...

6
Major Operating Controls and Their Functions
_Front Panel
5Cooling Fan
• Do not block or obstruct the ventilation during operation. It may otherwise cause
internal heating or fire.
• The life of this fan is approximately 50,000 hours (at room temp. 25°C). Replace the
fan as needed.
(When the room temperature is higher than 35°C, replace the fan earlier.)
Be sure to ask the dealer for the replacement.
_Top and Bottom Panels
3
4
1
2
LENS
5
6
6
7
1
2
3
4
5 6 789
10
11
12
Pin No.
1
2
3
4
5
6
Signal
Return...

7 8Breaker [BREAKER]
If the breaker is operated due to over-current or the like, check the cause and eliminate
the trouble, then press the breaker button.
9Zoom/Focus Connector [ZOOM/FOCUS]
Used to connect the zoom/focus control cables of lens. 6Camera mounting hole (1/4-20UNC)
7Camera mounting hole (3/8-16UNC)
The screw holes can be used to secure the camera for installing it on camera housing,
and when using a pan/tilt head or a tripod.
Major Operating Controls and Their Functions
_Side Panel
:SDI...

8
BREAKER
ZOOM/
FOCUS
SDI OUT1
2
1
/F720PROGRESSIVE
How to Install
_How to set the lens
• Standard 2/3qbayonet type (B4 mount) lens of any makers can be used*.
1Turn the lens fixing ring knob counterclockwise to remove the lens mount cap.
2Set the lens in place, and turn the lens fixing ring knob clockwise to precisely fix the
lens.
3Connect the lens cable to the lens connector.
4Connect the remote (zoom/focus control) cable to the zoom/focus connector on the
rear panel.
* Note that there are some...

9
O    I
BREAKER
ZOOM/
FOCUS
SDI OUT1
2
1
/F
AK-HC910P
YPbPr D-sub 15-pin
D-sub 15-pin
How to Set Up the System (Connection)
_Connection of remote control box
• Use multi-cable for the connection of HD controller AK-HRP900 and this unit.
HD-SDI
Multi-cable (5m)
AK-HDMLTCA05Coaxial Cable
(5C-FB)
HD Monitor
1Before connecting the cables, be sure to set the Power Switch of AC Adaptor and HD
Controller to OFF.
2Connect the multi-cable to the interface connector of the camera, and the opposite side
to HD...

10
O    I
BREAKER
ZOOM/
FOCUS
SDI OUT1
2
1
/F
HD-SDI
D-sub 15-pin
D-sub 15-pin Multi-cable (5m)
AK-HDMLTCA05Coaxial Cable (5C-FB)
AC Adaptor 
AW-PS505
HD Controller 
AK-HRP900HD Monitor
Multi-purpose Digital Camera Control System Configuration 1
Remote 
controllable 
lensMulti-purpose 
Digital Camera
AK-HC910P
External sync signal 
(3 value sync)
Remote (zoom/focus 
control) cable
DC 
Power 
Cable