Home > Panasonic > Door > Panasonic Door Station Vl Gc003a Installation And Operation Guide

Panasonic Door Station Vl Gc003a Installation And Operation Guide

    Download as PDF Print this page Share this page

    Have a look at the manual Panasonic Door Station Vl Gc003a Installation And Operation Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 10737 Panasonic manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							11
    Installation Introductions
    2Attach and fix the door station.
    LBefore drilling, see page 7 for installation location.
    Note:
    LUsing the switch box (page 9) is easier to install.
    Door station
    92mm (319/32) 83.5mm (3
    19/64)
    Opening to insert 
    the back of door station 
    (73mm x 141mm, 2
    7/8 x 51/2)
    Wood screw
    Door station
    Switch box
    Inch screw
    VL-GC003A.book  Page 11  Monday, October 24, 2005  8:35 PM 
    						
    							12
    Installation Introductions
    3Install the optional face panel as shown.
    LBe sure to install the optional face panel (VL-GF001A) to avoid malfunction.
    1. Loosen the screw attached to the bottom of the door station.
    2. Set the hooks (
    1) on the face panel into the slots (2) and cover.
    3. Press and hold (
    3), while fasten by tightening the screw to fasten.
    Door station Hooks
    Slots
    Screw 
    (Attached to the 
     door station)
    Face panel
    VL-GC003A.book  Page 12  Monday, October 24, 2005  8:35 PM 
    						
    							13
    Help
    Cleaning
    Use a soft, dry cloth when cleaning. For excessive dirt, wipe the unit with a slightly damp 
    cloth.
    Important:
    LDo not use anything containing alcohol, polish powder, powder soap, benzine, thinner, wax, 
    petroleum, or boiling water. Also do not spray with insecticide, glass cleaner, or hair spray. 
    This could cause a change in color or quality.
    VL-GC003A.book  Page 13  Monday, October 24, 2005  8:35 PM 
    						
    							14
    General Information
    Technical data about this product
    Power supply*1:Standby: Approximately 5 V DC (2 mA)
    At operation: Approximately 20 V DC (180 mA)
    Dimensions:Approximate height 165 mm x width 115 mm x depth 51 mm
     (6
    1/2 x 41/2 x 2)
    Mass (Weight):Approximately 225 g (0.5 lb.)
    Operating environment:–10 °C to 50 °C (14 °F – 122 °F), 
    Up to 90% RH (Relative Humidity) non condensing
    Installation method:Flush mount
    External material:ABS (V-0)
    Image pickup device:
    1/4 CCD (0.25 megapixel)
    Minimum subject 
    illumination:1 lux within 500 mm (19 
    3/4) from the door station
    *1 Supplied from the monitor station.
    Note:
    LDesign and specifications are subject to change without notice.
    LThe pictures and illustrations in these instructions may vary slightly from the actual 
    product.
    VL-GC003A.book  Page 14  Monday, October 24, 2005  8:35 PM 
    						
    							15
    General Information
    FCC and Other Information
    This device complies with Part 15 of the FCC Rules. Operation is subject to the following
    two conditions:
    (1) This device may not cause harmful interference.
    (2) This device must accept any interference received, including interference that may
    cause undesired operation.
    CAUTION:
    Any changes or modifications not expressly approved by the party responsible for
    compliance could void the user’s authority to operate this device.
    NOTE:
    This equipment has been tested and found to comply with the limits for a Class B digital
    device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
    reasonable protection against harmful interference in a residential installation. This
    equipment generates, uses, and can radiate radio frequency energy and, if not installed
    and used in accordance with the instructions, may cause harmful interference to radio
    communications. However, there is no guarantee that interference will not occur in a
    particular installation. If this equipment does cause harmful interference to radio or
    television reception, which can be determined by turning the monitor station off and on, 
    the user is encouraged to try to correct the interference by one or more of the following
    measures:
    – Reorient or relocate the receiving antenna.
    – Increase the separation between the equipment and receiver.
    – Connect the equipment into an outlet on a circuit different from that to which the receiver is 
    connected.
    – Consult the dealer or an experienced radio/TV technician for help.
    VL-GC003A.book  Page 15  Monday, October 24, 2005  8:35 PM 
    						
    							For your future reference
    Attach your sales receipt here.
    Panasonic Consumer Electronics Company, 
    Division of Panasonic Corporation of North America
    One Panasonic Way, Secaucus, New Jersey 07094, U.S.A.
    Panasonic Puerto Rico, Inc.
    San Gabriel Industrial Park, Ave. 65 de Infantería, Km. 9.5, Carolina, Puerto Rico 00985, 
    U.S.A.
    Copyright:
    LThis material is copyrighted by Panasonic Communications Co., Ltd., and may be 
    reproduced for internal use only. All other reproduction, in whole or in part, is prohibited 
    without the written consent of Panasonic Communications Co., Ltd.
    © 2005 Panasonic Communications Co., Ltd. All Rights Reserved. 
    Date of purchase
    Serial number (found on the rear of the unit)
    Dealer’s name and address
    Dealer’s telephone number
    VL-GC003A.book  Page 16  Monday, October 24, 2005  8:35 PM 
    						
    All Panasonic manuals Comments (0)

    Related Manuals for Panasonic Door Station Vl Gc003a Installation And Operation Guide