Panasonic Down Converted Board Ak Hdc931p Operating Instructions

							Installing the board in a Multi-Format Camera
1Remove the left and right side panels on the Multi-Format Camera (AK-HC931P).
2Remove the blank panel (right side of camera), then feed the cable (supplied with the
board) through the rectangular opening under the top panel and insert it into the
connector on the opposite side.
5
7
8DOWN
CONV
Down Converter Board
Model No. AK-HDC931P
Blank panelHeat sink Connector
Insert the cable into the connector on the opposite
(left) side of the camera(inside of the heat sink). 
Rectangular opening
CAUTION:
These servicing instructions are for use by qualified service personnel only. To
reduce the risk of electric shock do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so. 
						

							6
5
6DOWN
CONV7
8
3Insert this board (down converter unit) into slot 6 of the camera’s circuit board.
4Insert the other end of the cable into the connector on the board itself.
Printed in Japan
VQT0B70F0902H0-5@3
Down converter board
5
6
7
8DOWN
CONV