Panasonic E 37 V Dome Network Camera Quick_Start_Guide

							                                                                            
 7 
3 Network  Configuration  
The IP address of all the cameras is the same when leaving factory (default IP192.168.1.108), in order 
to make the camera get access to the network smoothly, please plan the useable IP  segment 
reasonably according to the actual network environment.  
3.1 M odify IP Address  
IP  address  can  be  acquired  and  modified  through  quick  configuration  tool  for  the  cameras  which  are 
accessed  via  wired  network,  it  needs  to  connect  wired  network  to  configure  wireless  parameters 
before  using  wireless  network  cameras.  In  this  chapter,  it  will  introduce the  approach  of  modifying  IP 
address via “Quick Configuration Tool”; also you can modify the IP address in the network parameters 
of  the  WEB  interface,  please refer  to  the  document  in  the  disk  >  for  more 
details.  
Note:  
Currently  the  quick  configuration  tool  only  supports  the  cameras  which  apply  to  the  same  network 
segment with computer IP  address.  
Step 1 Double click the “ConfigTools.exe” and open the quick configuration tool. 
Step  2  Double  click the  device  to be  configured,  the  system  will  pop  out  the “Login” dialog box.  Enter 
the IP  address, user name, password and port number of the camera, and click “Confirm”. 
Note:  
The default user name and password are admin and 12345 respectively, the default of port is 
37777.  See Figure 3-1 for more details.  
  
						

							                                                                            
 8 
Figure 3-1  
Step 3 Modify the camera IP  address on the “Net” interface, click “Save” to finish modification.  
See Figure 3-2 for more details.  
 
Figure 3-2  
3.2 Login WEB Interface  
Note:  
Different  devices  may  have  different  WEB  interfaces,  the  figures  below  are  just  for  reference,  please 
refer to the document  in the disk and the actual interface for more details 
Step 1 Open IE  and input the modified camera IP  address in the address bar.  
Step 2 The login interface is shown below, please input your user name and password (Default user 
name is admin and password is 12345 respectively), click “login”. 
See Figure 3-3 for more details.  
  
						

							                                                                            
 9 
 
Figure 3-3  
Step  3  Install  controls according  to  the  system prompt; see  Figure  3-4  for  the  WEB  main  interface. 
Please modify the administrator password as soon as possible after you successfully logged in.  
 
 
 
Figure 3-4  
 
 
 
  
						

							                                                                            
 10 
 
Note 
 This use r’s manual is for reference only. Slight difference may be  found in user interface. 
 All  the  de signs and software here are subject to change without prior written notice. 
 All  trade marks  and registered  trade marks mentioned are  the  properties of  the ir re spective  
owne rs. 
 If the re  is any unce rtainty or controversy, ple ase refer to the final explanation of us. 
 Ple ase  v isit our website for more information.