Panasonic Electronic Board Ub T880 Operating Instructions

51
Operating Instructions
Installation Manual
1
10.Turn off the power switch and unplug the 
power cord from the AC outlet.
11 .Wipe the screen board surface.
•Gently wipe the screen board surface with a soft, 
moist cloth.
Notice
•Do not use thinner, benzene, or abrasive 
chemicals to clean. 
(Doing so can result in discoloration.)
•Do not wipe the screen board with a dry 
cloth. 
(Doing so can cause static electricity build-
up.)
UB-T880-PJQXC0337ZA_mst.book  51 ページ  ２０１０年５月１１日　火曜日　午後１時９分 

Installation Manual
52 Operating Instructions
For Mounting on a Stand KX-B061 
(Sold Separately)
1.Attach the power cord.
•Connect the power cord to the elite Panaboard 
before installing on the stand.
2.Depending on the location of the outlet, install 
the power cord as illustrated in the following 
diagrams.
•When attaching the power cord downward.
•When attaching the power cord along the lower 
side of the elite Panaboard.
3.Hang the elite Panaboard on the stand with the 
screw heads.
4.Secure the...

53
Operating Instructions
Installation Manual
1
•When installing the elite Panaboard on the 
stand, you can adjust its height to 4 different 
levels. 
When changing the height, remove the left 
and right screws from the back of the elite 
Panaboard, and securely insert them at the 
desired height. Torque (greater than 1 N • m 
[10 k gf•cm (9 lbf•in.)]).
5.Confirm that the elite Panaboard can operate.
•See “Confirming the elite Panaboard Operation” 
(page 54).
6.Turn off the power switch and unplug the...

Installation Manual
54Operating Instructions
Confirming the elite Panaboard Operation
After assembling the elite Panaboard, confirm that it operates properly by following the procedure below.
Confirming the Interactive Features
1.Following the procedure in “Installing the elite Panaboard software/book” (page 22), install the 
software and connect the included USB cable.
2.Confirm that the interactive features are operating correctly.
•If a projector is not available, confirm operation using only the...

Installation Manual
55Operating Instructions
1
Repackaging
To repackage the elite Panaboard, perform steps in the following “Assembling the elite Panaboard” in 
reverse.
•For Wall Mounting →  page 49
•For Mounting on a Stand KX-B061 (Sold Separately)  →  page 52
Package the unit as depicted in the diagram in “Preparing for Removing the elite Panaboard from Its 
Packaging” (page 48).
Notice
•When handling the electronic board, hold it by the frame and not the screen board. (Holding the screen 
board can...

1731
(For EU only)
© Panasonic System Networks Co., Ltd. 2010 F0510E1060
Information for Users on Collection and Disposal of Old Equipment and used Batteries
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and 
electronic products and batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable 
collection points, in accordance with your national...