Panasonic Es Lt71_mul_om Operating Instruction Manual
Have a look at the manual Panasonic Es Lt71_mul_om Operating Instruction Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 10737 Panasonic manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
![Page 4
Parts identification
A Protective cap
B Outer foil section
1
Foil frame
2 System outer foil
3 System outer foil release
b
uttons
C Inner blades
D
Main body 4
Foil frame release buttons
5
Pivot action selector
6 Lock ring
7 Battery capacity lamp
8 Charge status lamp ()
9 Appliance sock et
: Power switch [0/1]
; Finger rest <
Trimmer
=
Trimmer handle
E
Self‑ cleaning recharger
> Water tank cap
? Water tank
@ Socket
A...](http://img.usermanuals.tech/thumb/58/63434/w64_es-lt71_mul_om_d-3.png "Page 4
Parts identification
A Protective cap
B Outer foil section
1
Foil frame
2 System outer foil
3 System outer foil release
b
uttons
C Inner blades
D
Main body 4
Foil frame release buttons
5
Pivot action selector
6 Lock ring
7 Battery capacity lamp
8 Charge status lamp ()
9 Appliance sock et
: Power switch [0/1]
; Finger rest <
Trimmer
=
Trimmer handle
E
Self‑ cleaning recharger
> Water tank cap
? Water tank
@ Socket
A...")
![Page 9
9
Follow the steps outlined below if the status
lamp blinks or glows
BlinksGlows
Correctly set the
detergent cartridge and
then restart a course. Remo
v
e the shaver from the self‑
cleaning recharger and then
check that the [CLEAN] lamp has
gone out. (Be careful as the blade
may be hot or wet.) Check that
the water tank is correctly
attached, the water tank cap is
securely closed and the self‑
cleaning recharger is placed
hor
izontally.
If the status lamp goes
out
Continue a course.
When an...](http://img.usermanuals.tech/thumb/58/63434/w64_es-lt71_mul_om_d-8.png "Page 9
9
Follow the steps outlined below if the status
lamp blinks or glows
BlinksGlows
Correctly set the
detergent cartridge and
then restart a course. Remo
v
e the shaver from the self‑
cleaning recharger and then
check that the [CLEAN] lamp has
gone out. (Be careful as the blade
may be hot or wet.) Check that
the water tank is correctly
attached, the water tank cap is
securely closed and the self‑
cleaning recharger is placed
hor
izontally.
If the status lamp goes
out
Continue a course.
When an...")
11 Replacement partsReplacement parts are available at your dealer or Service Center. Replacement parts for ES‑LT71System outer foil WES90 7 Inner blades WES906 Cleaning the self-cleaning recharger Beard trimmings may become attached to the cleaning tray of the self‑cleaning recharger. Follow the steps below to remove them. We recommend doing this each time you change the detergent cartridge. 1. Be sure to remove the water tank and the appliance plug from the self ‑ cleaning recharger. Be careful not to spill the cleaning liquid. •1 . Gently wipe off any beard trimmings attached to the inside of the cleaning tray with a cloth or tissue paper dampened with water. Clean the corners and uneven parts of the cleaning tray with a cotton swab dampened with water. •2 WarningDo not wash or apply water to the AC adaptor or self- cleaning recharger. Failure to observe this may cause electric shock or result in short circuits. Do not pull hard on the rubber blade protector at the bottom of the cleaning tray. The rubber may come off if you pull hard on it. It is only necessary to pull it up slightly. • When the water does not drain from the cleaning trayBeard trimmings may clog the drain at the bottom of the cleaning tray. In this case, you cannot clean or dry the shaver. Push the beard trimmings down through the drain with a tooth pick etc. Removing the built-in rechargeable battery Remove the built‑in rechargeable battery before disposing of the shaver. Please make sure that the battery is disposed of at an officially designated location if there is one. Do not dismantle or replace the battery so that you can use the shaver again. This could cause fire or an electric shock. Have the battery replaced by an authorised service centre. Disconnect the power cord from the shaver when removing the battery. •
1 Perform steps 1 to 4 and lift the battery, and then remove it. For environmental protection and recycling of materials This shaver contains a Lithium‑ion battery. Please make sure that the battery is disposed of at an officially assigned location, if there is one in your country. Specifications Power source See the name plate on the AC adaptor. (Automatic voltage conversion) Motor voltage .6 V DC Charging time Approx. 1 hour This product is intended for household use only. •
F ENPrinted in China 0000000000 X0000‑ 0 Panasonic Electric Works Wanbao (Guangzhou) Co., Ltd. http://panasonic.net