Panasonic Household Air Massager Ep1081 Operating Instructions

®
Before operating this unit, please read these instructions completely and save this manual for future use.
Antes de utilizar esta unidad, lea completamente estas instruccionnes y guarde este manual para
utilizarlo en el futuro en caso de ser necesario.
Model No. EP1081
Modelo No. EP1081
Household Air Massager
Masajeador Doméstico a Aire
Operating Instructions
Instrucciones
de funcionamiento
1-800-338-0552 for questions and comments.
www.panasonic.com/massage
Panasonic Consumer Electronics Company
One...

Thank you for purchasing the Panasonic Household Air Massager EP1081. To ensure optimum
performance and safety, please read these instructions carefully.
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the
following.
Read all instructions before using the Household Air Massager. 
DANGER – To reduce the risk of electric shock:
Always unplug the appliance immediately after use. The massager should also always be
unplugged before...

5
PARTS IDENTIFICATION
HOUSEHOLD AIR MASSAGER
Built-in air nodes
Built-in sonic
 transducer
Compressor cable
Main power
switchControllerAccessories Audio input
20-ft (6m) cable
5-ft (1.5m) cable
Headphone
double adaptor Air compressor
CONTROLLER
Air massage
selection switches
Sonic vibration
switchesOn/Off switch
Upper back
Middle back
Stretch wave
Sonic audio
VibrationAir massage display
Lumbar
Sonic vibration intensity 
adjustment buttons
SAFETY PRECAUTIONS
WARNING: To avoid the risk of injury:
1....

Middle Back
(Repeat)Shoulder
Back
Lower back
Lumbar
(Repeat)Shoulder
Back
Lower back
7 6
USING THE HOUSEHOLD AIR MASSAGER
AIR MASSAGE: TURNING ON AND OFF
Upper Back
OUTLINE OF AIR MASSAGE SELECTION
(Repeat)
Before using, make sure you have read all the
instructions, including warnings and safety and
operating precautions. 
1. Make sure the compressor cable is connected to the
air compressor.  See picture on page 5.
2. Make sure that the compressor cable is not crimped.
If it is, this will stop air flow...

9 8
SONIC VIBRATION: TURNING ON AND OFF
1. To use the sonic vibration, make sure the “On/Off” switch at the top
of the controller is on. Make sure that the operating lamp comes on.
2. If you do not have any audio input, but still want to experience
vibration, select the “Vib.” switch.  This will go through an
approximately 15 minute program of vibrations in your back area.
You can change the intensity of the vibration by holding down the
up/down arrows on the intensity adjustment buttons.
3. If you are...

TROUBLESHOOTING GUIDE
Before requesting service for your Air Massager, check the table below for the possible cause of
the problem. Some simple checks or minor adjustment on your part may eliminate the problem
and restore proper operation. If you are in doubt about some of the check points, or if the
remedies indicated in the chart do not solve the problem, call us at 1-800-338-0552 to locate the
servicer near to you.
10
SPECIFICATIONS
Power source:120V AC, 60Hz
Power consumption:38W (5W when power is...