Panasonic Household Massage Lounger Epma10 Operating Instructions

20
English
	MANUAL	OPERATION	FOR	THE	UPPER	BODY
1	Press	the		button.
The	power	will	turn	off	automatically	if	the	massage	does	not	start	within	3	minutes	after	turning	on	the	power.
2
1
2	Select	the	massage	type	you	want.
Press	the	button	of	the	massage	you	require.
The	unit	will	automatically	recline	to	the	massage	position. 	See	page	16	for	a	fine	adjustment.
Massage	Actions
NECK	KNEAD
Feels	like	the	thumbs	of	two	hands	
repeatedly
 	kneading	from	the	lower	
part	to	the	upper	part	of	your	neck.
KNEAD...

21
English3	Adjust	as	you	like
You	can	adjust	the	position	or	intensity	of	the	massage	heads,	and	you	will	hear	a	“beep-beep-beep”	sound	when	it	reaches	
its	limit.
A	Adjusting	the	 Vertical	Position	of	the	Massage	Heads
Up
DownPress
 	the	button	once	to	move	the	position	slightly	[approx.
	0.6	in.	(1.5	cm)]. 	Press	and	
hold	the	button	to	move	the	position	continuously; 	release	the	button	to	stop	the	
movement.
•
B	Adjusting	the	
Width	between	Massage	Heads
Increasing
DecreasingT
 ap,	Roll	and	Neck...

22
English
3	Adjusting	the	massage	intensity
The	intensity	is	adjustable	in	3	steps.
Default	is	level	2.
•
•
Lo
 wer	body	
intensity	display
4	Auto	shut-off	in	leg/foot	massage	and	leg	stretch
The	massage	will	end	after	approximately	15	minutes	and	the	unit	will	automatically	shut	off.
The	legrest	will	automatically	lower.
If	you	want	to	continue	using	the	unit	press	the	
	button.
Description	of	Leg/foot	Massage	and	Leg	Stretch
Leg/foot	massage
A	bottom-to-top	squeezing	action	slowly	relaxes	and	softens...

23
English	AFTER	COMPLETING	THE	MASSAGE
Return	the	seat	to	the	original	position
1	Check	that	there	is	nothing	in	the	vicinity	of	
the	backrest	or	the	legrest.
2	Press	the		button	twice. 	
The	backrest	and	legrest	will	automatically	return	to	their	original		
positions.	
The

	backrest	and	the	legrest	can	be	returned	with	the	reclining	button. 	
(See	page	16.)
3	Place	the	control	panel	in	its	holder.
4	Return	the	pillow	to	its	original	position	if	it	 was	flipped.
•
Disconnect	the	power
	See	 Warning	No....

24
English
How	to	move	the	unit
Using	the	wheels	to	move	the	unit
Grasp	the	legrest	to	move	the	unit	when	using	the	wheels.
It	is	easier	to	move	the	unit	with	the	massage	heads	
retracted	and	the	backrest	in	the	upright	position.
*	 Place	a	mat	or	cloth	on	the	floor	and	move	the	unit	slowly	
to	prevent	floor	damage. 	
•
•
Lifting	the	unit
Move	the	unit	by	having	one	person	firmly	hold	onto	the	
fabric	section	on	the	underside	of	the	legrest	and	another	
person	use	the	groove	on	the	back	cover	of	the...

25
English	TROUBLESHOOTING
Problem
Cause	and	Remedy
Motor	Noises It	sounds	and	feels	like	the	massage	heads	are	straining	to	get	over	wrinkles	in	the	cloth.
The	motor	groans	when	it	comes	under	load.
There	is	excessive	noise	during	 Tapping.	(The	noise	is	greater	at	the	top	of	the	unit.)
There	is	a	creaking	noise	when	the	massage	heads	are	in	operation.
There	is	a	rattling	sound	when	the	massage	heads	move	up	or	down.
The	belt	can	be	heard	rotating.
There	is	a	rubbing	sound	produced	by	the	massage	heads...

26
English
	ERROR	DISPLAY
Contents	of	the	error	will	be	displayed	in	the	remaining	time	display	area	when	
an	error	occurs	during	the	operation.
Time	Remaining	
Display
	
For	the	error	 “U10”		and		will	flash	alternately.
•
Error	displayContents
For	safety	reasons,	operation	will	terminate	automatically	when	it	cannot	detect	
if	someone	is	seated.
	If	this	error	occurs	even	if	you	are	seated,	sit	back	all	the	
way	to	the	backrest,	and	operate	from	the	start	again.
Operation	is	terminated	because	there	is...