Panasonic Kx-T123210 Installation Manual

OTHER FEATURES 
l Lift the handset or press the SP-PHONE button first. 
l After hearing confirmation tone (1 or 2 beeps), hang up the handset or press the SP-PHONE button. 
CALL FORWARDING * Setting 
All Calls 
Busy or No Answer Setting 4- 26 
To Outside Line Setting 
4- 28 
To cancel 
4- 26 
4 - 28 
DO NOT DISTURB 
Setting I To cancel 
4- 30 
ABSENT MESSAGE 
CAPABILITY Setting 
Messagel. “Will Return Soon” To cancel 
Message2. “Gone 
Home” 
MESSAGE WAITING 
To Leave the Message 
at each Extension from...

STATION PROGRAMMING 
l Be sure the handset is in the cradle and the SP-PHONE button is off. 
l Set the MEMORY switch of the proprietary telephone to “PROGRAM” first. 
l After programming, return the MEMORY switch to “SET”. 
AUTO CO HUNTING Setting ~TO cancel 
Prime Line Preference- 
Outgoing 
Idle Line Preference- 
Outgoing Setting ITo cancel 
AUTOMATIC ANSWERING Setting ITo cancel 
SELECTION 
4- 51 
Prime Line Preference- 
Incoming 
I 
No Line Preference- !To cancel 
Incoming ;mm 4-52 
FLEXIBLE CO...

NAME AND LOCATION 
External Music Jack 
EIA Connector 
(RS-232C) Alarm Indicator 
Night Indicator 
Day Indicator 
Power Indicator 
Power Switch 
Battery Backup 
Connector 
INSTALLATION 
Installation 
Cautions 
l Avoid installing in the following places. (Doing so may result in malfunction, noise, or discoloration.) 
1. Indirect sunlight and hot, cold, or humid places. (Temperature range:32”F-104°F) 
2. Sulfuric gases produced in areas where there are thermal springs, etc. may damage the equipment or...

IMPORTANT!!! 
Surely connect the frame of the KX-Tl23210 to earth 
ground properly to protect the unit. 
4 To earth ground 
In most continental united states, the ground provided by the “third wire ground” at the commercial power outlet 
will be satisfactory however, in a small percentage this ground may be installed in correctly. 
Therefore, the following test procedure should be performed. 
Test Procedure 
1. 
2. 
3. 
4. 
5. Obtain a suitable voltmeter and set it for a possible reading of up to 250 VAC...

The wall where the KX-Tl23210 is to be mounted must be able to support the weight of the KX-Tl23210. If screws 
other than the ones supplied are used, use the same-sized diameter screws as the enclosed ones. 
To Wall Mount: 
To Mount on Concrete or Mortar Walls: 
1. Place the templet (included) on the wail to 
mark the 3 screw positions. 1. Place the templet (included) on the wall to 
mark the 3 screw positions. 
2. Drill 3 holes and drive the anchor plugs 
(included) with a hammer, flush to the wall....

1. 
2. Unscrew the front cover of the unit. 
screws 
There are four screws. 
Open the front cover in the 
direction of arrow @ screws 
=XI 
When a power failure take place, there is no memory loss except for the camp-on, saved number redial, 
the last number redial, Call park and Message waiting during power failure, memory is protected by 21 day 
rechargeable battery. 
1. Connect the battery (included) as shown 
(Fig.1) 
2. Install the battery into the battery 
compartment. (Fig.2) 
l Replace the...

CONNECTION 
The Power Switch 07 the KX-T123210 must be off during wiring. 
After all the wiring are completed, turn the Power Switch ON. 
Mis-Wiring may cause the KX-Ti 23210 to operate improperly. 
Refer “During Installation” page 6-l and “During Connection” page 6-2. 
50 pin configuration and Color coding 
(Refer page 2-l I.) 
Max. length and kind of wire 
(Refer pages 2-8, 2-14 and 2-16) 
Insertion of Option Card 
(Refer page 2-9) 
Connection of printer 
(Refer page 2-l 8) 
If an extension does not...

Doorphone 2 
------______- 1 
(C.O. Surge Protector) 
toco1 
toco2 
toco3 
toco4 
toco5 
toC06 Initial 
12 CO Lines 
1 KX-Ti 23240 
KX-T61640 
; 
L___________________------~ 
---___ 1 I 
I 
I 
I I 
addition I 
-----------___ 
toco7 
toC08 
toco9 
to co 10 
taco 11 
to co 12 
32Extension Lines 
extension connected 
to jack number 1  16 Extension Lines.lnitial 
r----------------------, 
116 Extension Lines.addition 
1 
L----------------------J 1 
KX-T61631 
Standard 
Telephone 
KX-Tl23230 
0 Extension...

o We recommend that tejephone CO jack is used RJll. 
insert the modular plug of the telephone 
line cord (2-conductor wiring) into the 
modular jack on the KX-T123210. 
FIT 
View of TEL Jack (CO) R : Ring 
T : Tip 
To Terminal Board or Modular Jacks 
+ 
from the Central Office (CO). 
Use 2-conductor 
. 
wiring cord 
0 Mis-connection may cause the KX-TI 23210 to operate improperly. 
See “During Installation” page 6-l and “During Connection” page 6-2 
before connecting. 
, 
‘.:. 
:.:. 
: .:: 
:_ 
)_ ‘1 
2-7  

To connect jack number 1 through 8 and 9 
through 16, insert connector to the KX-T123210 
as shown right. 
Connector type 
50 
pin (Amphenol 57JE 
series or the equivalent) 
To Extensions (jack number 1 through 8 ) 
To Extensions (jack number 9 through 16 ) Jack no 
1 through 8 
Cable Pin Numbers to be connected 
See page 2-l 1. 
l The max. length of the extension line cord (twisted cable)that connects the KX-T123210 and the extension 
is shown below. 
26 AWG: Under 460 feet 
24 AWG: Under 750 feet 
22...