Home > Panasonic > Cordless Telephone > Panasonic Kx Tga405 Installation Guide

Panasonic Kx Tga405 Installation Guide

Add to Favourites
    Download as PDF

    View the Panasonic Kx Tga405 Installation Guide for free. All the Panasonic manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 Installation Guide for Range Extender By installing this unit, you can extend the range of your phone system to include areas where reception was previously not available. The unit extends the range in all directions, allowing several floors to be covered. Important: LThis unit is an accessory unit for use with Panasonic Digital Cordless phones. LThis unit is pre-registered to the base unit. LThis leaflet only describes the steps needed to install and use the unit. Refer to the base unit’s operating...
    Page 2 – 2 – Controls Understanding the STATUS indicator and w indicator Installation 1Connect the unit. LUse only the supplied Panasonic AC adaptor PQLV219. LWhen the unit is turned on, the STATUS indicator and w indicator light amber for about 2 seconds.ASTATUS indicator Bw indicator ID indicator C{PROGRAM} IndicatorLight statusMeaning STATUS indicatorGreen OnLWithin base unit range. The unit is ready for use. FlashingL1 handset is communicating with the base unit through this unit. Flashing rapidlyL2...
    Page 3 – 3 – 2Confirm that the STATUS indicator and w indicator light green. (The unit is ready for use.) LIf the indicators do not light green, re-position the unit in a place where the indicators light green. Note: LThe AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.) LThe AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may...
    Page 4 – 4 – Troubleshooting ProblemCause/solution The unit does not work.LWhen the indicators do not light, the AC adaptor is not connected properly. Check the connections. LWhen the indicators do not light green, move the unit closer to the base unit. LRegistration may have been canceled. Deregister the unit, then re-register. Deregister: 1Unplug the AC adaptor, then press and hold {PROGRAM}. 2While pressing and holding {PROGRAM}, re-connect the AC adaptor. 3Keep pressing and holding {PROGRAM} for about...
    Start reading Panasonic Kx Tga405 Installation Guide

    Related Manuals for Panasonic Kx Tga405 Installation Guide

    All Panasonic manuals