Panasonic Kx Tpa50 Installation Manual

							Thank you for purchasing a Panasonic product.
Please read this installation manual before using the unit and 
save it for future reference.This unit is an additional handset compatible with the following 
series of Panasonic SIP Cordless Phone: 
KX-TGP500/KX-TGP550
You must register this handset with your base unit before it can 
be used. This installation manual describes only the steps 
needed to register and begin using the handset. For further 
details, please read the base unit’s User Guide on the 
Panasonic Web site at: 
http://www.panasonic.com/sip
Charge the batteries for about 6 hours before initial use.
Additional Cordless Handset
Installation Manual
Model No. KX-TPA50
PNQX2117XA  DM0709SY3060 Printed in Malaysia 
						

							2
Accessory information
Supplied accessories
*1 The handset cover comes attached to the handset.
Note:
LPlease read the additional/replacement accessory section of the base 
unit’s User Guide on the Panasonic Web site. See page 1 for 
Panasonic URL.
Setting up
Connections
Note:
LUse only the supplied Panasonic AC adaptor PQLV219 or PQLV219 
(03).
Accessory item/Order numberQuantity
Charger/PNWETGP500B 1
AC adaptor/PQLV219Z or PQLV219 (03)Z 1
Rechargeable batteries/HHR-4DPA
(Part No. HHR-65AAABU or N4DHYYY00002)2
Handset cover
*1/PNYNTGA641TR 1
Belt clip/PNKE1029Z1 1
(120 V AC, 
  60 Hz)
Hooks 
						

							3
LThe AC adaptor must remain connected at all times. (It is normal for 
the adaptor to feel warm during use.)
Battery installation/Battery charge
Important:
LUse the supplied rechargeable batteries. For replacement, we 
recommend using the Panasonic rechargeable batteries noted on 
page 2.
LWipe the battery ends (S, T) with a dry cloth.
LAvoid touching the battery ends (S, T) or the unit contacts.
LConfirm correct polarities (S, T).
LUSE ONLY Ni-MH batteries AAA (R03) size.
LDo NOT use Alkaline/Manganese/Ni-Cd batteries.
Charge for about 6 hours.
LWhen the batteries are fully charged, the charge indicator goes off.
Note:
LIf the batteries are fully charged, but the operating time seems to be 
shorter, clean the battery ends (S, T) and the charge contacts with a 
dry cloth and charge again.
Rechargeable Ni-MH 
ONLYConfirm
“Charging” is
displayed. Charge indicator 
						

							4
Registering a handset to the base unit
1
Base unit:
NKX-TGP500 series
Press and hold {ALL} for about 4 seconds until the STATUS 
indicator flashes in red.
NKX-TGP550 series
Press and hold {ALL} for about 4 seconds until the registration tone 
sounds and the STATUS indicator flashes in red.
LIf all registered handsets start ringing, press the same button to 
stop. Then repeat this step.
LThe next step must be completed within 90 seconds.
2Handset:
Press {OK
L}, then wait until a long beep sounds.
Note:
LIf an error tone sounds, or if _ is still displayed, register the handset 
according to the registering section of the base unit’s User Guide on 
the Panasonic Web site. See page 1 for Panasonic URL.
Display language
1
{MENU} (center of joystick) i {#}{1}{1}{0}
2{V}/{^}: Select the desired setting.
3Press down the center of the joystick to save. i {OFF} 
						

							5
Belt clip
Wall mounting
1
Drive the screws (not supplied) into the wall.
2Mount the charger (A), then slide it down (B) and to the right (C) 
until it is secure. NTo attachNTo  r e m o v e
25.4 mm
(1 inch)
ScrewsA
B
C 
						

							6
For your safety
To prevent severe injury and loss of life/property, read this section carefully before 
using the product to ensure proper and safe operation of your product.
WARNING
Power connection
LCompletely insert the AC adaptor/power plug into the power outlet. Failure to do 
so may cause electric shock and/or excessive heat resulting in a fire.
LRegularly remove any dust, etc. from the AC adaptor/power plug by pulling it 
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause 
an insulation defect from moisture, etc. resulting in a fire.
LUnplug the product from power outlets if it emits smoke, an abnormal smell, or 
makes an unusual noise. These conditions can cause fire or electric shock. 
Confirm that smoke has stopped emitting and contact your phone system dealer.
Installation
LTo prevent the risk of fire or electrical shock, do not expose the product to rain or 
any type of moisture.
LDo not place or use this product near automatically controlled devices such as 
automatic doors and fire alarms. Radio waves emitted from this product may 
cause such devices to malfunction resulting in an accident.
CAUTION
Installation and relocation
LThe AC adaptor is used as the main disconnect device. Ensure that the AC outlet 
is installed near the product and is easily accessible.
Battery
LWe recommend using the supplied batteries or additional/replacement batteries 
noted on page 2 for replacement battery information. USE ONLY rechargeable 
Ni-MH batteries AAA (R03) size.
LDo not mix old and new batteries.
LDo not open or mutilate the batteries. Released electrolyte from the batteries is 
corrosive and may cause burns or injury to the eyes or skin. The electrolyte is 
toxic and may be harmful if swallowed.
LExercise care when handling the batteries. Do not allow conductive materials 
such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit 
may cause the batteries and/or the conductive material to overheat and cause 
burns. 
						

							7
LCharge the batteries provided with or identified for use with this product only, in 
accordance with the instructions and limitations specified in this manual.
LOnly use a compatible charger to charge the batteries. Do not tamper with the 
charger. Failure to follow these instructions may cause the batteries to swell or 
explode.
Attention:
Other information
LOperating the product near electrical appliances may cause interference. Move 
away from the electrical appliances.
LUse only the power cord and batteries indicated in this manual. Do not dispose 
of batteries in a fire. They may explode. Check with local codes for possible 
special disposal instructions.
Routine care
LWipe the outer surface of the product with a soft moist cloth.
LDo not use benzine, thinner, or any abrasive powder.
Notice for product disposal, transfer, or return 
LThis product can store your private/confidential information. To protect your 
privacy/confidentiality, we recommend that you erase information such as 
phonebook or caller list entries from the memory before you dispose of, transfer, 
or return the product.
FCC and other information
This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section 
68.316.
When you hold the phone to your ear, noise might be heard in your Hearing Aid. 
Some Hearing Aids are not adequately shielded from external RF (radio frequency) 
energy. If noise occurs, use an optional headset accessory or the speakerphone 
option (if applicable) when using this phone. Consult with your audiologist or 
Hearing Aid manufacturer about the availability of Hearing Aids which provide 
adequate shielding to RF energy commonly emitted by digital devices.A nickel metal hydride battery that is 
recyclable powers the product you have 
purchased.
Please call 1-800-8-BATTERY (1-800-822-
8837) for information on how to recycle this 
battery. 
						

							8
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST 
CALLS TO EMERGENCY NUMBERS:
1) Remain on the line and briefly explain to the dispatcher the reason for the call.
2) Perform such activities in the off-peak hours, such as early morning or late 
evenings.
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired 
operation.
Privacy of communications may not be ensured when using this phone.
CAUTION:Any changes or modifications not expressly approved by the party responsible for 
compliance could void the user’s authority to operate this device.
NOTE:This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to 
try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Warning:
LThis product complies with FCC radiation exposure limits set forth for an 
uncontrolled environment. 
LThis handset may not be collocated or operated in conjunction with any other 
antenna or transmitter.
LFor body-worn operation, the handset must be used only with a non-metallic 
accessory. Use of other accessories may not ensure compliance with FCC RF 
exposure requirements.
Notice:
LFCC ID can be found inside the battery compartment or on the bottom of the unit. 
						

							9
Notice Compliance with TIA-1083 standard:
Telephone handsets identified with this logo have reduced 
noise and interference when used with T-Coil equipped hearing 
aids and cochlear implants.
T
Compatible with
Hearing Aid T-Coil
TIA-1083
LThis product is designed for use in the United States of America. Sale or use 
of this product in other countries may violate local laws.
LCet appareil est conçu pour être utilisé aux États-Unis d’Amérique. La vente 
ou l’emploi de cet appareil dans certains autres pays peut constituer une 
infraction à la législation locale.
LEste producto está diseñado para usarse en los Estados Unidos de América. 
La venta o el empleo de este producto en ciertos países puede constituir 
violación de la legislación local.
L
LÎé-~ ê”ãÄÖâé
ö!ª
á›ãÒá.3.ÐáÅ”ãÄÖ]âé

ö!ªê:Þ1‘
ûãåùÔ•åÞá”°$ âêãÄÖ]æÅ¿áê
ÚããÒ
áC!åäé(oF,ê)LÒÆèùÔ• 
						

							10
One Panasonic Way, Secaucus, New Jersey 07094
Copyright:
This material is copyrighted by Panasonic System Networks Co., Ltd., 
and may be reproduced for internal use only. All other reproduction, in 
whole or in part, is prohibited without the written consent of Panasonic 
System Networks Co., Ltd.
© Panasonic System Networks Co., Ltd. 2009