Panasonic Microwave Oven Ne 1064t Operating Instructions

Programming
_ DO NOT OPEN THE DOOB -
The display window MUST be blank betore programming can begin. lf any indicator light is
illuminated in the digital Display Window: close the door, press STOP/RESET Pad and
wait 1 minute unlil the Display goes blank.
@
6-0m
uIl,
F.-.:-el
@
4.
.Press the PROG Pad.
NOTE:.ll no PROG Indicator appeared
on display, Program Lock should
be cancelled. (See page 14.).Do not keep pressing PROG Pad
for more than 30 seconds, or a
false failure code may result.
.Press the Memory...

NOTE: . Program the remaining Memory Pads as desired by repeating steps 1-5. You may insert up to 10
B. Programming Memory Pads for 2 or 3 Stage Heating:
Example: To program for 2 minutes at DEFROST for 2 stage heating using Memory Pad Number 5
1. Complete Steps 1 to 4 on page 1 1 .
.Press the Power Level Selector Pad
3 times. DEF indicator light will light.
.Press the PROG Pad again. You have
completed programming the Selected
Memory Pad lor 2 stage heating and
double heating time tor multiple portion...

C. Programming the Double Quantity Pad - For multiple portion heating:
Your oven is factory set to automatically double the programmed time for multiple portion heating - this isthe correct setting for heating multiple portions of most small loods items. No further programming of thetime is necessary for these food items.
The time required to heat multiple portions ot some large platters and most bulk food loads is slighfly lessthan double that ot a single portjon.
This model incorporates a Multiple...

A. To Activate Program Lock:
This procedure Locks the control panel Memory Pads into their programmed heating times and power
levels. DO NOT OPEN THE DOOR. The Display Window must be blank before the oisotav window
Program Lock tealure can be activated.
.Press and hold in the PROG Pad
until the display shows P and L.
(for 6 seconds)
.Program Lock feature is now
activated.
NOTE: .Do not press PROG Pad tor longer than 30 seconds continuously, or false failure
.In Program Lock
a. To activate preset...

C. To Read Program List:
Allows you to review all currently programmed Pad Number, heating time and power level for each stage.
1. Open the door.
.while pressing the sToP/RESET Pad,
press and hold in the START Pad.
The Bgep Tone setting will show in the
display window,
Example: Slage lndicator 1: Beep tone is ON
Stage Indicator 2: Beep tone is OFF.
2 seconds later, the Program Lock
setting will show in the display
wlndow.
Program Lock:P L
Prooram Unlock: P
s. [El;T--l.Press the lilemory Pad you desired...

The Beep Tone can be set, ON or OFF.
1. Open the door.
@.Press the PROG Pad. The display will
not cnange.
.Press the Memory Pad.
.Repeat pressing of 0 Pad. Select OFF
of Beep Tone.
Stage lndicator l =ON
Stagelndicator2=OFF
.Press the PROG Pad again. You have
completed programming the beep tone.
.2 seconds later, 0 wall appear in the
display
.Close door 2 secobds later, the
display window will 9o blank.
s. [0-.:., t 
_l
E. To Read the Cycle Counter:
The oven can dlsplay the total number of times the oven...

This oven monitors its operation and displays a Failure Code in the display window when a problem occurs.
What to do when a failure code appears:
CODECAUSEWHAT TO DO
F01Overcooked tood.Temperature of exhaust air too high.
-Press STOP/RESET Pad to stop beep..Unplug oven and wait al least 30 minutes
before reconnecting.Wait for oven to cool down and reset.-lf a flame is present, do nol open oven door..lf normal operation does not resume, call the
service aoent with intormation of failure code....

-18- 

NE-10647
Power Source120V, 60 Hz, single phase
Required Power13.4A 1500W
Output.1000 w
Frequency2,450 MHz
Outer Dimensions
(HxWxD)
12 x 20A x 1q4
(306mm x 51omm x 360mm)
Cavity Dimensions
(HxWxD)
8% x 13 x 13
(205mmx330mmx330mm)
Net WeightApprox. 34 lbs. (15.4 kg)
Shipping WeightApprox. 39 lbs. (17.7 kg)
Timer99 min 99 sec (Digital) x 10 Memory Pads with Double Quantity
(x2) Pad
201ts,
-lEC 705-88 Test Procedure
Specifications subject to change without notice
8Et
17
Side view with Open Door
1T
Zlt{ 15...

PANASONIC CONSUMER ELECTONIC COMPANY
COMPANY DIVISION OF MATSUSHITA
ELECTRIC CORPORATION OF AMERICA
One Panasonic Way, 4A-4, Secaucus, NJ 07094
(201)348-5377 Tooo36P2oAP
Printed in Taiwan